HeatCoolHQ heatcoolhq.com (888) 217-3739

Alamo Heights, TX

Furnace and Heating Repair in Alamo Heights, TX

Furnace repair in Alamo Heights, TX begins with what the system does when the thermostat calls for heat, and where in that sequence it quits. Alamo Heights averages 22 days a year with a low of 32°F or colder and about one at 20°F or colder (NOAA 1991–2020 normals, station in or next to town). Half the homes in Alamo Heights were built before 1954 (Census ACS 2019–2023), so in many of them the heating and cooling equipment has been replaced at least once while the ducts and the flue have not. When the gas utility finds a leak or an unsafe furnace it shuts the gas off and tags the appliance, and only a repair brings the gas back.

(888) 217-3739

Texas contractors. No obligation for the call.

The year in Alamo Heights—cooling runs nearly all year
The year in Alamo Heights. cooling runs nearly all year. There is no month when both systems are idle. JFMAMJJASOND
heatingcooling22 days below freezing · July dew point 70°F
A technician with a meter at the open panel of a gas furnace
A meter at the burner assembly with the panel off. The ignition sequence runs in a fixed order, and the step where it stops is what names the part.

A system that has stopped making heat on a cold night has one of a short list of faults behind it, and the step where the sequence stops names the part. Say what heats the house, both thermostat numbers — the setting and the reading — and what the equipment is doing, and a heating contractor who covers Alamo Heights takes it from there.

The heating half of the system is the part nobody in Alamo Heights thinks about, and in a climate like this it is as often as not the same outdoor unit that cools in July, running the other way. People live with a heat pump for years without knowing the machine does both jobs, which is why the first thing worth saying on the phone is which of the two heats the house.

Where a heat pump does the heating, no heat usually means it stopped heating rather than stopped running. The part that decides which job the machine is doing is the reversing valve, and one that sticks leaves an outdoor unit sounding normal and air at the registers that never warms. Where the heating comes from a small gas furnace instead, the list is the familiar one: flame sensor, ignitor, pressure switch, limit switch.

Where July dew points sit at 70°F and above, the indoor coil runs wet for the whole season, and everything it takes out of the air leaves through one drain line. A summer of that grows a film inside the trap and the line, and nobody thinks about a drain on the first cold night: a condensing furnace makes water of its own, in most installations it goes down that same line, and a line that will not take it backs the water up until the pressure switch refuses to close. In a climate like this a no-heat call can end at the drain and never reach the burner.

Alamo Heights, TX in numbers

Days a year with a low of 32°F or colder22NOAA 1991–2020 normals, station in or next to town
Days a year with a low of 20°F or colder1NOAA 1991–2020 normals
Average July dew point70°FPRISM 1991–2020 normals
Median year homes were built1954Census ACS 2019–2023
Households3,056Census ACS 2019–2023
CountyBexar CountyCensus Bureau
Federal minimum for a new split central AC14.3 SEER2 under 45,000 Btu/h (Southeast)DOE, 2023 standard

Why heating faults in Alamo Heights do not fix themselves

A furnace that has to be reset to keep running is not a furnace that is working. Each lockout is a control board refusing to try again after a safety did not prove — the flame, the pressure switch or the limit — and a reset answers none of that. What a reset does change is the wear: a furnace short cycling through a cold week runs its ignition sequence dozens of times a day, and the ignitor and the inducer motor are the parts paying for it.

A heating tune-up before the season

A pre-season heating tune-up is the one visit booked on your schedule instead of the furnace's. In Alamo Heights it belongs before the first cold night, because the faults that end a winter evening are mostly parts that were already wearing in October: an ignitor near the end of its starts, a flame sensor carrying last season's coating, a filter loaded through the cooling months, a condensate drain that has grown a film.

A technician at an indoor air handler

Signs it is time to call

  • There is a smell of gas, or a carbon monoxide alarm has gone off — outside first, then the gas utility, then the repair call.
  • The blower runs and the air never warms, or the thermostat is asking for heat while the reading keeps dropping.
  • Water is standing at the base of the furnace, or the flue outside has iced over.
The license
Held by the contractor, not by this site, and issued where the work happens — Texas licenses at state level, at city level or not at all depending on the trade and the town. Ask for the number and the name it is held under: a trading name and the licensed entity are often not the same.
The figure
Set by the contractor and said before the work starts. This site never quotes and has no part in it. If a technician cannot say what the visit covers before beginning, that is the moment to stop.
The call
Describing what the system is doing commits you to nothing. Nothing is booked until you say so.

What a visit in Alamo Heights involves

  1. 01

    The diagnosis

    At the thermostat first, then at the furnace or the condenser, in the order the equipment runs. What the system is doing is established before any part is named.

  2. 02

    The repair

    Agreed with the contractor before it starts. Where a part has to be ordered, a technician says so rather than leaving the system apart.

  3. 03

    What happens after

    A system that failed once in a season often fails again in it. Whether that is the same fault or a second one is worth asking while the technician is still there.

What to have ready when you call from Alamo Heights

  1. 01Which system it is: a furnace, a boiler with radiators or baseboard, or a heat pump with electric backup.
  2. 02Both numbers from the thermostat — the setting, and what it says the room is — and whether the screen has gone blank, because a thermostat wired without a common wire runs off its battery, and a dead battery looks exactly like a dead furnace.
  3. 03Whether the gas utility has already sent someone, and whether anything has been tagged.

Leave the reset alone while you wait — each press relights a furnace that shut itself down for a reason, and the lockout it is holding is the first thing a technician reads.

Heating Repair in Alamo Heights: questions

How many freezing days does Alamo Heights have?

Alamo Heights averages 22 days a year with a low of 32°F or colder and 1 at 20°F or colder, by the 1991–2020 climate normals for the NOAA station in or next to town. Heating is rarely asked for here, so a fault in it can sit unnoticed until the one cold week of the year.

How old are the homes in Alamo Heights?

Half the homes in Alamo Heights were built before 1954, by the Census Bureau's 2019–2023 American Community Survey. Detached houses make up about half of the housing. In houses that age the furnace or air conditioner has usually been replaced at least once, and the ducts and the flue are often older than the equipment.

How efficient must a new gas furnace be?

A new non-weatherized gas furnace has to reach an AFUE of at least 80 under the federal minimum. A 95 standard is set for furnaces made after December 18, 2028 and is still in court, so a furnace going in now can be an 80 or a condensing model in the 90s.

Map loads when you reach it

Other services in Alamo Heights

Heating Repair nearby

Call (888) 217-3739