HeatCoolHQ heatcoolhq.com (888) 217-3739

Redmond, WA

Heat Pump Repair and Replacement in Redmond, WA

A heat pump in Redmond, WA works in both seasons, so its repair or replacement starts with how it behaves in each. Redmond has, on average, 25 days a year with a low of 32°F or colder and about one at 20°F or colder (NOAA 1991–2020 normals, station 7 miles away). Half the homes in Redmond were built in 1991 or later (Census ACS 2019–2023). The federal minimum for a split heat pump made since January 1, 2023 is 14.3 SEER2 in cooling and 7.5 HSPF2 in heating, nationwide.

(888) 217-3739

Washington contractors. No obligation for the call.

The year in Redmond—cooling runs nearly all year
The year in Redmond. cooling runs nearly all year. There is no month when both systems are idle. JFMAMJJASOND
heatingcooling25 days below freezing · July dew point 54°F
A technician checking the coil of an outdoor heat pump in winter
The top grille off, frost across the coil. A heat pump melts that off on a schedule of its own, which looks like a fault and is not.

A heat pump blowing air that feels cool in winter is usually working as designed, and a heat pump that sits on auxiliary heat for hours in mild weather usually is not. Say what the thermostat reads and a heating and cooling contractor can come out to Redmond and tell the two apart.

In Redmond the cooling season is the year and the heating season is a handful of mornings. What a no-heat call means here depends on what else is in the house: where there is a furnace, the heat pump has something to hand the load to, and where there is none — and in this climate plenty of houses have none — the only thing behind it is a bank of electric resistance strips. That is the first thing a technician asks about, because there is no second appliance to switch to.

The backup that goes in matches the winter this place actually has, which is the sensible way round and has one consequence worth knowing: a strip bank put in for a mild January holds less in reserve than the one the same house would get further north. A freeze that would be unremarkable further north finds that limit, and the house falls behind while the outdoor unit runs and tests fine. The question then is not what broke but whether anything did, and that is a measurement rather than a guess.

Summer air here carries less water than it does further east, and air holding less water cools off faster once the sun is down. That widens the gap between afternoon and dawn, and in spring and autumn a heat pump answers both ends of it in a single day — cooling in the afternoon, heating before sunrise, with nobody switching anything over. The cost of that is hidden in the thermostat: set the heating and cooling numbers close together and the system changes direction several times a day, and every change is the reversing valve moving and the compressor starting again. Ask what the changeover band is set to — it is a setting, not a repair.

Redmond, WA in numbers

Days a year with a low of 32°F or colder25NOAA 1991–2020 normals, station 7 miles away
Days a year with a low of 20°F or colder1NOAA 1991–2020 normals
Average July dew point54°FPRISM 1991–2020 normals
Median year homes were built1991Census ACS 2019–2023
Households31,997Census ACS 2019–2023
CountyKing CountyCensus Bureau
Federal minimum for a new split central AC13.4 SEER2 (North region)DOE, 2023 standard

What the hardware-store fix does and does not do

The small can with a gauge on top is sold for car air conditioners, and that is not an accident: a homeowner cannot buy R-410A or R-454B over the counter. The EPA restricts the sale of those refrigerants to certified technicians, and refrigerant for a car air conditioner is the exception that keeps the can on the shelf. Even where a fitting could be made to work, a technician sets the charge by measurement rather than by a gauge reading — superheat and subcooling, read at the machine, and read differently in heating mode than in cooling. And a working system does not consume refrigerant: a heat pump that needs more of it has a leak, so the work is finding the leak rather than replacing what escaped.

A technician at an indoor air handler

When to stop and call

  • The thermostat sits on auxiliary or emergency heat for hours while it is mild outside.
  • It cools in summer but will not heat, or it heats but will not cool.
  • Refrigerant was added in an earlier season and the system is behaving the same way again.
The license
Held by the contractor, not by this site, and issued where the work happens — Washington licenses at state level, at city level or not at all depending on the trade and the town. Ask for the number and the name it is held under: a trading name and the licensed entity are often not the same.
The figure
Set by the contractor and said before the work starts. This site never quotes and has no part in it. If a technician cannot say what the visit covers before beginning, that is the moment to stop.
Coverage
By town, not by region. Redmond and the towns around it, and it shifts with who is taking calls at the hour you ring.

What a visit in Redmond involves

  1. 01

    The diagnosis

    At the thermostat first, then at the furnace or the condenser, in the order the equipment runs. What the system is doing is established before any part is named.

  2. 02

    The finding, out loud

    What failed, whether it is the fault or a symptom of another one, and whether the repair suits the age of the system. A diagnostic visit is usually charged separately from the repair — ask whether it is credited if the work goes ahead, because that differs from one contractor to the next.

  3. 03

    What happens after

    A system that failed once in a season often fails again in it. Whether that is the same fault or a second one is worth asking while the technician is still there.

What to have ready when you call

  1. 01That it is a heat pump, and what the backup is — electric, or a gas furnace on the same ducts, and not knowing is a fair answer.
  2. 02Roughly what year it went in, and the refrigerant from the outdoor data plate — R-410A on most systems in service, R-454B on recent ones.
  3. 03What the unit outside is doing: iced over, silent, running without stopping, or reversing every few minutes.

If the house has gone cold, emergency heat is what that setting is for — say on the phone that you switched to it, because it locks out the compressor, and the fault a technician needs to watch stops happening while it is on.

Heat Pumps in Redmond: questions

How many freezing days does Redmond have?

Redmond averages 25 days a year with a low of 32°F or colder and 1 at 20°F or colder, by the 1991–2020 climate normals for a NOAA station 7 miles away. Heating is a handful of mornings here, so a heat pump spends nearly the whole year cooling.

How humid are summers in Redmond?

The July dew point in Redmond averages 54°F, by the PRISM 1991–2020 climate normals. In air that dry most of the cooling load is heat, and an air conditioner removes little water, so sizing turns on the house and its sun more than on humidity.

Does the federal tax credit still cover a new heat pump in Redmond?

No: under the tax law signed on July 4, 2025, the 25C credit does not apply to equipment installed after December 31, 2025. A quote that still counts it is out of date; a utility or state rebate is a separate program, and the contractor or the utility can say whether one applies.

Map loads when you reach it

Other services in Redmond

Heat Pumps nearby

Call (888) 217-3739