HeatCoolHQ heatcoolhq.com (888) 217-3739

Lake Mary, FL

Furnace and Heating Repair in Lake Mary, FL

Heating repair in Lake Mary, FL comes down to finding the step where the furnace or heat pump stops in its start-up sequence. Lake Mary has, on average, 3 days a year with a low of 32°F or colder and almost none at 20°F or colder (NOAA 1991–2020 normals, station 5 miles away). Half the homes in Lake Mary were built in 1997 or later (Census ACS 2019–2023). A gas utility that finds a leak or an unsafe furnace shuts off the gas and tags the appliance, and the gas stays off until a contractor repairs the fault.

(888) 217-3739

Florida contractors. No obligation for the call.

The year in Lake Mary—cooling runs nearly all year
The year in Lake Mary. cooling runs nearly all year. There is no month when both systems are idle. JFMAMJJASOND
heatingcooling3 days below freezing · July dew point 73°F
A technician with a meter at the open panel of a gas furnace
A meter at the burner assembly with the panel off. The ignition sequence runs in a fixed order, and the step where it stops is what names the part.

No heat on a cold night comes down to a short list of faults, and the step where the sequence stops names the part. Say what heats the house, what the thermostat is asking for against what it says the room is, and what the equipment is actually doing, and a heating contractor who covers Lake Mary takes it from there.

Where the heat comes from a heat pump, no heat usually means it stopped heating rather than stopped running. The part that decides which job the machine is doing is the reversing valve, and one that sticks leaves an outdoor unit sounding normal and air at the registers that never warms. Where a small gas furnace does the heating instead, the list is the familiar one: flame sensor, ignitor, pressure switch, limit switch.

Air from the vents that feels cool in winter is not a fault by itself — a heat pump works on a smaller difference between the room and the air it supplies, and it runs longer cycles to make that up. What matters is whether the room gets to the number on the thermostat, and whether the electric strips are doing work the heat pump should be doing: a thermostat set or wired wrong brings them on when the weather never asked for them.

Where July dew points sit at 70°F and above, the indoor coil runs wet all summer, and everything it pulls out of the air leaves by one drain line. A summer of that grows a film inside the trap and the line, and nobody thinks about a drain on the first cold night: a condensing furnace makes water of its own, in most installations it goes down that same line, and a line that will not take it backs the water up until the pressure switch refuses to close. In a climate like this a no-heat call can end at the drain and never reach the burner.

Lake Mary, FL in numbers

Days a year with a low of 32°F or colder3NOAA 1991–2020 normals, station 5 miles away
Days a year with a low of 20°F or colderfewer than oneNOAA 1991–2020 normals
Average July dew point73°FPRISM 1991–2020 normals
Median year homes were built1997Census ACS 2019–2023
Households6,940Census ACS 2019–2023
CountySeminole CountyCensus Bureau
Federal minimum for a new split central AC14.3 SEER2 under 45,000 Btu/h (Southeast)DOE, 2023 standard

Why heating faults do not fix themselves

The one fault that changes the conversation entirely is a cracked heat exchanger. It is not a repair question alone — the gas utility red-tags the appliance and shuts the supply off, and it restores the supply only after a licensed contractor has worked on the furnace. The appliance does not come back by flipping a switch, and a tag pulled off the furnace takes the record of what was found with it.

A heating tune-up before the season

A heating tune-up is the one visit that happens on your schedule rather than the furnace's. In Lake Mary it belongs before the first cold night, because the faults that end a winter evening are mostly parts that were already wearing in October: an ignitor near the end of its starts, a flame sensor carrying last season's coating, a filter loaded through the cooling months, a condensate drain that has grown a film.

A technician at an indoor air handler

When to stop and call

  • There is a tag on the furnace and the gas supply has been shut off.
  • The blower runs and the air never warms, or the thermostat is asking for heat while the reading keeps dropping.
  • Water is standing at the base of the furnace, or the flue outside has iced over.
The license
Held by the contractor, not by this site, and issued where the work happens — Florida licenses at state level, at city level or not at all depending on the trade and the town. Ask for the number and the name it is held under: a trading name and the licensed entity are often not the same.
The figure
Set by the contractor and said before the work starts. This site never quotes and has no part in it. If a technician cannot say what the visit covers before beginning, that is the moment to stop.
The call
Describing what the system is doing commits you to nothing. Nothing is booked until you say so.

What happens on the visit

  1. 01

    The diagnosis

    At the thermostat first, then at the furnace or the condenser, in the order the equipment runs. What the system is doing is established before any part is named.

  2. 02

    The finding, out loud

    What failed, whether it is the fault or a symptom of another one, and whether the repair suits the age of the system. A diagnostic visit is usually charged separately from the repair — ask whether it is credited if the work goes ahead, because that differs from one contractor to the next.

  3. 03

    What happens after

    A system that failed once in a season often fails again in it. Whether that is the same fault or a second one is worth asking while the technician is still there.

Before you call: what to have ready

  1. 01What the system is — a furnace, a boiler on radiators or baseboard, or a heat pump with electric backup.
  2. 02Roughly when it went in, plus the model and serial number from the data plate inside the cabinet door — the year is usually in the serial rather than printed as a date.
  3. 03Whether the gas utility has already been to the house, and whether there is a tag on the appliance.

Leave the reset alone while you wait — each press relights a furnace that shut itself down for a reason, and the lockout it is holding is the first thing a technician reads.

Heating Repair in Lake Mary: questions

How cold does Lake Mary get in winter?

Lake Mary averages 3 days a year with a low of 32°F or colder and almost none at 20°F or colder, by the 1991–2020 climate normals for a NOAA station 5 miles away. Heating is rarely asked for here, so a fault in it can sit unnoticed until the one cold week of the year.

When were most houses in Lake Mary built?

Half the homes in Lake Mary were built in 1997 or later, by the Census Bureau's 2019–2023 American Community Survey. Detached houses make up about half of the housing. Equipment in houses of that age is often on its second set, and the install date on the label decides whether parts are still made.

How efficient must a new gas furnace be?

A new non-weatherized gas furnace has to reach an AFUE of at least 80 under the federal minimum. A 95 standard is set for furnaces made after December 18, 2028 and is still in court, so a furnace going in now can be an 80 or a condensing model in the 90s.

Map loads when you reach it

Other services in Lake Mary

Heating Repair nearby

Call (888) 217-3739