HeatCoolHQ heatcoolhq.com (888) 217-3739

Ten Sleep, WY

Ductwork and Airflow in Ten Sleep, WY

Duct repair in Ten Sleep, WY starts with measuring the airflow at the registers and the static pressure at the air handler. Half the homes in Ten Sleep were built before 1975 (Census ACS 2019–2023). The July dew point in Ten Sleep averages 46°F (PRISM 1991–2020 normals), dry enough that nearly all of the cooling load is heat rather than moisture. The 2021 International Energy Conservation Code caps leakage from a new duct system at 4 cubic feet a minute per 100 square feet of floor area, tested after construction, wherever that edition is in force.

(888) 217-3739

Wyoming contractors. No obligation for the call.

The year in Ten Sleep—heating runs most of the year
The year in Ten Sleep. heating runs most of the year. Between the two seasons there are weeks when neither system runs, which is when a fault goes unnoticed. BELOW FREEZINGBELOW FREEZINGnothing runsJFMAMJJASOND
heatingcoolingbelow freezing158 days below freezing · July dew point 46°F
A technician joining flexible duct to a metal trunk line in a crawl space
Flexible duct being strapped to the trunk line under the floor. What leaves the equipment and what arrives at the register are two different numbers.

One room that is always wrong while the thermostat says the house is fine usually points at the duct rather than at the equipment. Name the room, and whether it happens in heating or in cooling, and an independent contractor can come out to Ten Sleep and measure the airflow instead of guessing at it.

Ten Sleep has the long heating season, and that decides which duct problem gets noticed. A weak run here is a complaint that runs a whole season, not a bad two weeks in August.

Where the runs sit inside a heated basement, a leaking joint gives most of its heat back to the house. Put the same joint in an unheated attic or a vented crawl space and it goes outdoors instead, and it does that every hour of a season this long. Which of the two a house has decides whether a duct leak costs comfort or costs money, and where the runs go is worth saying on the phone.

The July dew point here sits below the temperature of the air inside a supply run, so a badly insulated attic run warms what it carries instead of sweating on it. A leaking return does something else in a dry climate: it carries dust. It draws attic or crawl space air into the system, and the filter only catches what came through it, which is why a house that is kept clean can still have a black filter and gray register faces. Dry air also makes the measurement cleaner: with almost nothing going into moisture, the temperature split across the coil reads as airflow and little else, and one reading separates a duct problem from an equipment problem.

Ten Sleep, WY in numbers

Days a year with a low of 32°F or colder158NOAA 1991–2020 normals, station 4 miles away
Days a year with a low of 20°F or colder72NOAA 1991–2020 normals
Average July dew point46°FPRISM 1991–2020 normals
Median year homes were built1975Census ACS 2019–2023
Households115Census ACS 2019–2023
CountyWashakie CountyCensus Bureau
Federal minimum for a new split central AC13.4 SEER2 (North region)DOE, 2023 standard

What the hardware-store fix does and does not do

The filter is the one thing in the aisle that changes airflow at all, and where it has not been changed since the last season it is worth doing before the phone comes out. What it cannot do is reach past itself: a filter gives back the air the system already had, and it does nothing for a run that is crushed, pulled off its collar or leaking into a crawl space, and nothing for a return that was always too small. The version that backfires is the upgrade: a dense one-inch filter sold for allergens takes more pressure than the slot was built for, and a system already short of air gets shorter. If the room is still wrong with a clean filter in, the filter was never the answer.

A technician at an indoor air handler

When to stop and call in Ten Sleep

  • A room has never been comfortable since the system was replaced.
  • A return grille whistles or roars, or the filter bows inward when the blower starts.
  • There is a stain on a ceiling under a duct run, or duct insulation that is wet to the touch.
The figure
Set by the contractor and said before the work starts. This site never quotes and has no part in it. If a technician cannot say what the visit covers before beginning, that is the moment to stop.
The call
Describing what the system is doing commits you to nothing. Nothing is booked until you say so.
Coverage
By town, not by region. Ten Sleep and the towns around it, and it shifts with who is taking calls at the hour you ring.

What happens on the visit

  1. 01

    The diagnosis

    At the thermostat first, then at the furnace or the condenser, in the order the equipment runs. What the system is doing is established before any part is named.

  2. 02

    The finding, out loud

    What failed, whether it is the fault or a symptom of another one, and whether the repair suits the age of the system. A diagnostic visit is usually charged separately from the repair — ask whether it is credited if the work goes ahead, because that differs from one contractor to the next.

  3. 03

    What happens after

    A system that failed once in a season often fails again in it. Whether that is the same fault or a second one is worth asking while the technician is still there.

What to have ready when you call

  1. 01Which rooms are wrong, and whether it is in heating, in cooling, or both — that one answer narrows it before anybody arrives.
  2. 02Which part of the house the duct crosses: a basement, a vented crawl space, an attic, or none of those because it all runs inside.
  3. 03The address and ZIP code, and how a technician reaches the duct — an attic hatch, a crawl space door, or a basement with the runs in the open.

Do not go around opening and closing registers before the visit — a technician measures the system as it actually runs, and one damper moved this morning shifts every reading this afternoon.

Ductwork in Ten Sleep: questions

When were most houses in Ten Sleep built?

Half the homes in Ten Sleep were built before 1975, by the Census Bureau's 2019–2023 American Community Survey. Detached houses make up most of the housing. Equipment in houses of that age is often on its second set, and the install date on the label decides whether parts are still made.

How humid are summers in Ten Sleep?

The July dew point in Ten Sleep averages 46°F, by the PRISM 1991–2020 climate normals. In air that dry most of the cooling load is heat, and an air conditioner removes little water, so sizing turns on the house and its sun more than on humidity.

Is there a leakage limit for new ducts in Ten Sleep?

Under the 2021 International Energy Conservation Code, a new duct system may leak at most 4 cubic feet of air a minute per 100 square feet of floor area when tested after construction. It applies where Wyoming or the town has adopted that edition, which the local building department can confirm.

Map loads when you reach it

Other services in Ten Sleep

Ductwork nearby

Call (888) 217-3739