HeatCoolHQ heatcoolhq.com (888) 217-3739

Murray, UT

Heat Pump Repair and Replacement in Murray, UT

A heat pump in Murray, UT works in both seasons, so its repair or replacement starts with how it behaves in each. Murray has, on average, 112 days a year with a low of 32°F or colder and 33 at 20°F or colder (NOAA 1991–2020 normals, station 6 miles away), and those colder days are when a heat pump leans on its backup heat. Half the homes in Murray were built before 1978 (Census ACS 2019–2023). The federal minimum for a split heat pump made since January 1, 2023 is 14.3 SEER2 in cooling and 7.5 HSPF2 in heating, nationwide.

(888) 217-3739

Utah contractors. No obligation for the call.

The year in Murray—both systems work a real season
The year in Murray. both systems work a real season. There is no month when both systems are idle. BELOW FREEZINGJFMAMJJASOND
heatingcoolingbelow freezing112 days below freezing · July dew point 45°F
A technician checking the coil of an outdoor heat pump in winter
The top grille off, frost across the coil. A heat pump melts that off on a schedule of its own, which looks like a fault and is not.

A heat pump blowing air that feels cool in winter is usually working as designed, and a heat pump that sits on auxiliary heat for hours in mild weather usually is not. Say what the thermostat reads and a heating and cooling contractor can come out to Murray and tell the two apart.

In Murray a heat pump carries most of the year by itself, cooling through the summer and heating through everything except the coldest weeks. That is the case for having one, and it is also what ages it: the compressor, the contactor and the capacitor take run hours an air conditioner in the same house would never see, which is why age on a heat pump is better counted in seasons worked than in years on the data plate — a system installed in 2012 that has worked both halves of every year since is further along than the date suggests.

Twice a year the machine has to change direction, and that is when the reversing valve gets tested — once in autumn and once in spring. A machine that heated all winter and then refuses to cool when the first warm week of May arrives is usually pointing at that valve, or at the control that tells it to move, rather than at the compressor. A spring failure is easy to put off, and that is the trap: the valve that would not move in May is the valve that has to move again in October, and a summer of leaving it alone does not fix it.

In dry air the cooling side has only one job to do, so a machine sized too large does not leave the house clammy here — it short-cycles and lets the temperature swing instead. The difference that matters more is in winter, and it is about frost. Frost needs water in the air before it can build on an outdoor coil, and there is little of it here — so the defrost cycle runs less often than it would in a damp climate, and a coil that is genuinely iced over is reporting a fault rather than the weather. Elsewhere that same sheet of ice is worth waiting out for a day; here it is worth a phone call.

Murray, UT in numbers

Days a year with a low of 32°F or colder112NOAA 1991–2020 normals, station 6 miles away
Days a year with a low of 20°F or colder33NOAA 1991–2020 normals
Average July dew point45°FPRISM 1991–2020 normals
Median year homes were built1978Census ACS 2019–2023
Households20,401Census ACS 2019–2023
CountySalt Lake CountyCensus Bureau
Federal minimum for a new split central AC13.4 SEER2 (North region)DOE, 2023 standard

Why heat pumps in Murray do not fix themselves

The parts that cycle fail first, and they rarely fail alone. A run capacitor that has lost capacitance does not stop the compressor — it raises the current the compressor draws every minute it runs, and the heat that comes with it. A heat pump asks for that on the heating side as well as the cooling one, where an AC only ever runs to cool, so the part that fails at the end of it is not the capacitor. A capacitor is a part; a compressor is a large fraction of the machine, and on a system installed before 2010 that is where the conversation turns to replacement.

A technician at an indoor air handler

When to stop and call

  • Ice covers the outdoor coil and the defrost cycles are not clearing it.
  • The thermostat sits on auxiliary or emergency heat for hours while it is mild outside.
  • The breaker feeding the outdoor unit or the air handler will not stay in.
The figure
Set by the contractor and said before the work starts. This site never quotes and has no part in it. If a technician cannot say what the visit covers before beginning, that is the moment to stop.
The call
Describing what the system is doing commits you to nothing. Nothing is booked until you say so.
Coverage
By town, not by region. Murray and the towns around it, and it shifts with who is taking calls at the hour you ring.

What the visit involves

  1. 01

    The finding, out loud

    What failed, whether it is the fault or a symptom of another one, and whether the repair suits the age of the system. A diagnostic visit is usually charged separately from the repair — ask whether it is credited if the work goes ahead, because that differs from one contractor to the next.

  2. 02

    The repair

    Agreed with the contractor before it starts. Where a part has to be ordered, a technician says so rather than leaving the system apart.

  3. 03

    What happens after

    A system that failed once in a season often fails again in it. Whether that is the same fault or a second one is worth asking while the technician is still there.

What to have ready when you call

  1. 01That the system is a heat pump, and what carries the heat when it cannot — electric, or a gas furnace on the same ducts, and not knowing is a fair answer.
  2. 02What the thermostat is set to, what it is reading, and whether it shows auxiliary or emergency heat.
  3. 03The address and ZIP code, and whether the outdoor unit can be reached — a locked gate, a dog or deep snow changes the appointment.

If the house has gone cold, emergency heat is what that setting is for — say on the phone that you switched to it, because it locks out the compressor, and the fault a technician needs to watch stops happening while it is on.

Heat Pumps in Murray: questions

How cold does Murray get in winter?

Murray averages 112 days a year with a low of 32°F or colder and 33 at 20°F or colder, by the 1991–2020 climate normals for a NOAA station 6 miles away. Both seasons are real here, and the coldest weeks are when the backup strips or a furnace carry part of the load.

How humid are summers in Murray?

The July dew point in Murray averages 45°F, by the PRISM 1991–2020 climate normals. In air that dry most of the cooling load is heat, and an air conditioner removes little water, so sizing turns on the house and its sun more than on humidity.

Does the federal tax credit still cover a new heat pump in Murray?

No. The 25C energy efficient home improvement credit ended for equipment installed after December 31, 2025, under the tax law signed on July 4, 2025. A quote that still counts it is out of date; a utility or state rebate is a separate program, and the contractor or the utility can say whether one applies.

Map loads when you reach it

Other services in Murray

Heat Pumps nearby

Call (888) 217-3739