HeatCoolHQ heatcoolhq.com (888) 217-3739

Selma, AL

Ductwork and Airflow in Selma, AL

Duct repair in Selma, AL starts with measuring the airflow at the registers and the static pressure at the air handler. Half the homes in Selma were built before 1969 (Census ACS 2019–2023), and ducts in houses that age were often added or extended long after they were built. Selma has an average July dew point of 71°F (PRISM 1991–2020 normals), air wet enough that an air conditioner spends much of each cycle pulling water out of it. Under the 2021 International Energy Conservation Code, a new duct system may leak no more than 4 cubic feet of air a minute per 100 square feet of floor area at the post-construction test, where the state or town has adopted that edition.

(888) 217-3739

Alabama contractors. No obligation for the call.

The year in Selma—cooling leads, heating gets weeks
The year in Selma. cooling leads, heating gets weeks. Between the two seasons there are weeks when neither system runs, which is when a fault goes unnoticed. nothing runsJFMAMJJASOND
heatingcooling40 days below freezing · July dew point 71°F
A technician joining flexible duct to a metal trunk line in a crawl space
Flexible duct being strapped to the trunk line under the floor. What leaves the equipment and what arrives at the register are two different numbers.

A room that never gets comfortable while the rest of the house is fine is usually a duct problem rather than an equipment problem. Say which room and in which season, and an independent contractor can come out to Selma and measure the airflow instead of guessing at it.

Cooling leads the year in Selma, and the installer sizes the duct around the cooling load — where anybody sized it at all. That works in your favor more often than not: a system with a furnace moves less air in heating than it moves in cooling, and a heat pump moves the same air in both, so a run sized to carry the house through August usually carries it through the few cold weeks either way.

What the short winter changes is where the loss lands, not whether there is one. A joint in a vented crawl space or an unconditioned attic leaks at the same rate in every month of the year; here it leaks through a cooling season that runs most of the year and a heating season measured in weeks. So almost everything a duct leak costs here is written in summer, and the time to get a contractor under the house is before that season rather than in the middle of it.

July here is humid enough that duct picks up a failure dry climates never see: a supply run crossing an unconditioned attic or crawl space carries air near 55°F through air whose dew point is above 70°F, and where the insulation is torn, compressed or missing, the duct sweats. Water runs downhill to the low point of the run, and it turns up a floor below, some distance from the joint that made it. A leaking return in the same space does the other half of the damage — it draws that outside air in at its own dew point, and the coil spends its capacity drying attic air while the house stays cool and clammy.

Selma, AL in numbers

Days a year with a low of 32°F or colder40NOAA 1991–2020 normals, station in or next to town
Days a year with a low of 20°F or colder3NOAA 1991–2020 normals
Average July dew point71°FPRISM 1991–2020 normals
Median year homes were built1969Census ACS 2019–2023
Households7,796Census ACS 2019–2023
CountyDallas CountyCensus Bureau
Federal minimum for a new split central AC14.3 SEER2 under 45,000 Btu/h (Southeast)DOE, 2023 standard

What the hardware-store fix does and does not do

Duct tape is named for the one job it does not hold. The cloth-backed roll dries out on a warm duct and releases, usually within a couple of years, and the joint is open again with nothing to show for the afternoon. What holds is mastic brushed on, or foil tape carrying a UL 181 marking on the roll — and both want the joint clean and dry, which is the hard part in a crawl space.

A technician at an indoor air handler

When to stop and call

  • A return grille whistles or roars, or the filter bows inward when the blower starts.
  • There is a stain on a ceiling under a duct run, or duct insulation that is wet to the touch.
  • Ice on the line at the air handler, or the system shutting itself off and starting again within the hour.
The license
Held by the contractor, not by this site, and issued where the work happens — Alabama licenses at state level, at city level or not at all depending on the trade and the town. Ask for the number and the name it is held under: a trading name and the licensed entity are often not the same.
The figure
Set by the contractor and said before the work starts. This site never quotes and has no part in it. If a technician cannot say what the visit covers before beginning, that is the moment to stop.
The call
Describing what the system is doing commits you to nothing. Nothing is booked until you say so.

What a visit in Selma involves

  1. 01

    The diagnosis

    At the thermostat first, then at the furnace or the condenser, in the order the equipment runs. What the system is doing is established before any part is named.

  2. 02

    The finding, out loud

    What failed, whether it is the fault or a symptom of another one, and whether the repair suits the age of the system. A diagnostic visit is usually charged separately from the repair — ask whether it is credited if the work goes ahead, because that differs from one contractor to the next.

  3. 03

    The repair

    Agreed with the contractor before it starts. Where a part has to be ordered, a technician says so rather than leaving the system apart.

Before you call: what to have ready

  1. 01Which rooms are wrong, and whether it is in heating, in cooling, or both — that one answer narrows it before anybody arrives.
  2. 02The filter size, and how long the one in the slot has been there, and whether any register or damper has been closed.
  3. 03What the system is — furnace, heat pump, or a furnace with cooling added — and roughly what year it went in, and whether the installer replaced the duct with it or left it in place.

Do not go around opening and closing registers before the visit — a technician measures the system as it actually runs, and one damper moved this morning shifts every reading this afternoon.

Ductwork in Selma: questions

How old are the homes in Selma?

Half the homes in Selma were built before 1969, by the Census Bureau's 2019–2023 American Community Survey. Detached houses make up about half of the housing. Ducts in houses that age were often added after the house was built, sized for heat rather than for cooling.

What is the July dew point in Selma?

The July dew point in Selma averages 71°F, by the PRISM 1991–2020 climate normals. In air that wet an oversized air conditioner cools the house fast, shuts off before it has dried the air, and leaves rooms cool and clammy, which is why sizing starts with a load calculation for the house.

Is there a leakage limit for new ducts in Selma?

Under the 2021 International Energy Conservation Code, a new duct system may leak at most 4 cubic feet of air a minute per 100 square feet of floor area when tested after construction. Whether that applies depends on the code edition Alabama or the town has adopted, and the building department can say which one.

Map loads when you reach it

Other services in Selma

Ductwork nearby

Call (888) 217-3739