SeaTac, WA
AC Replacement and Installation in SeaTac, WA
AC replacement in SeaTac, WA is sized from the house and its climate, not from the tonnage stamped on the old condenser. The July dew point in SeaTac averages 53°F (PRISM 1991–2020 normals), dry enough that nearly all of the cooling load is heat rather than moisture. Half the homes in SeaTac were built before 1971 (Census ACS 2019–2023). In Washington, a split central air conditioner made since January 1, 2023 has to rate at least 13.4 SEER2, the federal minimum for the North region.
(888) 217-3739Washington contractors. No obligation for the call.
An air conditioner that no longer holds the house on a hot afternoon is not automatically finished, and what settles it is age, what failed, and what the system is charged with. Say what year the system went in and what it has started doing, and an independent contractor can come out to SeaTac and size the replacement from the house rather than from the box being carried out.
Frost is rare enough in SeaTac that the calendar works differently here. In a heating climate a changeout can wait for the months when nobody asks the air conditioner for anything; here that stretch is shorter, and in a hot week it closes altogether. How many hours the system has actually run is the other half of it, and that varies more inside a mild-winter climate than the map suggests — a coastal summer and an inland one are not the same summer, and the same model reaches the end of its service life years apart in the two. Which is why the date the equipment went in decides less here than what a technician finds on the visit.
The refrigerant change arrives with a new system, not with a repair. A system already charged with R-410A stays lawful to run, service, repair and recharge, and no end date is attached to that; what changed is what a new residential system arrives charged with, and since 1 January 2025 that is R-454B or R-32. Both are classed as mildly flammable, and neither is listed for equipment built for R-410A, so converting an existing system is not a repair path — replacing it is.
This close to the ocean, salt air works on the outdoor unit itself — the aluminum fins, the copper of the coil, and the fasteners holding the cabinet together. Ask where the contractor means to set the new unit, and whether its coil is a coated one; both questions belong to the specification rather than to the first summer after it.
SeaTac, WA in numbers
| Days a year with a low of 32°F or colder | 25 | NOAA 1991–2020 normals, station in or next to town |
|---|---|---|
| Days a year with a low of 20°F or colder | 1 | NOAA 1991–2020 normals |
| Average July dew point | 53°F | PRISM 1991–2020 normals |
| Median year homes were built | 1971 | Census ACS 2019–2023 |
| Households | 11,772 | Census ACS 2019–2023 |
| County | King County | Census Bureau |
| Federal minimum for a new split central AC | 13.4 SEER2 (North region) | DOE, 2023 standard |
Air conditioners do not fix themselves
On a system charged with R-22 the arithmetic is sharper. Manufacture of new R-22 equipment stopped in 2010 and production and import of the refrigerant ended in 2020, so a technician recharging one now is putting back refrigerant reclaimed from another system. Recharging it is still lawful and still possible; it is simply the expensive kind of leak, and it is usually the one that ends the repair conversation.
When to stop and call in SeaTac
- You have read R-22 on the outdoor data plate, and the system is no longer holding the house.
- Ice comes back on the line or the coil after you have put a clean filter in.
- Someone has told you to replace the system without having measured the house.
- The license
- Held by the contractor, not by this site, and issued where the work happens — Washington licenses at state level, at city level or not at all depending on the trade and the town. Ask for the number and the name it is held under: a trading name and the licensed entity are often not the same.
- The call
- Describing what the system is doing commits you to nothing. Nothing is booked until you say so.
- Coverage
- By town, not by region. SeaTac and the towns around it, and it shifts with who is taking calls at the hour you ring.
What happens on the visit
- 01
The diagnosis
At the thermostat first, then at the furnace or the condenser, in the order the equipment runs. What the system is doing is established before any part is named.
- 02
The finding, out loud
What failed, whether it is the fault or a symptom of another one, and whether the repair suits the age of the system. A diagnostic visit is usually charged separately from the repair — ask whether it is credited if the work goes ahead, because that differs from one contractor to the next.
- 03
The repair
Agreed with the contractor before it starts. Where a part has to be ordered, a technician says so rather than leaving the system apart.
What to have ready when you call
- 01Roughly what year it was installed, and which refrigerant it runs on — the model number is worth having in front of you too.
- 02What happens when the system runs — not cooling at all, cooling weakly, running without ever stopping, tripping the breaker, or icing over.
- 03The address and ZIP code, and how a technician gets to the outdoor unit — a locked gate or a dog in the yard changes the appointment.
Find the outdoor data plate and read it before you call — the model number and the refrigerant are printed on it, and those two lines decide most of what follows.
AC Replacement in SeaTac: questions
What is the July dew point in SeaTac?
The July dew point in SeaTac averages 53°F, by the PRISM 1991–2020 climate normals. In air that dry most of the cooling load is heat, and an air conditioner removes little water, so sizing turns on the house and its sun more than on humidity.
When were most houses in SeaTac built?
Half the homes in SeaTac were built before 1971, by the Census Bureau's 2019–2023 American Community Survey. Detached houses make up a good share of the housing. Equipment in houses of that age is often on its second set, and the install date on the label decides whether parts are still made.
Is a new R-410A system still allowed in SeaTac?
Under federal rules, yes, if the equipment was made or imported before January 1, 2025: an EPA rule that took effect on July 27, 2026 removed the January 1, 2026 installation deadline for that stock. Equipment made since January 1, 2025 is charged with R-454B or R-32 instead, and an outdoor unit built for those is not a listed match for an indoor coil built for R-410A.
Other services in SeaTac
AC Replacement nearby