Ten Sleep, WY
Heat Pump Repair and Replacement in Ten Sleep, WY
Heat pump repair in Ten Sleep, WY starts by telling a normal defrost cycle or auxiliary-heat run from one that is a fault. Ten Sleep has, on average, 158 days a year with a low of 32°F or colder and 72 at 20°F or colder (NOAA 1991–2020 normals, station 4 miles away), and those colder days are when a heat pump leans on its backup heat. Half the homes in Ten Sleep were built before 1975 (Census ACS 2019–2023). The federal minimum for a split heat pump made since January 1, 2023 is 14.3 SEER2 in cooling and 7.5 HSPF2 in heating, nationwide.
(888) 217-3739Wyoming contractors. No obligation for the call.
Air that feels cool at the vents in winter is usually the heat pump working as designed, and a heat pump that sits on auxiliary heat for hours in mild weather usually is not. Say what the thermostat is showing and a heating and cooling contractor can come out to Ten Sleep and tell the two apart.
A heat pump in Ten Sleep is a decision rather than the default, where the usual arrangement is a furnace with an air conditioner beside it, and the trade-off behind that decision is real: the heating season runs long enough that the hours when the machine is weakest add up to a season of their own. What moved in the last ten years is where those hours begin. A single-stage heat pump installed in 2010 lost output as the temperature dropped and handed most of January to its backup, while cold-climate inverter models hold much of their rated heating output down near 5°F — so the heat pump somebody remembers from an earlier winter and the one a contractor installs now are not the same machine.
Defrost is the other thing a winter this long makes impossible to miss. In heating mode the outdoor coil collects frost, and the system reverses itself for a few minutes to melt it off — which is why steam rolls off the unit on a cold morning, why the outdoor fan stops, and why the backup heat comes on for the length of it. The fault version looks different: a sheet of ice that never clears, or ice building up around the base, which usually means the meltwater has nowhere to drain and the unit sits too low. Ice comes off with warm air or with time, never with a screwdriver — the tubing in that coil is thin, and a puncture turns a defrost fault into a refrigerant leak.
In dry air the cooling side has only one job to do, so a machine sized too large does not leave the house clammy here — it short-cycles and lets the temperature swing instead. The difference that matters more is in winter, and it is about frost. Frost cannot build on an outdoor coil without water in the air, and there is little of it here — so the defrost cycle runs less often than it would in a damp climate, and a coil that is genuinely iced over is reporting a fault rather than the weather. In a wetter place that same sheet of ice is worth a day's patience; here it is worth a phone call.
Ten Sleep, WY in numbers
| Days a year with a low of 32°F or colder | 158 | NOAA 1991–2020 normals, station 4 miles away |
|---|---|---|
| Days a year with a low of 20°F or colder | 72 | NOAA 1991–2020 normals |
| Average July dew point | 46°F | PRISM 1991–2020 normals |
| Median year homes were built | 1975 | Census ACS 2019–2023 |
| Households | 115 | Census ACS 2019–2023 |
| County | Washakie County | Census Bureau |
| Federal minimum for a new split central AC | 13.4 SEER2 (North region) | DOE, 2023 standard |
Before you try the store-bought fix
The filter is the one item on this list where the store-bought version does something real: a loaded filter starves the indoor coil of air, and a clean one gives that back. What it cannot do is account for a house that is still behind — a furnace with restricted airflow trips its limit switch and announces itself, while a heat pump never makes air hot enough to trip anything: it falls behind, the backup strips make up the difference, and nothing announces anything. That is why a fresh filter settles nothing by itself: the charge, the defrost control, the reversing valve and the capacitor all sit behind it, and none of those is sold on a shelf.
When to stop and call in Ten Sleep
- Ice covers the outdoor coil and the defrost cycles are not clearing it.
- The thermostat sits on auxiliary or emergency heat for hours while it is mild outside.
- The breaker feeding the outdoor unit or the air handler will not stay in.
- The license
- Held by the contractor, not by this site, and issued where the work happens — Wyoming licenses at state level, at city level or not at all depending on the trade and the town. Ask for the number and the name it is held under: a trading name and the licensed entity are often not the same.
- The figure
- Set by the contractor and said before the work starts. This site never quotes and has no part in it. If a technician cannot say what the visit covers before beginning, that is the moment to stop.
- The call
- Describing what the system is doing commits you to nothing. Nothing is booked until you say so.
What a visit in Ten Sleep involves
- 01
The diagnosis
At the thermostat first, then at the furnace or the condenser, in the order the equipment runs. What the system is doing is established before any part is named.
- 02
The finding, out loud
What failed, whether it is the fault or a symptom of another one, and whether the repair suits the age of the system. A diagnostic visit is usually charged separately from the repair — ask whether it is credited if the work goes ahead, because that differs from one contractor to the next.
- 03
What happens after
A system that failed once in a season often fails again in it. Whether that is the same fault or a second one is worth asking while the technician is still there.
Before you call: what to have ready
- 01That it is a heat pump, and what the backup is — electric, or a gas furnace on the same ducts, and not knowing is a fair answer.
- 02Both thermostat numbers, and whether the display is showing auxiliary or emergency heat.
- 03What the outdoor unit is doing: iced over, silent, running without stopping, or reversing every few minutes.
If the house has gone cold, emergency heat is what that setting is for — say on the phone that you switched to it, because it locks out the compressor, and the fault a technician needs to watch stops happening while it is on.
Heat Pumps in Ten Sleep: questions
How cold does Ten Sleep get in winter?
Ten Sleep averages 158 days a year with a low of 32°F or colder and 72 at 20°F or colder, by the 1991–2020 climate normals for a NOAA station 4 miles away. A winter that long leans on the backup heat, so a heat pump here is sized and set up for the cold half of the year.
What is the July dew point in Ten Sleep?
The July dew point in Ten Sleep averages 46°F, by the PRISM 1991–2020 climate normals. In air that dry most of the cooling load is heat, and an air conditioner removes little water, so sizing turns on the house and its sun more than on humidity.
What efficiency does a new heat pump need in Ten Sleep?
The federal minimum for a split heat pump made since January 1, 2023 is 14.3 SEER2 for cooling and 7.5 HSPF2 for heating, the same in Wyoming as in every other state. The rating of the matched outdoor unit and coil is on the AHRI certificate, and a quote for Ten Sleep can go above the minimum.
Other services in Ten Sleep
Heat Pumps nearby