HeatCoolHQ heatcoolhq.com (888) 217-3739

Randolph AFB, TX

Furnace and Heating Repair in Randolph AFB, TX

Furnace repair in Randolph AFB, TX begins with what the system does when the thermostat calls for heat, and where in that sequence it quits. Randolph AFB has, on average, 12 days a year with a low of 32°F or colder and almost none at 20°F or colder (NOAA 1991–2020 normals, station in or next to town). Half the homes in Randolph AFB were built before 1938 (Census ACS 2019–2023), so in many of them the heating and cooling equipment has been replaced at least once while the ducts and the flue have not. When the gas utility finds a leak or an unsafe furnace it shuts the gas off and tags the appliance, and only a repair brings the gas back.

(888) 217-3739

Texas contractors. No obligation for the call.

The year in Randolph AFB—cooling runs nearly all year
The year in Randolph AFB. cooling runs nearly all year. There is no month when both systems are idle. JFMAMJJASOND
heatingcooling12 days below freezing · July dew point 70°F
A technician with a meter at the open panel of a gas furnace
A meter at the burner assembly with the panel off. The ignition sequence runs in a fixed order, and the step where it stops is what names the part.

A system that has stopped making heat on a cold night has one of a short list of faults behind it, and the step where the sequence stops names the part. Say what heats the house, both thermostat numbers — the setting and the reading — and what the equipment is doing, and a heating contractor who covers Randolph AFB takes it from there.

Where a heat pump does the heating, no heat usually means it stopped heating rather than stopped running. The reversing valve is what decides which job the machine is doing, and one that sticks leaves an outdoor unit sounding normal and air at the registers that never warms. Where the heating comes from a small gas furnace instead, the list is the familiar one: flame sensor, ignitor, pressure switch, limit switch.

Air from the vents that feels cool in winter is not a fault by itself — a heat pump works on a smaller difference between the room and the air it supplies, and it runs longer cycles to make that up. The test is whether the room gets to the number on the thermostat, and whether the electric strips are doing work the heat pump should be doing: a thermostat set or wired wrong brings them on when the weather never asked for them.

Where July dew points sit at 70°F and above, the indoor coil runs wet all summer, and everything it pulls out of the air leaves by one drain line. A summer of that grows a film inside the trap and the line, and nobody thinks about a drain on the first cold night: a condensing furnace makes water of its own, in most installations it goes down that same line, and a line that will not take it backs the water up until the pressure switch refuses to close. In a climate like this a no-heat call can end at the drain and never reach the burner.

Randolph AFB, TX in numbers

Days a year with a low of 32°F or colder12NOAA 1991–2020 normals, station in or next to town
Days a year with a low of 20°F or colderfewer than oneNOAA 1991–2020 normals
Average July dew point70°FPRISM 1991–2020 normals
Median year homes were built1938Census ACS 2019–2023
Households360Census ACS 2019–2023
CountyBexar CountyCensus Bureau
Federal minimum for a new split central AC14.3 SEER2 under 45,000 Btu/h (Southeast)DOE, 2023 standard

What the store-bought fix actually does

A new filter is the one item from a hardware store that ends a no-heat call outright, and it is fair to say so: a filter loaded solid chokes the return, the heat exchanger cannot put its heat into air that is barely moving, the limit switch opens, and the furnace shuts itself down and short cycles. What a new filter cannot do is prove it was the fault. Where the furnace locks out again within a day of a new one going in, the air was restricted somewhere past the filter, and a technician measures the temperature rise across the furnace to find where.

A heating tune-up before the season

A pre-season heating tune-up is the one visit booked on your schedule instead of the furnace's. In Randolph AFB it belongs before the first cold night, because the faults that end a winter evening are mostly parts that were already wearing in October: an ignitor near the end of its starts, a flame sensor carrying last season's coating, a filter loaded through the cooling months, a condensate drain that has grown a film.

A technician at an indoor air handler

When to stop and call in Randolph AFB

  • The furnace locks out again within an hour of being reset.
  • There is a tag on the furnace and the gas supply has been shut off.
  • The blower runs and the air never warms, or the thermostat is asking for heat while the reading keeps dropping.
The figure
Set by the contractor and said before the work starts. This site never quotes and has no part in it. If a technician cannot say what the visit covers before beginning, that is the moment to stop.
The call
Describing what the system is doing commits you to nothing. Nothing is booked until you say so.
Coverage
By town, not by region. Randolph AFB and the towns around it, and it shifts with who is taking calls at the hour you ring.

What the visit involves

  1. 01

    The diagnosis

    At the thermostat first, then at the furnace or the condenser, in the order the equipment runs. What the system is doing is established before any part is named.

  2. 02

    The finding, out loud

    What failed, whether it is the fault or a symptom of another one, and whether the repair suits the age of the system. A diagnostic visit is usually charged separately from the repair — ask whether it is credited if the work goes ahead, because that differs from one contractor to the next.

  3. 03

    The repair

    Agreed with the contractor before it starts. Where a part has to be ordered, a technician says so rather than leaving the system apart.

What to have ready when you call from Randolph AFB

  1. 01What the system is — a furnace, a boiler on radiators or baseboard, or a heat pump with electric backup.
  2. 02The two thermostat numbers: the setting, and the reading it shows for the room — and whether the screen is blank, because a thermostat wired without a common wire runs off its battery, and a battery that has gone down looks exactly like a dead furnace.
  3. 03What the equipment is actually doing — silent, clicking then stopping, lighting and dropping out, or blowing cold.

Do not keep pressing the reset while you wait — each press relights a furnace that shut itself down for a reason, and the lockout it is holding is the first thing a technician reads.

Heating Repair in Randolph AFB: questions

How many freezing days does Randolph AFB have?

Randolph AFB averages 12 days a year with a low of 32°F or colder and almost none at 20°F or colder, by the 1991–2020 climate normals for the NOAA station in or next to town. Heating is rarely asked for here, so a fault in it can sit unnoticed until the one cold week of the year.

How old are the homes in Randolph AFB?

Half the homes in Randolph AFB were built before 1938, by the Census Bureau's 2019–2023 American Community Survey. Detached houses make up about half of the housing. In houses that age the furnace or air conditioner has usually been replaced at least once, and the ducts and the flue are often older than the equipment.

How efficient must a new gas furnace be?

A new non-weatherized gas furnace has to reach an AFUE of at least 80 under the federal minimum. DOE has set 95 for furnaces made after December 18, 2028, and that rule is still being fought in court, so a furnace installed now can still be an 80 or a condensing 90-plus.

Map loads when you reach it

Other services in Randolph AFB

Heating Repair nearby

Call (888) 217-3739