Olmos Park, TX
Furnace and Heating Repair in Olmos Park, TX
Heating repair in Olmos Park, TX comes down to finding the step where the furnace or heat pump stops in its start-up sequence. Olmos Park has, on average, 22 days a year with a low of 32°F or colder and about one at 20°F or colder (NOAA 1991–2020 normals, station in or next to town). Half the homes in Olmos Park were built before 1941 (Census ACS 2019–2023), so in many of them the heating and cooling equipment has been replaced at least once while the ducts and the flue have not. A gas utility that finds a leak or an unsafe furnace shuts off the gas and tags the appliance, and the gas stays off until a contractor repairs the fault.
(888) 217-3739Texas contractors. No obligation for the call.
No heat on a cold night comes down to a short list of faults, and the step where the sequence stops names the part. Say what heats the house, what the thermostat is asking for against what it says the room is, and what the equipment is actually doing, and a heating contractor who covers Olmos Park takes it from there.
The heating half of the system is the part nobody in Olmos Park thinks about, and in a climate like this it is as often as not the same outdoor unit that cools in July, running the other way. A household can live with a heat pump for years without knowing the machine does both jobs, which is why the first thing worth saying on the phone is which of the two heats the house.
Where a heat pump does the heating, no heat usually means it stopped heating rather than stopped running. The reversing valve is what decides which job the machine is doing, and one that sticks leaves an outdoor unit sounding normal and air at the registers that never warms. Where a small gas furnace does the heating instead, the list is the familiar one: flame sensor, ignitor, pressure switch, limit switch.
Where July dew points sit at 70°F and above, the indoor coil runs wet for the whole season, and everything it takes out of the air leaves through one drain line. A summer of that grows a film inside the trap and the line, and nobody thinks about a drain on the first cold night: a condensing furnace makes water of its own, in most installations it goes down that same line, and a line that will not take it backs the water up until the pressure switch refuses to close. So a no-heat call in a climate like this can end at the drain rather than at the burner.
Olmos Park, TX in numbers
| Days a year with a low of 32°F or colder | 22 | NOAA 1991–2020 normals, station in or next to town |
|---|---|---|
| Days a year with a low of 20°F or colder | 1 | NOAA 1991–2020 normals |
| Average July dew point | 70°F | PRISM 1991–2020 normals |
| Median year homes were built | 1941 | Census ACS 2019–2023 |
| Households | 879 | Census ACS 2019–2023 |
| County | Bexar County | Census Bureau |
| Federal minimum for a new split central AC | 14.3 SEER2 under 45,000 Btu/h (Southeast) | DOE, 2023 standard |
Before you try the store-bought fix
A new filter is the one item from a hardware store that ends a no-heat call outright, and it is fair to say so: a filter loaded solid chokes the return, the heat exchanger cannot put its heat into air that is barely moving, the limit switch opens, and the furnace shuts itself down and short cycles. What a new filter cannot do is prove it was the fault. Where the furnace locks out again within a day of a new one going in, the air was restricted somewhere past the filter, and a technician measures the temperature rise across the furnace to find where.
A heating tune-up before the season
A heating maintenance visit covers a concrete list, and it is worth asking about each item by name: the ignition sequence run from start to finish, the flame sensor cleaned and its signal read, the temperature rise measured across the furnace, the heat exchanger looked over for cracks, carbon monoxide checked at the flue, and the drain cleared. On a heat pump the list adds the defrost cycle and the auxiliary heat strips; on a boiler, the pressure, the relief valve and the circulator.
Signs it is time to call
- There is a smell of gas, or a carbon monoxide alarm has gone off — outside first, then the gas utility, then the repair call.
- There is a tag on the furnace and the gas supply has been shut off.
- The blower runs and the air never warms, or the thermostat is asking for heat while the reading keeps dropping.
- The license
- Held by the contractor, not by this site, and issued where the work happens — Texas licenses at state level, at city level or not at all depending on the trade and the town. Ask for the number and the name it is held under: a trading name and the licensed entity are often not the same.
- The figure
- Set by the contractor and said before the work starts. This site never quotes and has no part in it. If a technician cannot say what the visit covers before beginning, that is the moment to stop.
- The call
- Describing what the system is doing commits you to nothing. Nothing is booked until you say so.
What happens on the visit
- 01
The diagnosis
At the thermostat first, then at the furnace or the condenser, in the order the equipment runs. What the system is doing is established before any part is named.
- 02
The repair
Agreed with the contractor before it starts. Where a part has to be ordered, a technician says so rather than leaving the system apart.
- 03
What happens after
A system that failed once in a season often fails again in it. Whether that is the same fault or a second one is worth asking while the technician is still there.
What to have ready when you call
- 01What the system is — a furnace, a boiler on radiators or baseboard, or a heat pump with electric backup.
- 02Both numbers from the thermostat — the setting, and what it says the room is — and whether the screen is blank, because a thermostat wired without a common wire runs off its battery, and a battery that has gone down looks exactly like a dead furnace.
- 03Whether the gas utility has already been to the house, and whether there is a tag on the appliance.
Leave the reset alone while you wait — each press relights a furnace that shut itself down for a reason, and the lockout it is holding is the first thing a technician reads.
Heating Repair in Olmos Park: questions
How cold does Olmos Park get in winter?
Olmos Park averages 22 days a year with a low of 32°F or colder and 1 at 20°F or colder, by the 1991–2020 climate normals for the NOAA station in or next to town. Heating is rarely asked for here, so a fault in it can sit unnoticed until the one cold week of the year.
When were most houses in Olmos Park built?
Half the homes in Olmos Park were built before 1941, by the Census Bureau's 2019–2023 American Community Survey. Detached houses make up most of the housing. In houses that age the furnace or air conditioner has usually been replaced at least once, and the ducts and the flue are often older than the equipment.
What happens if the gas company red-tags a furnace in Olmos Park?
A red tag means the gas utility found a leak or an unsafe appliance and shut the gas off to it. The gas stays off until a contractor repairs the fault, and a cracked heat exchanger is often where a red tag turns a repair into a replacement.
Other services in Olmos Park
Heating Repair nearby