HeatCoolHQ heatcoolhq.com (888) 217-3739

Exeter, NH

AC Replacement and Installation in Exeter, NH

A new air conditioner in Exeter, NH is matched to the house, to the indoor coil and to the refrigerant it will run on. The July dew point in Exeter averages 61°F (PRISM 1991–2020 normals), so moisture is a smaller part of the cooling load here than heat. Half the homes in Exeter were built before 1968 (Census ACS 2019–2023), so in many of them the heating and cooling equipment has been replaced at least once while the ducts and the flue have not. The federal floor for a split central air conditioner made since January 1, 2023 and sold for New Hampshire is 13.4 SEER2, the North region's standard.

(888) 217-3739

New Hampshire contractors. No obligation for the call.

The year in Exeter—heating runs most of the year
The year in Exeter. heating runs most of the year. Between the two seasons there are weeks when neither system runs, which is when a fault goes unnoticed. BELOW FREEZINGBELOW FREEZINGnothing runsJFMAMJJASOND
heatingcoolingbelow freezing143 days below freezing · July dew point 61°F
Two technicians lowering a new condenser onto a concrete pad
A new outdoor unit going down on its pad. Where it stands decides how it is serviced for the next fifteen years, and that is settled once.

An air conditioner that no longer holds the house on a hot afternoon is not automatically finished, and what settles it is age, what failed, and what the system is charged with. Say what year the system went in and what it has started doing, and an independent contractor can come out to Exeter and size the replacement from the house rather than from the box being carried out.

The cooling season in Exeter is short, and that is what makes the age of an air conditioner misleading. A system that cools for ten or twelve weeks a year puts on a fraction of the running hours the same model accumulates in the south, so it can still be cooling years after the date on the equipment suggested it would stop.

The second machine is usually standing in the same cabinet as the first. Where a furnace and the indoor coil share one, they almost always went in on the same day, and a changeout that replaces one and leaves the other means a contractor opens that cabinet twice. A changeout usually takes about one day, and a heating climate leaves eight months in which that day is not an emergency.

Because the same outdoor unit serves either one, the choice between an air conditioner and a heat pump arrives with the replacement rather than later. The nights that decide it are the ones below 20°F, and there are enough of them here to plan for: a heat pump hands the work to electric resistance strips once the outdoor temperature drops far enough, and the electric bill in a cold snap follows whichever of the two is doing the work. The temperature at which the strips take over is a property of the installed system rather than of heat pumps, and a contractor can say what it will be beforehand. Ask what is meant to carry the house through the coldest nights — strips, an existing furnace, or a second stage — and put the question before the contractor picks the model.

Exeter, NH in numbers

Days a year with a low of 32°F or colder143NOAA 1991–2020 normals, station 7 miles away
Days a year with a low of 20°F or colder57NOAA 1991–2020 normals
Average July dew point61°FPRISM 1991–2020 normals
Median year homes were built1968Census ACS 2019–2023
Households4,601Census ACS 2019–2023
CountyRockingham CountyCensus Bureau
Federal minimum for a new split central AC13.4 SEER2 (North region)DOE, 2023 standard

Air conditioners do not fix themselves

A working system does not consume refrigerant. A system that needed more of it in two different seasons has a leak nobody has located, and it will need more again. Each recharge buys one season, and on R-410A it buys that season for more than the last one, because the refrigerant is still made but under a shrinking national production allowance that steps down again in 2029, while the systems that need it stay in service.

A technician at an indoor air handler

When to stop and call in Exeter

  • The compressor hums and then trips the breaker, and resetting it is the one thing you can do that makes it worse.
  • Ice comes back on the line or the coil after you have put a clean filter in.
  • Someone has told you to replace the system without having measured the house.
The license
Held by the contractor, not by this site, and issued where the work happens — New Hampshire licenses at state level, at city level or not at all depending on the trade and the town. Ask for the number and the name it is held under: a trading name and the licensed entity are often not the same.
The figure
Set by the contractor and said before the work starts. This site never quotes and has no part in it. If a technician cannot say what the visit covers before beginning, that is the moment to stop.
The call
Describing what the system is doing commits you to nothing. Nothing is booked until you say so.

What happens on the visit

  1. 01

    The finding, out loud

    What failed, whether it is the fault or a symptom of another one, and whether the repair suits the age of the system. A diagnostic visit is usually charged separately from the repair — ask whether it is credited if the work goes ahead, because that differs from one contractor to the next.

  2. 02

    The repair

    Agreed with the contractor before it starts. Where a part has to be ordered, a technician says so rather than leaving the system apart.

  3. 03

    What happens after

    A system that failed once in a season often fails again in it. Whether that is the same fault or a second one is worth asking while the technician is still there.

Before you call: what to have ready

  1. 01Roughly when the system went in, and what refrigerant it is charged with — the model number is worth having in front of you too.
  2. 02What happens when the system runs — not cooling at all, cooling weakly, running without ever stopping, tripping the breaker, or icing over.
  3. 03What else is in the cabinet with the indoor coil — a furnace, an air handler, nothing you can name — and whether it is the same age.

Find the outdoor data plate and read it before you call — the model number and the refrigerant are printed on it, and those two lines decide most of what follows.

AC Replacement in Exeter: questions

How humid are summers in Exeter?

The July dew point in Exeter averages 61°F, by the PRISM 1991–2020 climate normals. In air that dry most of the cooling load is heat, and an air conditioner removes little water, so sizing turns on the house and its sun more than on humidity.

When were most houses in Exeter built?

Half the homes in Exeter were built before 1968, by the Census Bureau's 2019–2023 American Community Survey. Detached houses make up a good share of the housing. In houses that age the furnace or air conditioner has usually been replaced at least once, and the ducts and the flue are often older than the equipment. Manufactured homes are common enough here that a packaged unit outside, feeding a duct under the floor, is worth mentioning on the call.

Can a contractor in Exeter still install an R-410A system?

Under federal rules, yes, if the equipment was made or imported before January 1, 2025: an EPA rule that took effect on July 27, 2026 removed the January 1, 2026 installation deadline for that stock. Equipment made since January 1, 2025 is charged with R-454B or R-32 instead, and an outdoor unit built for those is not a listed match for an indoor coil built for R-410A.

Map loads when you reach it

Other services in Exeter

AC Replacement nearby

Call (888) 217-3739