Selma, AL
Furnace and Heating Repair in Selma, AL
Heating repair in Selma, AL comes down to finding the step where the furnace or heat pump stops in its start-up sequence. Selma averages 40 days a year with a low of 32°F or colder and 3 at 20°F or colder (NOAA 1991–2020 normals, station in or next to town). Half the homes in Selma were built before 1969 (Census ACS 2019–2023), so in many of them the heating and cooling equipment has been replaced at least once while the ducts and the flue have not. When the gas utility finds a leak or an unsafe furnace it shuts the gas off and tags the appliance, and only a repair brings the gas back.
(888) 217-3739Alabama contractors. No obligation for the call.
A system that has stopped making heat on a cold night has one of a short list of faults behind it, and the step where the sequence stops names the part. Say what heats the house, both thermostat numbers — the setting and the reading — and what the equipment is doing, and a heating contractor who covers Selma takes it from there.
Here the year belongs to cooling, and the heating side of the system is the half that waits. Whatever heats the house has been sitting since spring, and the first cold night is the first thing to ask anything of it since then — which is why heating faults in Selma arrive on a schedule.
Equipment that sits is not equipment that rested. The filter that loaded through the cooling season is still in the cabinet when the blower has to move heated air through it; where a gas furnace does the heating, an ignitor that has been cold since spring is the part that most often fails on the first cold start of the season, and last winter's coating is still on the flame sensor, because nothing has burned since and nobody cleaned it. That is why the first cold week in Selma takes a lot of houses at once.
Where July dew points sit at 70°F and above, the indoor coil runs wet for the whole season, and everything it takes out of the air leaves through one drain line. A summer of that grows a film inside the trap and the line, and nobody thinks about a drain on the first cold night: a condensing furnace makes water of its own, in most installations it goes down that same line, and a line that will not take it backs the water up until the pressure switch refuses to close. So a no-heat call in a climate like this can end at the drain rather than at the burner.
Selma, AL in numbers
| Days a year with a low of 32°F or colder | 40 | NOAA 1991–2020 normals, station in or next to town |
|---|---|---|
| Days a year with a low of 20°F or colder | 3 | NOAA 1991–2020 normals |
| Average July dew point | 71°F | PRISM 1991–2020 normals |
| Median year homes were built | 1969 | Census ACS 2019–2023 |
| Households | 7,796 | Census ACS 2019–2023 |
| County | Dallas County | Census Bureau |
| Federal minimum for a new split central AC | 14.3 SEER2 under 45,000 Btu/h (Southeast) | DOE, 2023 standard |
Why heating faults do not fix themselves
The fault that changes the whole conversation is a cracked heat exchanger. It is not a repair question alone — the gas utility red-tags the appliance and shuts the supply off, and it restores the supply only after a licensed contractor has worked on the furnace. Flipping the switch changes nothing about the tag, and taking the tag off gets rid of the record of what was found.
A heating tune-up before the season
What a technician checks on a heating maintenance visit is concrete, and worth naming on the phone: the ignition sequence run from start to finish, the flame sensor cleaned and its signal read, the temperature rise measured across the furnace, the heat exchanger looked over for cracks, carbon monoxide checked at the flue, and the drain cleared. On a heat pump the list adds the defrost cycle and the auxiliary heat strips; on a boiler, the pressure, the relief valve and the circulator.
Signs it is time to call
- The furnace locks out again within an hour of being reset.
- There is a tag on the furnace and the gas supply has been shut off.
- The blower runs and the air never warms, or the thermostat is asking for heat while the reading keeps dropping.
- The license
- Held by the contractor, not by this site, and issued where the work happens — Alabama licenses at state level, at city level or not at all depending on the trade and the town. Ask for the number and the name it is held under: a trading name and the licensed entity are often not the same.
- The figure
- Set by the contractor and said before the work starts. This site never quotes and has no part in it. If a technician cannot say what the visit covers before beginning, that is the moment to stop.
- The call
- Describing what the system is doing commits you to nothing. Nothing is booked until you say so.
What the visit involves
- 01
The finding, out loud
What failed, whether it is the fault or a symptom of another one, and whether the repair suits the age of the system. A diagnostic visit is usually charged separately from the repair — ask whether it is credited if the work goes ahead, because that differs from one contractor to the next.
- 02
The repair
Agreed with the contractor before it starts. Where a part has to be ordered, a technician says so rather than leaving the system apart.
- 03
What happens after
A system that failed once in a season often fails again in it. Whether that is the same fault or a second one is worth asking while the technician is still there.
What to have ready when you call
- 01Which system it is: a furnace, a boiler with radiators or baseboard, or a heat pump with electric backup.
- 02What the equipment is actually doing — silent, clicking then stopping, lighting and dropping out, or blowing cold.
- 03Whether the gas utility has already been to the house, and whether there is a tag on the appliance.
Leave the reset alone while you wait — each press relights a furnace that shut itself down for a reason, and the lockout it is holding is the first thing a technician reads.
Heating Repair in Selma: questions
How cold does Selma get in winter?
Selma averages 40 days a year with a low of 32°F or colder and 3 at 20°F or colder, by the 1991–2020 climate normals for the NOAA station in or next to town. Cooling leads here, and the heating runs for a few weeks of the year, so a fault often shows up on the first cold morning.
How old are the homes in Selma?
Half the homes in Selma were built before 1969, by the Census Bureau's 2019–2023 American Community Survey. Detached houses make up about half of the housing. In houses that age the furnace or air conditioner has usually been replaced at least once, and the ducts and the flue are often older than the equipment.
What efficiency does a new gas furnace in Selma need?
A new non-weatherized gas furnace has to reach an AFUE of at least 80 under the federal minimum. A 95 standard is set for furnaces made after December 18, 2028 and is still in court, so a furnace going in now can be an 80 or a condensing model in the 90s.