HeatCoolHQ heatcoolhq.com (888) 217-3739

Bigfoot, TX

Furnace Replacement and Installation in Bigfoot, TX

A new furnace in Bigfoot, TX is sized from the house, its ducts and its winters, not from the rating plate of the one coming out. Bigfoot averages 16 days a year with a low of 32°F or colder and about one at 20°F or colder (NOAA 1991–2020 normals, station 11 miles away). Half the homes in Bigfoot were built in 1998 or later (Census ACS 2019–2023). A gas furnace installed now must reach an AFUE of 80 or more under the federal minimum, while DOE's 95 rule for furnaces made after December 18, 2028 is still being litigated.

(888) 217-3739

Texas contractors. No obligation for the call.

The year in Bigfoot—cooling runs nearly all year
The year in Bigfoot. cooling runs nearly all year. There is no month when both systems are idle. JFMAMJJASOND
heatingcooling16 days below freezing · July dew point 70°F
Two technicians easing a furnace cabinet down a basement stairway
A replacement cabinet coming off the dolly. How the unit gets in is part of the job: a turn in the stairs or a narrow doorway can decide which model fits.

A furnace that has failed once and a furnace on its second service call this season are two different questions. Say roughly when it was installed and what it is doing, and a heating contractor can come out to Bigfoot and answer that before anything is ordered.

Low hours change the way a furnace ends rather than whether it ends. A furnace here stands still more than it runs: a flue that never gets hot enough to dry itself out, condensate sitting in a trap through a warm winter, corrosion working on the burners from the outside in. Corrosion reaches the heat exchanger before cycling would have, and the ending is the same one.

From one house to the next here, the indoor cabinet is not the same thing: a small gas furnace in a closet or out in the garage in one, an air handler with electric resistance strips behind a heat pump in the next. The model number on the data plate settles which, and it settles what the visit is — a furnace changeout and an air handler changeout are not the same piece of work.

The blower comes with the furnace, and it runs in July as well as in January, which makes a changeout here a cooling decision as much as a heating one. In July most of the work is water rather than temperature: a system that cools the air fast, shuts down and leaves the house cold and sticky never ran long enough to dehumidify. Ask what the new blower does at part load, because one that holds a lower airflow for a longer cycle takes more water out of the same house.

Bigfoot, TX in numbers

Days a year with a low of 32°F or colder16NOAA 1991–2020 normals, station 11 miles away
Days a year with a low of 20°F or colder1NOAA 1991–2020 normals
Average July dew point70°FPRISM 1991–2020 normals
Median year homes were built1998Census ACS 2019–2023
Households343Census ACS 2019–2023
CountyFrio CountyCensus Bureau
Federal minimum for a new split central AC14.3 SEER2 under 45,000 Btu/h (Southeast)DOE, 2023 standard

Why furnaces do not fix themselves

Nothing spent on an old furnace transfers to the new one. A large repair on an appliance installed before 2010 buys months rather than years — and if the fault turns out to be the heat exchanger, the gas utility takes the timing out of it altogether: it closes the supply, and the supply comes back only after a licensed contractor has worked on the appliance.

A technician at an indoor air handler

When to stop and call

  • The gas utility has tagged the furnace and shut the supply off.
  • This is the second service call on the same furnace in one heating season.
  • Flame rolls out of the burner opening, or there is soot around the furnace door.
The figure
Set by the contractor and said before the work starts. This site never quotes and has no part in it. If a technician cannot say what the visit covers before beginning, that is the moment to stop.
The call
Describing what the system is doing commits you to nothing. Nothing is booked until you say so.
Coverage
By town, not by region. Bigfoot and the towns around it, and it shifts with who is taking calls at the hour you ring.

What the visit involves

  1. 01

    The diagnosis

    At the thermostat first, then at the furnace or the condenser, in the order the equipment runs. What the system is doing is established before any part is named.

  2. 02

    The repair

    Agreed with the contractor before it starts. Where a part has to be ordered, a technician says so rather than leaving the system apart.

  3. 03

    What happens after

    A system that failed once in a season often fails again in it. Whether that is the same fault or a second one is worth asking while the technician is still there.

What to have ready when you call

  1. 01When the furnace went in, roughly, and its model number — the data plate inside the door carries both.
  2. 02What the furnace is doing now — no heat at all, short cycling, a noise that started recently, or burners that light and drop out.
  3. 03Whether cooling runs through the same ductwork, and what the outdoor data plate gives as the refrigerant — R-410A, R-454B or R-22 — and the model number on that unit, which tells a contractor whether it only cools or heats as well.

Have the data plate from inside the furnace door in front of you, because it answers half the call — the year it went in and the model number. And if the gas utility left a tag on the appliance, leave the tag where it is: it names what has to be put right before the gas comes back.

Furnace Replacement in Bigfoot: questions

How many freezing days does Bigfoot have?

Bigfoot averages 16 days a year with a low of 32°F or colder and 1 at 20°F or colder, by the 1991–2020 climate normals for a NOAA station 11 miles away. Heating is rarely asked for here, so a fault in it can sit unnoticed until the one cold week of the year.

How old are the homes in Bigfoot?

Half the homes in Bigfoot were built in 1998 or later, by the Census Bureau's 2019–2023 American Community Survey. Detached houses make up about half of the housing. Equipment in houses of that age is often on its second set, and the install date on the label decides whether parts are still made. Manufactured homes are common enough here that a packaged unit outside, feeding a duct under the floor, is worth mentioning on the call.

How efficient must a new gas furnace be?

A new non-weatherized gas furnace has to reach an AFUE of at least 80 under the federal minimum. DOE has set 95 for furnaces made after December 18, 2028, and that rule is still being fought in court, so a furnace installed now can still be an 80 or a condensing 90-plus.

Map loads when you reach it

Other services in Bigfoot

Furnace Replacement nearby

Call (888) 217-3739