HeatCoolHQ heatcoolhq.com (888) 217-3739

Exeter, NH

Ductwork and Airflow in Exeter, NH

Ductwork and airflow problems in Exeter, NH show up as one room too hot or too cold while the thermostat says the house is fine. Half the homes in Exeter were built before 1968 (Census ACS 2019–2023), and ducts in houses that age were often added or extended long after they were built. Exeter has an average July dew point of 61°F (PRISM 1991–2020 normals), so moisture is a smaller part of the cooling load here than heat. Where the 2021 International Energy Conservation Code is adopted, a new duct system may leak at most 4 cubic feet of air a minute per 100 square feet of floor area in the test after construction.

(888) 217-3739

New Hampshire contractors. No obligation for the call.

The year in Exeter—heating runs most of the year
The year in Exeter. heating runs most of the year. Between the two seasons there are weeks when neither system runs, which is when a fault goes unnoticed. BELOW FREEZINGBELOW FREEZINGnothing runsJFMAMJJASOND
heatingcoolingbelow freezing143 days below freezing · July dew point 61°F
A technician joining flexible duct to a metal trunk line in a crawl space
Flexible duct being strapped to the trunk line under the floor. What leaves the equipment and what arrives at the register are two different numbers.

A room that never gets comfortable while the rest of the house is fine is usually a duct problem rather than an equipment problem. Name the room, and whether it happens in heating or in cooling, and an independent contractor can come out to Exeter and measure the airflow instead of guessing at it.

Exeter has the long heating season, and that decides which duct problem gets noticed. A weak run is a complaint that lasts a season here, not a bad two weeks in August.

A run that crosses an unheated attic or a vented crawl space carries the warmest air in the house through the coldest air on the property, and the gap is at its widest on the coldest night of the year — the night the far bedroom gets judged. Where the heat comes off a furnace, the supply air is around 120°F to 140°F and the space the run crosses is below freezing. The same joint leaks the same amount in October and in January; what changes is how much heat leaves with it.

A leaking return in an attic or a crawl space pulls outdoor air into the system at the dew point outdoors, and the coil deals with that air before it deals with any room. The heating side pays for the same leak in winter, and no room feels wrong in either season while it happens. Most of what the coil does in this climate is still temperature rather than moisture, so the temperature split measured across it reads mostly as airflow — one reading at the air handler is worth more than an afternoon of opening and closing registers.

Exeter, NH in numbers

Days a year with a low of 32°F or colder143NOAA 1991–2020 normals, station 7 miles away
Days a year with a low of 20°F or colder57NOAA 1991–2020 normals
Average July dew point61°FPRISM 1991–2020 normals
Median year homes were built1968Census ACS 2019–2023
Households4,601Census ACS 2019–2023
CountyRockingham CountyCensus Bureau
Federal minimum for a new split central AC13.4 SEER2 (North region)DOE, 2023 standard

Duct problems do not fix themselves

The cold room is the symptom people call about, and it is the smaller half of the problem. A return that is too small, or a run that has collapsed, raises the pressure the blower works against, and the blower works against it every hour the system runs — in the rooms that are fine as much as in the room that is not.

A technician at an indoor air handler

Signs it is time to call

  • The filter is clean, every register is open, and one room is still wrong.
  • There is a stain on a ceiling under a duct run, or duct insulation that is wet to the touch.
  • Ice on the line at the air handler, or the system shutting itself off and starting again within the hour.
The license
Held by the contractor, not by this site, and issued where the work happens — New Hampshire licenses at state level, at city level or not at all depending on the trade and the town. Ask for the number and the name it is held under: a trading name and the licensed entity are often not the same.
The figure
Set by the contractor and said before the work starts. This site never quotes and has no part in it. If a technician cannot say what the visit covers before beginning, that is the moment to stop.
Coverage
By town, not by region. Exeter and the towns around it, and it shifts with who is taking calls at the hour you ring.

What the visit involves

  1. 01

    The diagnosis

    At the thermostat first, then at the furnace or the condenser, in the order the equipment runs. What the system is doing is established before any part is named.

  2. 02

    The finding, out loud

    What failed, whether it is the fault or a symptom of another one, and whether the repair suits the age of the system. A diagnostic visit is usually charged separately from the repair — ask whether it is credited if the work goes ahead, because that differs from one contractor to the next.

  3. 03

    What happens after

    A system that failed once in a season often fails again in it. Whether that is the same fault or a second one is worth asking while the technician is still there.

What to have ready when you call from Exeter

  1. 01Which rooms are weak, and whether it happens in heating, in cooling, or in both — that one answer narrows it before anybody arrives.
  2. 02The filter size, and how long the one in the slot has been there, and whether any register or damper has been closed.
  3. 03The address and ZIP code, and how a technician reaches the duct — an attic hatch, a crawl space door, or a basement with the runs in the open.

Do not go around opening and closing registers before the visit — a technician measures the system as it actually runs, and one damper moved this morning shifts every reading this afternoon.

Ductwork in Exeter: questions

How old are the homes in Exeter?

Half the homes in Exeter were built before 1968, by the Census Bureau's 2019–2023 American Community Survey. Detached houses make up a good share of the housing. Ducts in houses that age were often added after the house was built, sized for heat rather than for cooling. Manufactured homes are common enough here that a packaged unit outside, feeding a duct under the floor, is worth mentioning on the call.

How humid are summers in Exeter?

The July dew point in Exeter averages 61°F, by the PRISM 1991–2020 climate normals. In air that dry most of the cooling load is heat, and an air conditioner removes little water, so sizing turns on the house and its sun more than on humidity.

Is there a leakage limit for new ducts in Exeter?

The 2021 International Energy Conservation Code allows a new duct system to leak no more than 4 cubic feet of air a minute per 100 square feet of floor area at the post-construction test. Whether that applies depends on the code edition New Hampshire or the town has adopted, and the building department can say which one.

Map loads when you reach it

Other services in Exeter

Ductwork nearby

Call (888) 217-3739