Altamonte Springs, FL
Furnace and Heating Repair in Altamonte Springs, FL
Furnace repair in Altamonte Springs, FL begins with what the system does when the thermostat calls for heat, and where in that sequence it quits. Altamonte Springs averages 1 days a year with a low of 32°F or colder and almost none at 20°F or colder (NOAA 1991–2020 normals, station 9 miles away). Half the homes in Altamonte Springs were built before 1983 (Census ACS 2019–2023). A gas utility that finds a leak or an unsafe furnace shuts off the gas and tags the appliance, and the gas stays off until a contractor repairs the fault.
(888) 217-3739Florida contractors. No obligation for the call.
A system that has stopped making heat on a cold night has one of a short list of faults behind it, and the step where the sequence stops names the part. Say what heats the house, both thermostat numbers — the setting and the reading — and what the equipment is doing, and a heating contractor who covers Altamonte Springs takes it from there.
The heating half of the system is the part nobody in Altamonte Springs thinks about, and in a climate like this it is as often as not the same outdoor unit that cools in July, running the other way. People live with a heat pump for years without knowing the machine does both jobs, which is why the first thing worth saying on the phone is which of the two heats the house.
Where a heat pump does the heating, no heat usually means it stopped heating rather than stopped running. The part that decides which job the machine is doing is the reversing valve, and one that sticks leaves an outdoor unit sounding normal and air at the registers that never warms. Where a small gas furnace does the heating instead, the list is the familiar one: flame sensor, ignitor, pressure switch, limit switch.
Where July dew points sit at 70°F and above, the indoor coil runs wet all summer, and everything it pulls out of the air leaves by one drain line. A summer of that grows a film inside the trap and the line, and nobody thinks about a drain on the first cold night: a condensing furnace makes water of its own, in most installations it goes down that same line, and a line that will not take it backs the water up until the pressure switch refuses to close. In a climate like this a no-heat call can end at the drain and never reach the burner.
Altamonte Springs, FL in numbers
| Days a year with a low of 32°F or colder | 1 | NOAA 1991–2020 normals, station 9 miles away |
|---|---|---|
| Days a year with a low of 20°F or colder | fewer than one | NOAA 1991–2020 normals |
| Average July dew point | 73°F | PRISM 1991–2020 normals |
| Median year homes were built | 1983 | Census ACS 2019–2023 |
| Households | 20,679 | Census ACS 2019–2023 |
| County | Seminole County | Census Bureau |
| Federal minimum for a new split central AC | 14.3 SEER2 under 45,000 Btu/h (Southeast) | DOE, 2023 standard |
Before you try the store-bought fix
A new filter is the one thing off a hardware-store shelf that ends a no-heat call outright, and it is fair to say so: a filter that has loaded up chokes the return, the heat exchanger cannot put its heat into air that is barely moving, the limit switch opens, and the furnace shuts itself down and short cycles. What a new filter cannot do is prove it was the fault. Where the furnace locks out again within a day of a new one going in, the air was restricted somewhere past the filter, and a technician measures the temperature rise across the furnace to find where.
A heating tune-up before the season
What a technician checks on a heating maintenance visit is concrete, and worth naming on the phone: the ignition sequence run from start to finish, the flame sensor cleaned and its signal read, the temperature rise measured across the furnace, the heat exchanger looked over for cracks, carbon monoxide checked at the flue, and the drain cleared. On a heat pump the list adds the defrost cycle and the auxiliary heat strips; on a boiler, the pressure, the relief valve and the circulator.
When to stop and call
- The furnace locks out again within an hour of being reset.
- The blower runs and the air never warms, or the thermostat is asking for heat while the reading keeps dropping.
- Water is standing at the base of the furnace, or the flue outside has iced over.
- The license
- Held by the contractor, not by this site, and issued where the work happens — Florida licenses at state level, at city level or not at all depending on the trade and the town. Ask for the number and the name it is held under: a trading name and the licensed entity are often not the same.
- The call
- Describing what the system is doing commits you to nothing. Nothing is booked until you say so.
- Coverage
- By town, not by region. Altamonte Springs and the towns around it, and it shifts with who is taking calls at the hour you ring.
What the visit involves
- 01
The finding, out loud
What failed, whether it is the fault or a symptom of another one, and whether the repair suits the age of the system. A diagnostic visit is usually charged separately from the repair — ask whether it is credited if the work goes ahead, because that differs from one contractor to the next.
- 02
The repair
Agreed with the contractor before it starts. Where a part has to be ordered, a technician says so rather than leaving the system apart.
- 03
What happens after
A system that failed once in a season often fails again in it. Whether that is the same fault or a second one is worth asking while the technician is still there.
Before you call: what to have ready
- 01What the system is — a furnace, a boiler on radiators or baseboard, or a heat pump with electric backup.
- 02When the system went in, as near as anyone knows, and the model and serial number off the data plate inside the cabinet door — the year is usually in the serial rather than printed as a date.
- 03What the equipment is actually doing — silent, clicking then stopping, lighting and dropping out, or blowing cold.
Do not keep pressing the reset while you wait — each press relights a furnace that shut itself down for a reason, and the lockout it is holding is the first thing a technician reads.
Heating Repair in Altamonte Springs: questions
How many freezing days does Altamonte Springs have?
Altamonte Springs averages 1 days a year with a low of 32°F or colder and almost none at 20°F or colder, by the 1991–2020 climate normals for a NOAA station 9 miles away. Heating is rarely asked for here, so a fault in it can sit unnoticed until the one cold week of the year.
When were most houses in Altamonte Springs built?
Half the homes in Altamonte Springs were built before 1983, by the Census Bureau's 2019–2023 American Community Survey. Detached houses make up some of the housing. Equipment in houses of that age is often on its second set, and the install date on the label decides whether parts are still made.
What happens if the gas company red-tags a furnace in Altamonte Springs?
A red tag means the gas utility found a leak or an unsafe appliance and shut the gas off to it. Gas comes back only after a contractor repairs the fault; a cracked heat exchanger is the finding that most often turns the repair into a replacement.
Other services in Altamonte Springs
Heating Repair nearby