HeatCoolHQ heatcoolhq.com (888) 217-3739

Ten Sleep, WY

AC Replacement and Installation in Ten Sleep, WY

A new air conditioner in Ten Sleep, WY is matched to the house, to the indoor coil and to the refrigerant it will run on. The July dew point in Ten Sleep averages 46°F (PRISM 1991–2020 normals), dry enough that nearly all of the cooling load is heat rather than moisture. Half the homes in Ten Sleep were built before 1975 (Census ACS 2019–2023). The federal floor for a split central air conditioner made since January 1, 2023 and sold for Wyoming is 13.4 SEER2, the North region's standard.

(888) 217-3739

Wyoming contractors. No obligation for the call.

The year in Ten Sleep—heating runs most of the year
The year in Ten Sleep. heating runs most of the year. Between the two seasons there are weeks when neither system runs, which is when a fault goes unnoticed. BELOW FREEZINGBELOW FREEZINGnothing runsJFMAMJJASOND
heatingcoolingbelow freezing158 days below freezing · July dew point 46°F
Two technicians lowering a new condenser onto a concrete pad
A new outdoor unit going down on its pad. Where it stands decides how it is serviced for the next fifteen years, and that is settled once.

An air conditioner that gives up on a hot afternoon has not automatically reached the end of its life, and what settles it is age, what failed, and what the system is charged with. Say what year the system went in and what it has started doing, and an independent contractor can come out to Ten Sleep and size the replacement from the house rather than from the box being carried out.

The cooling season in Ten Sleep is short, and that is what makes the age of an air conditioner misleading. A system that cools for ten or twelve weeks a year puts on a fraction of the running hours the same model accumulates in the south, so it can still be cooling years after the date on the equipment suggested it would stop.

The second machine is usually standing in the same cabinet as the first. Where a furnace and the indoor coil share one, they almost always went in on the same day, and a changeout that replaces one and leaves the other means a contractor opens that cabinet twice. A changeout usually takes about one day, and a heating climate leaves eight months in which that day is not an emergency.

The summer air in Ten Sleep holds so little water that dropping the temperature is nearly the whole job, and the same oversizing error has the opposite consequence. Nothing goes clammy, because there was little moisture to remove; what happens instead is short cycling — the AC reaches the setting almost as soon as it starts, stops, the temperature climbs back, and it starts again. Starting is the hard part of a compressor's day, so a system that starts several times an hour wears the contactor and the compressor rather than the season. A technician sizing a replacement here also expects a wider temperature split across the coil, because nearly all of the capacity goes into temperature and almost none of it into water.

Ten Sleep, WY in numbers

Days a year with a low of 32°F or colder158NOAA 1991–2020 normals, station 4 miles away
Days a year with a low of 20°F or colder72NOAA 1991–2020 normals
Average July dew point46°FPRISM 1991–2020 normals
Median year homes were built1975Census ACS 2019–2023
Households115Census ACS 2019–2023
CountyWashakie CountyCensus Bureau
Federal minimum for a new split central AC13.4 SEER2 (North region)DOE, 2023 standard

What the store-bought fix actually does

The sealed can with a gauge on the top is the usual first move, and it deserves an honest answer. A system low on refrigerant does cool badly, and putting refrigerant into it does make it cool better for a while — that part is real. What the can cannot do is find the hole: refrigerant is not used up, so a system that is low is leaking, and the gap between cans gets shorter every time. The cans on the shelf beside the motor oil are charged for car systems, which use a different refrigerant from a home air conditioner, and the ones with a sealant in them add a second problem to the first — sealant can set in the metering device, and it fouls the recovery machine a technician has to connect.

A technician at an indoor air handler

When to stop and call

  • You have had refrigerant added in two different seasons.
  • The compressor hums and then trips the breaker, and resetting it is the one thing you can do that makes it worse.
  • Someone has told you to replace the system without having measured the house.
The license
Held by the contractor, not by this site, and issued where the work happens — Wyoming licenses at state level, at city level or not at all depending on the trade and the town. Ask for the number and the name it is held under: a trading name and the licensed entity are often not the same.
The call
Describing what the system is doing commits you to nothing. Nothing is booked until you say so.
Coverage
By town, not by region. Ten Sleep and the towns around it, and it shifts with who is taking calls at the hour you ring.

What happens on the visit

  1. 01

    The diagnosis

    At the thermostat first, then at the furnace or the condenser, in the order the equipment runs. What the system is doing is established before any part is named.

  2. 02

    The repair

    Agreed with the contractor before it starts. Where a part has to be ordered, a technician says so rather than leaving the system apart.

  3. 03

    What happens after

    A system that failed once in a season often fails again in it. Whether that is the same fault or a second one is worth asking while the technician is still there.

Before you call: what to have ready

  1. 01Roughly when the system went in, and what refrigerant it is charged with — the model number is worth having in front of you too.
  2. 02Whether a contractor has already been out to it this season, and what they found.
  3. 03What the system is doing now — not cooling at all, cooling weakly, running without ever stopping, tripping the breaker, or icing over.

Find the outdoor data plate and read it before you call — the model number and the refrigerant are printed on it, and those two lines decide most of what follows.

AC Replacement in Ten Sleep: questions

What is the July dew point in Ten Sleep?

The July dew point in Ten Sleep averages 46°F, by the PRISM 1991–2020 climate normals. In air that dry most of the cooling load is heat, and an air conditioner removes little water, so sizing turns on the house and its sun more than on humidity.

How old are the homes in Ten Sleep?

Half the homes in Ten Sleep were built before 1975, by the Census Bureau's 2019–2023 American Community Survey. Detached houses make up most of the housing. Equipment in houses of that age is often on its second set, and the install date on the label decides whether parts are still made.

What efficiency does a new air conditioner need in Ten Sleep?

A new split central air conditioner in Ten Sleep falls under DOE's 2023 standard for the North: at least 13.4 SEER2. In the North the rule follows the date of manufacture, so a unit made earlier to the old standard can still be installed.

Map loads when you reach it

Other services in Ten Sleep

AC Replacement nearby

Call (888) 217-3739