HeatCoolHQ heatcoolhq.com (888) 217-3739

Kenmore, WA

Heat Pump Repair and Replacement in Kenmore, WA

Heat pump repair in Kenmore, WA starts by telling a normal defrost cycle or auxiliary-heat run from one that is a fault. Kenmore averages 25 days a year with a low of 32°F or colder and about one at 20°F or colder (NOAA 1991–2020 normals, station 4 miles away). Half the homes in Kenmore were built before 1984 (Census ACS 2019–2023). A split heat pump made since January 1, 2023 must rate at least 14.3 SEER2 and 7.5 HSPF2, a federal floor that does not change from state to state.

(888) 217-3739

Washington contractors. No obligation for the call.

The year in Kenmore—cooling runs nearly all year
The year in Kenmore. cooling runs nearly all year. There is no month when both systems are idle. JFMAMJJASOND
heatingcooling25 days below freezing · July dew point 54°F
A technician checking the coil of an outdoor heat pump in winter
The top grille off, frost across the coil. A heat pump melts that off on a schedule of its own, which looks like a fault and is not.

Air that feels cool at the vents in winter is usually the heat pump working as designed, and a heat pump that sits on auxiliary heat for hours in mild weather usually is not. Say what the thermostat is showing and a heating and cooling contractor can come out to Kenmore and tell the two apart.

In Kenmore the cooling season is the year and the heating season is a handful of mornings. What a no-heat call means here depends on what else is in the house: where there is a furnace, the heat pump has something to hand the load to, and where there is none — and in this climate plenty of houses have none — the only thing behind it is a bank of electric resistance strips. That is the first thing a technician establishes, because there is no second appliance to switch to.

The backup that goes in matches the winter this place actually has, which is the sensible way round and has one consequence worth knowing: a strip bank put in for a mild January holds less in reserve than the one the same house would get further north. A freeze that would be unremarkable further north finds that limit, and the house falls behind while the outdoor unit runs and tests fine. What has to be answered then is not what broke, but whether anything did, and that is a measurement rather than a guess.

Summer air here carries less water than it does further east, and air holding less water cools off faster once the sun is down. That puts a wide gap between afternoon and dawn, and in spring and autumn a heat pump answers both ends of it in a single day — cooling in the afternoon, heating before sunrise, with nobody switching anything over. The cost of that is hidden in the thermostat: set the heating and cooling numbers close together and the system changes direction several times a day, and every change is the reversing valve moving and the compressor starting again. Ask where the changeover band sits — it is a setting, not a repair.

Kenmore, WA in numbers

Days a year with a low of 32°F or colder25NOAA 1991–2020 normals, station 4 miles away
Days a year with a low of 20°F or colder1NOAA 1991–2020 normals
Average July dew point54°FPRISM 1991–2020 normals
Median year homes were built1984Census ACS 2019–2023
Households9,004Census ACS 2019–2023
CountyKing CountyCensus Bureau
Federal minimum for a new split central AC13.4 SEER2 (North region)DOE, 2023 standard

Before you try the store-bought fix

The small can with a gauge on top is sold for car air conditioners, and that is not an accident: a homeowner cannot buy R-410A or R-454B over the counter. The EPA restricts sales of those refrigerants to certified technicians, and the exception that keeps the can on the shelf is refrigerant for a car air conditioner. Even if a fitting could be made to work, a technician sets the charge by measurement rather than by what a gauge reads — superheat and subcooling, read at the machine, and read differently in heating mode than in cooling. And a working system does not consume refrigerant: a heat pump that needs more of it has a leak, so the work is finding the leak rather than replacing what escaped.

A technician at an indoor air handler

When to stop and call

  • Ice covers the outdoor coil and the defrost cycles are not clearing it.
  • The thermostat sits on auxiliary or emergency heat for hours while it is mild outside.
  • It cools in summer but will not heat, or it heats but will not cool.
The figure
Set by the contractor and said before the work starts. This site never quotes and has no part in it. If a technician cannot say what the visit covers before beginning, that is the moment to stop.
The call
Describing what the system is doing commits you to nothing. Nothing is booked until you say so.
Coverage
By town, not by region. Kenmore and the towns around it, and it shifts with who is taking calls at the hour you ring.

What the visit involves

  1. 01

    The diagnosis

    At the thermostat first, then at the furnace or the condenser, in the order the equipment runs. What the system is doing is established before any part is named.

  2. 02

    The finding, out loud

    What failed, whether it is the fault or a symptom of another one, and whether the repair suits the age of the system. A diagnostic visit is usually charged separately from the repair — ask whether it is credited if the work goes ahead, because that differs from one contractor to the next.

  3. 03

    What happens after

    A system that failed once in a season often fails again in it. Whether that is the same fault or a second one is worth asking while the technician is still there.

Before you call: what to have ready

  1. 01That the system is a heat pump, and what carries the heat when it cannot — electric, or a gas furnace on the same ducts, and not knowing is a fair answer.
  2. 02Both thermostat numbers, and whether the display is showing auxiliary or emergency heat.
  3. 03What the outdoor unit is doing: iced over, silent, running without stopping, or reversing every few minutes.

Emergency heat is what that setting is for if the house has gone cold, but say on the phone that you switched to it, because it locks out the compressor, and the fault a technician needs to watch stops happening while it is on.

Heat Pumps in Kenmore: questions

How many freezing days does Kenmore have?

Kenmore averages 25 days a year with a low of 32°F or colder and 1 at 20°F or colder, by the 1991–2020 climate normals for a NOAA station 4 miles away. Heating is a handful of mornings here, so a heat pump spends nearly the whole year cooling.

How humid are summers in Kenmore?

The July dew point in Kenmore averages 54°F, by the PRISM 1991–2020 climate normals. In air that dry most of the cooling load is heat, and an air conditioner removes little water, so sizing turns on the house and its sun more than on humidity.

What efficiency does a new heat pump need in Kenmore?

A split heat pump made since January 1, 2023 has to rate at least 14.3 SEER2 for cooling and 7.5 HSPF2 for heating under the federal standard, and the minimum is the same in every state, Washington included. The rating of the matched outdoor unit and coil is on the AHRI certificate, and a quote for Kenmore can go above the minimum.

Map loads when you reach it

Other services in Kenmore

Heat Pumps nearby

Call (888) 217-3739