Bigfoot, TX
Furnace and Heating Repair in Bigfoot, TX
Furnace and heating repair in Bigfoot, TX starts at the thermostat and follows the equipment through its start-up sequence to the step where it stops. Bigfoot averages 16 days a year with a low of 32°F or colder and about one at 20°F or colder (NOAA 1991–2020 normals, station 11 miles away). Half the homes in Bigfoot were built in 1998 or later (Census ACS 2019–2023). When the gas utility finds a leak or an unsafe furnace it shuts the gas off and tags the appliance, and only a repair brings the gas back.
(888) 217-3739Texas contractors. No obligation for the call.
A system that has stopped making heat on a cold night has one of a short list of faults behind it, and the step where the sequence stops names the part. Say what heats the house, both thermostat numbers — the setting and the reading — and what the equipment is doing, and a heating contractor who covers Bigfoot takes it from there.
In Bigfoot the heating half of the system is the part nobody thinks about, and in a climate like this it is as often as not the same outdoor unit that cools in July, running the other way. People live with a heat pump for years without knowing the machine does both jobs, which is why the first thing worth saying on the phone is which of the two heats the house.
Air from the vents that feels cool in winter is not a fault by itself — a heat pump works on a smaller difference between the room and the air it supplies, and it runs longer cycles to make that up. The test is whether the room gets to the number on the thermostat, and whether the electric strips are doing work the heat pump should be doing: a thermostat set or wired wrong brings them on when the weather never asked for them.
Where July dew points sit at 70°F and above, the indoor coil runs wet for the whole season, and everything it takes out of the air leaves through one drain line. A summer of that grows a film inside the trap and the line, and nobody thinks about a drain on the first cold night: a condensing furnace makes water of its own, in most installations it goes down that same line, and a line that will not take it backs the water up until the pressure switch refuses to close. So a no-heat call in a climate like this can end at the drain rather than at the burner.
Bigfoot, TX in numbers
| Days a year with a low of 32°F or colder | 16 | NOAA 1991–2020 normals, station 11 miles away |
|---|---|---|
| Days a year with a low of 20°F or colder | 1 | NOAA 1991–2020 normals |
| Average July dew point | 70°F | PRISM 1991–2020 normals |
| Median year homes were built | 1998 | Census ACS 2019–2023 |
| Households | 343 | Census ACS 2019–2023 |
| County | Frio County | Census Bureau |
| Federal minimum for a new split central AC | 14.3 SEER2 under 45,000 Btu/h (Southeast) | DOE, 2023 standard |
Why heating faults do not fix themselves
The one fault that changes the conversation entirely is a cracked heat exchanger. It is not a repair question alone — the gas utility red-tags the appliance and shuts the supply off, and it restores the supply only after a licensed contractor has worked on the furnace. The appliance does not come back by flipping a switch, and a tag pulled off the furnace takes the record of what was found with it.
A heating tune-up before the season
A pre-season heating tune-up is the one visit booked on your schedule instead of the furnace's. In Bigfoot it belongs before the first cold night, because the faults that end a winter evening are mostly parts that were already wearing in October: an ignitor near the end of its starts, a flame sensor carrying last season's coating, a filter loaded through the cooling months, a condensate drain that has grown a film.
Signs it is time to call
- There is a tag on the furnace and the gas supply has been shut off.
- The blower runs and the air never warms, or the thermostat is asking for heat while the reading keeps dropping.
- Water is standing at the base of the furnace, or the flue outside has iced over.
- The license
- Held by the contractor, not by this site, and issued where the work happens — Texas licenses at state level, at city level or not at all depending on the trade and the town. Ask for the number and the name it is held under: a trading name and the licensed entity are often not the same.
- The figure
- Set by the contractor and said before the work starts. This site never quotes and has no part in it. If a technician cannot say what the visit covers before beginning, that is the moment to stop.
- The call
- Describing what the system is doing commits you to nothing. Nothing is booked until you say so.
What the visit involves
- 01
The diagnosis
At the thermostat first, then at the furnace or the condenser, in the order the equipment runs. What the system is doing is established before any part is named.
- 02
The finding, out loud
What failed, whether it is the fault or a symptom of another one, and whether the repair suits the age of the system. A diagnostic visit is usually charged separately from the repair — ask whether it is credited if the work goes ahead, because that differs from one contractor to the next.
- 03
What happens after
A system that failed once in a season often fails again in it. Whether that is the same fault or a second one is worth asking while the technician is still there.
What to have ready when you call
- 01What the system is — a furnace, a boiler on radiators or baseboard, or a heat pump with electric backup.
- 02When the system went in, as near as anyone knows, and the model and serial number off the data plate inside the cabinet door — the year is usually in the serial rather than printed as a date.
- 03The two thermostat numbers: the setting, and the reading it shows for the room — and whether the screen is blank, because a thermostat wired without a common wire runs off its battery, and a battery that has gone down looks exactly like a dead furnace.
Do not keep pressing the reset while you wait — each press relights a furnace that shut itself down for a reason, and the lockout it is holding is the first thing a technician reads.
Heating Repair in Bigfoot: questions
How many freezing days does Bigfoot have?
Bigfoot averages 16 days a year with a low of 32°F or colder and 1 at 20°F or colder, by the 1991–2020 climate normals for a NOAA station 11 miles away. Heating is rarely asked for here, so a fault in it can sit unnoticed until the one cold week of the year.
When were most houses in Bigfoot built?
Half the homes in Bigfoot were built in 1998 or later, by the Census Bureau's 2019–2023 American Community Survey. Detached houses make up about half of the housing. Equipment in houses of that age is often on its second set, and the install date on the label decides whether parts are still made. Manufactured homes are common enough here that a packaged unit outside, feeding a duct under the floor, is worth mentioning on the call.
What efficiency does a new gas furnace in Bigfoot need?
The federal minimum for a new non-weatherized gas furnace is an AFUE of 80. A 95 standard is set for furnaces made after December 18, 2028 and is still in court, so a furnace going in now can be an 80 or a condensing model in the 90s.
Other services in Bigfoot
Heating Repair nearby