HeatCoolHQ heatcoolhq.com (888) 217-3739

SeaTac, WA

Heat Pump Repair and Replacement in SeaTac, WA

A heat pump in SeaTac, WA works in both seasons, so its repair or replacement starts with how it behaves in each. SeaTac averages 25 days a year with a low of 32°F or colder and about one at 20°F or colder (NOAA 1991–2020 normals, station in or next to town). Half the homes in SeaTac were built before 1971 (Census ACS 2019–2023). The federal minimum for a split heat pump made since January 1, 2023 is 14.3 SEER2 in cooling and 7.5 HSPF2 in heating, nationwide.

(888) 217-3739

Washington contractors. No obligation for the call.

The year in SeaTac—cooling runs nearly all year
The year in SeaTac. cooling runs nearly all year. There is no month when both systems are idle. JFMAMJJASOND
heatingcooling25 days below freezing · July dew point 53°F
A technician checking the coil of an outdoor heat pump in winter
The top grille off, frost across the coil. A heat pump melts that off on a schedule of its own, which looks like a fault and is not.

Air that feels cool at the vents in winter is usually the heat pump working as designed, and a heat pump that sits on auxiliary heat for hours in mild weather usually is not. Say what the thermostat is showing and a heating and cooling contractor can come out to SeaTac and tell the two apart.

In SeaTac the cooling season is the year and the heating season is a handful of mornings. What a no-heat call means here depends on what else is in the house: where there is a furnace, the heat pump has something to hand the load to, and where there is none — and in this climate plenty of houses have none — the only thing behind it is a bank of electric resistance strips. That is the first thing a technician establishes, because there is no second appliance to switch to.

The backup that goes in matches the winter this place actually has, which is the sensible way round and has one consequence worth knowing: a strip bank put in for a mild January holds less in reserve than the one the same house would get further north. A cold snap that another state would call ordinary finds that limit, and the house falls behind while the outdoor unit runs and tests fine. What has to be answered then is not what broke, but whether anything did, and that is a measurement rather than a guess.

Dry summer air leaves the cooling side only one job, so a machine sized too large does not leave the house clammy here — it short-cycles and lets the temperature swing instead. The winter difference matters more here, and it is about frost. Frost needs water in the air before it can build on an outdoor coil, and there is little of it here — so the defrost cycle runs less often than it would in a damp climate, and a coil that is genuinely iced over is reporting a fault rather than the weather. Elsewhere that same sheet of ice is worth waiting out for a day; here it is worth a phone call.

SeaTac, WA in numbers

Days a year with a low of 32°F or colder25NOAA 1991–2020 normals, station in or next to town
Days a year with a low of 20°F or colder1NOAA 1991–2020 normals
Average July dew point53°FPRISM 1991–2020 normals
Median year homes were built1971Census ACS 2019–2023
Households11,772Census ACS 2019–2023
CountyKing CountyCensus Bureau
Federal minimum for a new split central AC13.4 SEER2 (North region)DOE, 2023 standard

Before you try the store-bought fix

A hard-start kit does what it claims, which is exactly why it is worth being careful with. It adds starting torque, and a compressor that has begun to struggle will often run another season with one fitted — it is a real part, fitted deliberately on some systems, and not a gimmick. What it cannot do is say why the compressor needed help: a weak run capacitor, worn windings, or a system running at pressures it should not be. A kit fitted and then forgotten hides that question until the compressor answers it.

A technician at an indoor air handler

When to stop and call

  • The thermostat sits on auxiliary or emergency heat for hours while it is mild outside.
  • The breaker feeding the outdoor unit or the air handler will not stay in.
  • Refrigerant was added in an earlier season and the system is behaving the same way again.
The license
Held by the contractor, not by this site, and issued where the work happens — Washington licenses at state level, at city level or not at all depending on the trade and the town. Ask for the number and the name it is held under: a trading name and the licensed entity are often not the same.
The figure
Set by the contractor and said before the work starts. This site never quotes and has no part in it. If a technician cannot say what the visit covers before beginning, that is the moment to stop.
The call
Describing what the system is doing commits you to nothing. Nothing is booked until you say so.

What the visit involves

  1. 01

    The diagnosis

    At the thermostat first, then at the furnace or the condenser, in the order the equipment runs. What the system is doing is established before any part is named.

  2. 02

    The finding, out loud

    What failed, whether it is the fault or a symptom of another one, and whether the repair suits the age of the system. A diagnostic visit is usually charged separately from the repair — ask whether it is credited if the work goes ahead, because that differs from one contractor to the next.

  3. 03

    What happens after

    A system that failed once in a season often fails again in it. Whether that is the same fault or a second one is worth asking while the technician is still there.

Before you call: what to have ready

  1. 01That the system is a heat pump, and what carries the heat when it cannot — electric, or a gas furnace on the same ducts, and not knowing is a fair answer.
  2. 02Both thermostat numbers, and whether the display is showing auxiliary or emergency heat.
  3. 03What the outdoor unit is doing: iced over, silent, running without stopping, or reversing every few minutes.

Emergency heat is what that setting is for if the house has gone cold, but say on the phone that you switched to it, because it locks out the compressor, and the fault a technician needs to watch stops happening while it is on.

Heat Pumps in SeaTac: questions

How cold does SeaTac get in winter?

SeaTac averages 25 days a year with a low of 32°F or colder and 1 at 20°F or colder, by the 1991–2020 climate normals for the NOAA station in or next to town. Heating is a handful of mornings here, so a heat pump spends nearly the whole year cooling.

How humid are summers in SeaTac?

The July dew point in SeaTac averages 53°F, by the PRISM 1991–2020 climate normals. In air that dry most of the cooling load is heat, and an air conditioner removes little water, so sizing turns on the house and its sun more than on humidity.

Is a new R-410A system still allowed in SeaTac?

Federally, yes, for equipment made or imported before January 1, 2025: the EPA dropped the January 1, 2026 installation deadline for that stock in a rule effective July 27, 2026. What has been made since January 1, 2025 runs on R-454B or R-32, and those outdoor units are not a listed match for a coil built for R-410A.

Map loads when you reach it

Other services in SeaTac

Heat Pumps nearby

Call (888) 217-3739