HeatCoolHQ heatcoolhq.com (888) 217-3739

San Antonio, TX

Furnace and Heating Repair in San Antonio, TX

Heating repair in San Antonio, TX comes down to finding the step where the furnace or heat pump stops in its start-up sequence. San Antonio averages 22 days a year with a low of 32°F or colder and about one at 20°F or colder (NOAA 1991–2020 normals, station 3 miles away). Half the homes in San Antonio were built before 1984 (Census ACS 2019–2023). When the gas utility finds a leak or an unsafe furnace it shuts the gas off and tags the appliance, and only a repair brings the gas back.

(888) 217-3739

Texas contractors. No obligation for the call.

The year in San Antonio—cooling runs nearly all year
The year in San Antonio. cooling runs nearly all year. There is no month when both systems are idle. JFMAMJJASOND
heatingcooling22 days below freezing · July dew point 70°F
A technician with a meter at the open panel of a gas furnace
A meter at the burner assembly with the panel off. The ignition sequence runs in a fixed order, and the step where it stops is what names the part.

No heat on a cold night comes down to a short list of faults, and the step where the sequence stops names the part. Say what heats the house, what the thermostat is asking for against what it says the room is, and what the equipment is actually doing, and a heating contractor who covers San Antonio takes it from there.

Where a heat pump does the heating, no heat usually means it stopped heating rather than stopped running. The part that decides which job the machine is doing is the reversing valve, and one that sticks leaves an outdoor unit sounding normal and air at the registers that never warms. Where a small gas furnace does the heating instead, the list is the familiar one: flame sensor, ignitor, pressure switch, limit switch.

Air from the vents that feels cool in winter is not a fault by itself — a heat pump works on a smaller difference between the room and the air it supplies, and it runs longer cycles to make that up. What matters is whether the room gets to the number on the thermostat, and whether the electric strips are doing work the heat pump should be doing: a thermostat set or wired wrong brings them on when the weather never asked for them.

Where July dew points sit at 70°F and above, the indoor coil runs wet all summer, and everything it pulls out of the air leaves by one drain line. A summer of that grows a film inside the trap and the line, and nobody thinks about a drain on the first cold night: a condensing furnace makes water of its own, in most installations it goes down that same line, and a line that will not take it backs the water up until the pressure switch refuses to close. So a no-heat call in a climate like this can end at the drain rather than at the burner.

San Antonio, TX in numbers

Days a year with a low of 32°F or colder22NOAA 1991–2020 normals, station 3 miles away
Days a year with a low of 20°F or colder1NOAA 1991–2020 normals
Average July dew point70°FPRISM 1991–2020 normals
Median year homes were built1984Census ACS 2019–2023
Households547,883Census ACS 2019–2023
CountyBexar CountyCensus Bureau
Federal minimum for a new split central AC14.3 SEER2 under 45,000 Btu/h (Southeast)DOE, 2023 standard

Before you try the store-bought fix

A new filter is the one item from a hardware store that ends a no-heat call outright, and it is fair to say so: a filter that has loaded up chokes the return, the heat exchanger cannot put its heat into air that is barely moving, the limit switch opens, and the furnace shuts itself down and short cycles. What a new filter cannot do is prove it was the fault. Where the furnace locks out again within a day of a new one going in, the restriction is somewhere past the filter, and a technician measures the temperature rise across the furnace to find where.

A heating tune-up before the season

What a technician checks on a heating maintenance visit is concrete, and worth naming on the phone: the ignition sequence run from start to finish, the flame sensor cleaned and its signal read, the temperature rise measured across the furnace, the heat exchanger looked over for cracks, carbon monoxide checked at the flue, and the drain cleared. On a heat pump the list adds the defrost cycle and the auxiliary heat strips; on a boiler, the pressure, the relief valve and the circulator.

A technician at an indoor air handler

When to stop and call in San Antonio

  • The furnace locks out again within an hour of being reset.
  • There is a smell of gas, or a carbon monoxide alarm has gone off — outside first, then the gas utility, then the repair call.
  • There is a tag on the furnace and the gas supply has been shut off.
The license
Held by the contractor, not by this site, and issued where the work happens — Texas licenses at state level, at city level or not at all depending on the trade and the town. Ask for the number and the name it is held under: a trading name and the licensed entity are often not the same.
The figure
Set by the contractor and said before the work starts. This site never quotes and has no part in it. If a technician cannot say what the visit covers before beginning, that is the moment to stop.
The call
Describing what the system is doing commits you to nothing. Nothing is booked until you say so.

What the visit involves

  1. 01

    The diagnosis

    At the thermostat first, then at the furnace or the condenser, in the order the equipment runs. What the system is doing is established before any part is named.

  2. 02

    The finding, out loud

    What failed, whether it is the fault or a symptom of another one, and whether the repair suits the age of the system. A diagnostic visit is usually charged separately from the repair — ask whether it is credited if the work goes ahead, because that differs from one contractor to the next.

  3. 03

    What happens after

    A system that failed once in a season often fails again in it. Whether that is the same fault or a second one is worth asking while the technician is still there.

What to have ready when you call from San Antonio

  1. 01What the system is — a furnace, a boiler on radiators or baseboard, or a heat pump with electric backup.
  2. 02Both numbers from the thermostat — the setting, and what it says the room is — and whether the screen is blank, because a thermostat wired without a common wire runs off its battery, and a battery that has gone down looks exactly like a dead furnace.
  3. 03What it is doing: silent, clicking and stopping, lighting and dropping out, or running with cold air at the vents.

Leave the reset alone while you wait — each press relights a furnace that shut itself down for a reason, and the lockout it is holding is the first thing a technician reads.

Heating Repair in San Antonio: questions

How many freezing days does San Antonio have?

San Antonio averages 22 days a year with a low of 32°F or colder and 1 at 20°F or colder, by the 1991–2020 climate normals for a NOAA station 3 miles away. Heating is rarely asked for here, so a fault in it can sit unnoticed until the one cold week of the year.

How old are the homes in San Antonio?

Half the homes in San Antonio were built before 1984, by the Census Bureau's 2019–2023 American Community Survey. Detached houses make up about half of the housing. Equipment in houses of that age is often on its second set, and the install date on the label decides whether parts are still made.

What efficiency does a new gas furnace in San Antonio need?

A new non-weatherized gas furnace has to reach an AFUE of at least 80 under the federal minimum. DOE has set 95 for furnaces made after December 18, 2028, and that rule is still being fought in court, so a furnace installed now can still be an 80 or a condensing 90-plus.

Map loads when you reach it

Other services in San Antonio

Heating Repair nearby

Call (888) 217-3739