HeatCoolHQ heatcoolhq.com (888) 217-3739

Selma, AL

Heat Pump Repair and Replacement in Selma, AL

A heat pump in Selma, AL works in both seasons, so its repair or replacement starts with how it behaves in each. Selma averages 40 days a year with a low of 32°F or colder and 3 at 20°F or colder (NOAA 1991–2020 normals, station in or next to town). Half the homes in Selma were built before 1969 (Census ACS 2019–2023), so in many of them the heating and cooling equipment has been replaced at least once while the ducts and the flue have not. A split heat pump made since January 1, 2023 must rate at least 14.3 SEER2 and 7.5 HSPF2, a federal floor that does not change from state to state.

(888) 217-3739

Alabama contractors. No obligation for the call.

The year in Selma—cooling leads, heating gets weeks
The year in Selma. cooling leads, heating gets weeks. Between the two seasons there are weeks when neither system runs, which is when a fault goes unnoticed. nothing runsJFMAMJJASOND
heatingcooling40 days below freezing · July dew point 71°F
A technician checking the coil of an outdoor heat pump in winter
The top grille off, frost across the coil. A heat pump melts that off on a schedule of its own, which looks like a fault and is not.

Air that feels cool at the vents in winter is usually the heat pump working as designed, and a heat pump that sits on auxiliary heat for hours in mild weather usually is not. Say what the thermostat is showing and a heating and cooling contractor can come out to Selma and tell the two apart.

A heat pump in Selma works most of its hours as an air conditioner, and the heating side runs for a few weeks rather than a season. That decides which faults get noticed and when: anything wrong with cooling shows up in July with the whole house paying attention, while anything wrong with heating waits for the first cold week of the year to announce itself.

The reversing valve is the part that pattern is hardest on. It holds one position for most of the year and is then asked to move, and a valve that has sat that long sometimes does not move at all, or stops halfway. A system that cooled all summer and then delivers room-temperature air in the first cold week of December is describing that valve, or the solenoid on it, far more often than a dead compressor.

Sizing a heat pump means sizing for two jobs at once, and in a July this wet they pull against each other. Sized for the coldest night, it is oversized for the cooling season: it drops the temperature, shuts off, and never runs long enough to pull water out of the air, so the thermostat reads 74°F and the house still feels damp. That is where a single-stage machine runs out of options, and it is the argument for a compressor that modulates rather than one that is simply larger — long, slow run cycles are what dehumidify. Ask what the size was based on: a measurement of the house, with the heating load and the cooling load worked out separately.

Selma, AL in numbers

Days a year with a low of 32°F or colder40NOAA 1991–2020 normals, station in or next to town
Days a year with a low of 20°F or colder3NOAA 1991–2020 normals
Average July dew point71°FPRISM 1991–2020 normals
Median year homes were built1969Census ACS 2019–2023
Households7,796Census ACS 2019–2023
CountyDallas CountyCensus Bureau
Federal minimum for a new split central AC14.3 SEER2 under 45,000 Btu/h (Southeast)DOE, 2023 standard

Why heat pumps do not fix themselves

A heat pump is unusual in that it can fail without going quiet. A machine low on refrigerant, or one whose defrost control has stopped working, does not stop making heat — it falls behind, and the backup heat fills the gap without being asked. The thermostat still reads what it is set to, so the fault turns up on the electric bill rather than in the house. The same shortfall in cooling is easier to spot, because nothing covers for it — which is why a heat pump often gets diagnosed in summer for something it had been doing all through the heating season.

A technician at an indoor air handler

When to stop and call

  • The thermostat sits on auxiliary or emergency heat for hours while it is mild outside.
  • It cools in summer but will not heat, or it heats but will not cool.
  • Refrigerant was added in an earlier season and the system is behaving the same way again.
The figure
Set by the contractor and said before the work starts. This site never quotes and has no part in it. If a technician cannot say what the visit covers before beginning, that is the moment to stop.
The call
Describing what the system is doing commits you to nothing. Nothing is booked until you say so.
Coverage
By town, not by region. Selma and the towns around it, and it shifts with who is taking calls at the hour you ring.

What a visit in Selma involves

  1. 01

    The diagnosis

    At the thermostat first, then at the furnace or the condenser, in the order the equipment runs. What the system is doing is established before any part is named.

  2. 02

    The finding, out loud

    What failed, whether it is the fault or a symptom of another one, and whether the repair suits the age of the system. A diagnostic visit is usually charged separately from the repair — ask whether it is credited if the work goes ahead, because that differs from one contractor to the next.

  3. 03

    The repair

    Agreed with the contractor before it starts. Where a part has to be ordered, a technician says so rather than leaving the system apart.

What to have ready when you call from Selma

  1. 01That it is a heat pump, and what the backup is — electric, or a gas furnace on the same ducts, and not knowing is a fair answer.
  2. 02What the outdoor unit is doing: iced over, silent, running without stopping, or reversing every few minutes.
  3. 03The address and ZIP code, and whether the outdoor unit can be reached — a locked gate, a dog or deep snow changes the appointment.

Emergency heat is what that setting is for if the house has gone cold, but say on the phone that you switched to it, because it locks out the compressor, and the fault a technician needs to watch stops happening while it is on.

Heat Pumps in Selma: questions

How cold does Selma get in winter?

Selma averages 40 days a year with a low of 32°F or colder and 3 at 20°F or colder, by the 1991–2020 climate normals for the NOAA station in or next to town. Cooling sizes the equipment here, and the few cold mornings are when the backup heat comes on.

What is the July dew point in Selma?

The July dew point in Selma averages 71°F, by the PRISM 1991–2020 climate normals. In air that wet an oversized air conditioner cools the house fast, shuts off before it has dried the air, and leaves rooms cool and clammy, which is why sizing starts with a load calculation for the house.

What efficiency does a new heat pump need in Selma?

The federal minimum for a split heat pump made since January 1, 2023 is 14.3 SEER2 for cooling and 7.5 HSPF2 for heating, the same in Alabama as in every other state. The rating of the matched outdoor unit and coil is on the AHRI certificate, and a quote for Selma can go above the minimum.

Map loads when you reach it

Other services in Selma

Heat Pumps nearby

Call (888) 217-3739