Ten Sleep, WY
Furnace and Heating Repair in Ten Sleep, WY
Furnace and heating repair in Ten Sleep, WY starts at the thermostat and follows the equipment through its start-up sequence to the step where it stops. Ten Sleep averages 158 days a year with a low of 32°F or colder and 72 at 20°F or colder (NOAA 1991–2020 normals, station 4 miles away). Half the homes in Ten Sleep were built before 1975 (Census ACS 2019–2023). When the gas utility finds a leak or an unsafe furnace it shuts the gas off and tags the appliance, and only a repair brings the gas back.
(888) 217-3739Wyoming contractors. No obligation for the call.
No heat on a cold night comes down to a short list of faults, and the step where the sequence stops names the part. Say what heats the house, both thermostat numbers — the setting and the reading — and what the equipment is doing, and a heating contractor who covers Ten Sleep takes it from there.
Winter in Ten Sleep runs long enough that heating is the main system in the house rather than the second one, and a night without it is counted in hours rather than in inconvenience. A house that loses heat overnight in a cold snap has a plumbing question by morning, which is why this is a call worth making at the hour it happens rather than in the morning.
A winter this long decides which part gives up first. A furnace that has been firing since October reaches January with the hours on it, so what fails is usually the part that has been working rather than the part that was weakest when it went in: an ignitor has a certain number of starts in it, an inducer motor and a blower motor turn on bearings, and a flame sensor takes on a little more of what the flame leaves behind every cycle. What a cold snap adds is only the timing.
A dry climate is where a humidifier gets mounted on the furnace itself, on the plenum or on the return — and where there is one, its faults get read as furnace faults. A solenoid stuck open puts standing water at the base of the cabinet, a pad gone solid with scale stops the humidifier doing anything at all, and a drain that plugs sends the overflow down the outside of the furnace. Worth saying on the phone whether the system has one, because it changes what a technician opens first.
Ten Sleep, WY in numbers
| Days a year with a low of 32°F or colder | 158 | NOAA 1991–2020 normals, station 4 miles away |
|---|---|---|
| Days a year with a low of 20°F or colder | 72 | NOAA 1991–2020 normals |
| Average July dew point | 46°F | PRISM 1991–2020 normals |
| Median year homes were built | 1975 | Census ACS 2019–2023 |
| Households | 115 | Census ACS 2019–2023 |
| County | Washakie County | Census Bureau |
| Federal minimum for a new split central AC | 13.4 SEER2 (North region) | DOE, 2023 standard |
Why heating faults do not fix themselves
The one fault that changes the conversation entirely is a cracked heat exchanger. It is not a repair question alone — the gas utility red-tags the appliance and shuts the supply off, and it restores the supply only after a licensed contractor has worked on the furnace. The appliance does not come back by flipping a switch, and a tag pulled off the furnace takes the record of what was found with it.
A heating tune-up before the season
A heating maintenance visit covers a concrete list, and it is worth asking about each item by name: the ignition sequence run from start to finish, the flame sensor cleaned and its signal read, the temperature rise measured across the furnace, the heat exchanger looked over for cracks, carbon monoxide checked at the flue, and the drain cleared. On a heat pump the list adds the defrost cycle and the auxiliary heat strips; on a boiler, the pressure, the relief valve and the circulator.
Signs it is time to call
- The furnace locks out again within an hour of being reset.
- The blower runs and the air never warms, or the thermostat is asking for heat while the reading keeps dropping.
- Water is standing at the base of the furnace, or the flue outside has iced over.
- The figure
- Set by the contractor and said before the work starts. This site never quotes and has no part in it. If a technician cannot say what the visit covers before beginning, that is the moment to stop.
- The call
- Describing what the system is doing commits you to nothing. Nothing is booked until you say so.
- Coverage
- By town, not by region. Ten Sleep and the towns around it, and it shifts with who is taking calls at the hour you ring.
What a visit in Ten Sleep involves
- 01
The finding, out loud
What failed, whether it is the fault or a symptom of another one, and whether the repair suits the age of the system. A diagnostic visit is usually charged separately from the repair — ask whether it is credited if the work goes ahead, because that differs from one contractor to the next.
- 02
The repair
Agreed with the contractor before it starts. Where a part has to be ordered, a technician says so rather than leaving the system apart.
- 03
What happens after
A system that failed once in a season often fails again in it. Whether that is the same fault or a second one is worth asking while the technician is still there.
What to have ready when you call from Ten Sleep
- 01Which system it is: a furnace, a boiler with radiators or baseboard, or a heat pump with electric backup.
- 02Both numbers from the thermostat — the setting, and what it says the room is — and whether the screen is blank, because a thermostat wired without a common wire runs off its battery, and a battery that has gone down looks exactly like a dead furnace.
- 03Whether the gas utility has already been to the house, and whether there is a tag on the appliance.
Do not keep pressing the reset while you wait — each press relights a furnace that shut itself down for a reason, and the lockout it is holding is the first thing a technician reads.
Heating Repair in Ten Sleep: questions
How cold does Ten Sleep get in winter?
Ten Sleep averages 158 days a year with a low of 32°F or colder and 72 at 20°F or colder, by the 1991–2020 climate normals for a NOAA station 4 miles away. Heating is the main system here, and a furnace that quits in January is an emergency rather than an inconvenience.
When were most houses in Ten Sleep built?
Half the homes in Ten Sleep were built before 1975, by the Census Bureau's 2019–2023 American Community Survey. Detached houses make up most of the housing. Equipment in houses of that age is often on its second set, and the install date on the label decides whether parts are still made.
What does a red tag on a furnace in Ten Sleep mean?
The gas utility red-tags a furnace when it finds a leak or an unsafe appliance, and it shuts the gas off to it. The gas stays off until a contractor repairs the fault, and a cracked heat exchanger is often where a red tag turns a repair into a replacement.
Other services in Ten Sleep
Heating Repair nearby