HeatCoolHQ heatcoolhq.com (888) 217-3739

Kendall, FL

Heat Pump Repair and Replacement in Kendall, FL

Heat pump repair in Kendall, FL starts by telling a normal defrost cycle or auxiliary-heat run from one that is a fault. Kendall almost never freezes: fewer than one day a year has a low of 32°F or colder (NOAA 1991–2020 normals, station 5 miles away). Half the homes in Kendall were built before 1978 (Census ACS 2019–2023). A split heat pump made since January 1, 2023 must rate at least 14.3 SEER2 and 7.5 HSPF2, a federal floor that does not change from state to state.

(888) 217-3739

Florida contractors. No obligation for the call.

The year in Kendall—cooling runs nearly all year
The year in Kendall. cooling runs nearly all year. There is no month when both systems are idle. JFMAMJJASOND
heatingcooling0 days below freezing · July dew point 74°F
A technician checking the coil of an outdoor heat pump in winter
The top grille off, frost across the coil. A heat pump melts that off on a schedule of its own, which looks like a fault and is not.

A heat pump blowing air that feels cool in winter is usually working as designed, and a heat pump that sits on auxiliary heat for hours in mild weather usually is not. Say what the thermostat is showing and a heating and cooling contractor can come out to Kendall and tell the two apart.

A heat pump in Kendall spends the year on the cooling side, and the heating side is a handful of mornings. What a no-heat call means here depends on what else is in the house: where there is a furnace, the heat pump has something to hand the load to, and where there is none — and in this climate plenty of houses have none — the only thing behind it is a bank of electric resistance strips. That is the first thing a technician establishes, because there is no second appliance to switch to.

Sizing here runs the opposite way from a cold climate: the cooling load sets the size, exactly as it would for an air conditioner, because it is the load that exists for most of the year — which is correct, and it also means that on the handful of genuinely cold mornings the machine runs without stopping and the strips carry what it cannot. A machine running continuously on a cold morning is doing its job, not failing at it.

A heat pump has to be sized for two different jobs, and in a July this wet the two pull in opposite directions. Size it for the coldest night and it is too large for the cooling season: it drops the temperature, shuts off, and never runs long enough to pull water out of the air, so the thermostat reads 74°F and the house still feels damp. That is where a single-stage machine runs out of options, and it is the argument for a compressor that modulates rather than one that is simply larger — long, slow run cycles are what dehumidify. Ask what the sizing was based on: a measurement of the house, with the heating load and the cooling load worked out separately.

Kendall, FL in numbers

Days a year with a low of 32°F or colder0NOAA 1991–2020 normals, station 5 miles away
Days a year with a low of 20°F or colderfewer than oneNOAA 1991–2020 normals
Average July dew point74°FPRISM 1991–2020 normals
Median year homes were built1978Census ACS 2019–2023
Households30,283Census ACS 2019–2023
CountyMiami-Dade CountyCensus Bureau
Federal minimum for a new split central AC14.3 SEER2 under 45,000 Btu/h (Southeast)DOE, 2023 standard

What the hardware-store fix does and does not do

The filter is the one thing on this list where the store-bought version does real work: a loaded filter starves the indoor coil of air, and a clean one gives that back. What it cannot do is explain a house that is still behind — a furnace with restricted airflow trips its limit switch and announces itself, while a heat pump never makes air hot enough to trip anything: it falls behind, the backup strips make up the difference, and nothing announces anything. That is why a new filter settles nothing on its own: the charge, the defrost control, the reversing valve and the capacitor all sit behind it, and none of those is sold on a shelf.

A technician at an indoor air handler

When to stop and call in Kendall

  • The thermostat sits on auxiliary or emergency heat for hours while it is mild outside.
  • It cools in summer but will not heat, or it heats but will not cool.
  • Refrigerant was added in an earlier season and the system is behaving the same way again.
The license
Held by the contractor, not by this site, and issued where the work happens — Florida licenses at state level, at city level or not at all depending on the trade and the town. Ask for the number and the name it is held under: a trading name and the licensed entity are often not the same.
The figure
Set by the contractor and said before the work starts. This site never quotes and has no part in it. If a technician cannot say what the visit covers before beginning, that is the moment to stop.
The call
Describing what the system is doing commits you to nothing. Nothing is booked until you say so.

What happens on the visit

  1. 01

    The finding, out loud

    What failed, whether it is the fault or a symptom of another one, and whether the repair suits the age of the system. A diagnostic visit is usually charged separately from the repair — ask whether it is credited if the work goes ahead, because that differs from one contractor to the next.

  2. 02

    The repair

    Agreed with the contractor before it starts. Where a part has to be ordered, a technician says so rather than leaving the system apart.

  3. 03

    What happens after

    A system that failed once in a season often fails again in it. Whether that is the same fault or a second one is worth asking while the technician is still there.

Before you call: what to have ready

  1. 01That it is a heat pump, and what the backup is — electric, or a gas furnace on the same ducts, and not knowing is a fair answer.
  2. 02What the thermostat is set to, what it is reading, and whether it shows auxiliary or emergency heat.
  3. 03What the unit outside is doing: iced over, silent, running without stopping, or reversing every few minutes.

Emergency heat is what that setting is for if the house has gone cold, but say on the phone that you switched to it, because it locks out the compressor, and the fault a technician needs to watch stops happening while it is on.

Heat Pumps in Kendall: questions

How cold does Kendall get in winter?

Kendall averages 0 days a year with a low of 32°F or colder and almost none at 20°F or colder, by the 1991–2020 climate normals for a NOAA station 5 miles away. Heating is a handful of mornings here, so a heat pump spends nearly the whole year cooling.

What is the July dew point in Kendall?

The July dew point in Kendall averages 74°F, by the PRISM 1991–2020 climate normals. In air that wet an oversized air conditioner cools the house fast, shuts off before it has dried the air, and leaves rooms cool and clammy, which is why sizing starts with a load calculation for the house.

Is a new R-410A system still allowed in Kendall?

Under federal rules, yes, if the equipment was made or imported before January 1, 2025: an EPA rule that took effect on July 27, 2026 removed the January 1, 2026 installation deadline for that stock. Equipment made since January 1, 2025 is charged with R-454B or R-32 instead, and an outdoor unit built for those is not a listed match for an indoor coil built for R-410A.

Map loads when you reach it

Other services in Kendall

Heat Pumps nearby

Call (888) 217-3739