HeatCoolHQ heatcoolhq.com (888) 217-3739

Andrews, TX

Heat Pump Repair and Replacement in Andrews, TX

Heat pump repair in Andrews, TX starts by telling a normal defrost cycle or auxiliary-heat run from one that is a fault. Andrews has, on average, 59 days a year with a low of 32°F or colder and 7 at 20°F or colder (NOAA 1991–2020 normals, station in or next to town). Half the homes in Andrews were built before 1975 (Census ACS 2019–2023). Every split heat pump made since January 1, 2023 has to rate at least 14.3 SEER2 for cooling and 7.5 HSPF2 for heating, the same federal minimum in every state.

(888) 217-3739

Texas contractors. No obligation for the call.

The year in Andrews—cooling leads, heating gets weeks
The year in Andrews. cooling leads, heating gets weeks. Between the two seasons there are weeks when neither system runs, which is when a fault goes unnoticed. nothing runsJFMAMJJASOND
heatingcooling59 days below freezing · July dew point 59°F
A technician checking the coil of an outdoor heat pump in winter
The top grille off, frost across the coil. A heat pump melts that off on a schedule of its own, which looks like a fault and is not.

Air that feels cool at the vents in winter is usually the heat pump working as designed, and a heat pump that sits on auxiliary heat for hours in mild weather usually is not. Say what the thermostat reads and a heating and cooling contractor can come out to Andrews and tell the two apart.

A heat pump in Andrews works most of its hours as an air conditioner, and the heating side runs for a few weeks rather than a season. That shapes which faults get noticed, and when: anything wrong with cooling shows up in July with the whole house paying attention, while anything wrong with heating waits for the first cold week of the year to announce itself.

A gas furnace and a heat pump deliver heat at different temperatures, and the gap is wide. A heat pump supplies air nearer 95°F where a gas furnace supplies it nearer 130°F, and air that arrives near skin temperature, moving, reads as cool — which is why the complaint arrives every year from houses with nothing wrong. What matters is whether the house reaches the setting, and how long it sits short of it: air that feels cool with the house holding at the setting is the machine working, and air that feels cool with the house still short of it at bedtime is not.

Summer air here holds less water than it does further east, and air that holds less water sheds heat faster once the sun is down. That widens the gap between afternoon and dawn, and in spring and autumn a heat pump answers both ends of it in a single day — cooling in the afternoon, heating before sunrise, with nobody switching anything over. What it costs is hidden in the thermostat: set the heating and cooling numbers close together and the system changes direction several times a day, and every change is the reversing valve moving and the compressor starting again. Ask what the changeover band is set to — it is a setting, not a repair.

Andrews, TX in numbers

Days a year with a low of 32°F or colder59NOAA 1991–2020 normals, station in or next to town
Days a year with a low of 20°F or colder7NOAA 1991–2020 normals
Average July dew point59°FPRISM 1991–2020 normals
Median year homes were built1975Census ACS 2019–2023
Households5,102Census ACS 2019–2023
CountyAndrews CountyCensus Bureau
Federal minimum for a new split central AC14.3 SEER2 under 45,000 Btu/h (Southeast)DOE, 2023 standard

Why heat pumps in Andrews do not fix themselves

The parts that cycle are the ones that go first, and they do not go alone. A run capacitor that has lost capacitance does not shut the compressor down — it raises the current the compressor draws every minute it runs, and the heat that comes with it. A heat pump asks for that on both sides of the year, where an AC only ever runs to cool, so the part that fails at the end of it is not the capacitor. A capacitor is a part; a compressor is a large fraction of the machine, and on a system installed before 2010 that is where the conversation turns to replacement.

A technician at an indoor air handler

When to stop and call in Andrews

  • Ice covers the outdoor coil and the defrost cycles are not clearing it.
  • It cools in summer but will not heat, or it heats but will not cool.
  • The breaker feeding the outdoor unit or the air handler will not stay in.
The figure
Set by the contractor and said before the work starts. This site never quotes and has no part in it. If a technician cannot say what the visit covers before beginning, that is the moment to stop.
The call
Describing what the system is doing commits you to nothing. Nothing is booked until you say so.
Coverage
By town, not by region. Andrews and the towns around it, and it shifts with who is taking calls at the hour you ring.

What a visit in Andrews involves

  1. 01

    The diagnosis

    At the thermostat first, then at the furnace or the condenser, in the order the equipment runs. What the system is doing is established before any part is named.

  2. 02

    The finding, out loud

    What failed, whether it is the fault or a symptom of another one, and whether the repair suits the age of the system. A diagnostic visit is usually charged separately from the repair — ask whether it is credited if the work goes ahead, because that differs from one contractor to the next.

  3. 03

    What happens after

    A system that failed once in a season often fails again in it. Whether that is the same fault or a second one is worth asking while the technician is still there.

Before you call: what to have ready

  1. 01That the system is a heat pump, and what carries the heat when it cannot — electric, or a gas furnace on the same ducts, and not knowing is a fair answer.
  2. 02Both thermostat numbers, and whether the display is showing auxiliary or emergency heat.
  3. 03What the outdoor unit is doing: iced over, silent, running without stopping, or reversing every few minutes.

Emergency heat is what that setting is for if the house has gone cold, but say on the phone that you switched to it, because it locks out the compressor, and the fault a technician needs to watch stops happening while it is on.

Heat Pumps in Andrews: questions

How cold does Andrews get in winter?

Andrews averages 59 days a year with a low of 32°F or colder and 7 at 20°F or colder, by the 1991–2020 climate normals for the NOAA station in or next to town. Cooling sizes the equipment here, and the few cold mornings are when the backup heat comes on.

What is the July dew point in Andrews?

The July dew point in Andrews averages 59°F, by the PRISM 1991–2020 climate normals. In air that dry most of the cooling load is heat, and an air conditioner removes little water, so sizing turns on the house and its sun more than on humidity.

What efficiency does a new heat pump need in Andrews?

A split heat pump made since January 1, 2023 has to rate at least 14.3 SEER2 for cooling and 7.5 HSPF2 for heating under the federal standard, and the minimum is the same in every state, Texas included. A contractor can quote above the minimum; the rating is on the unit's label and on the AHRI certificate for the matched pair.

Map loads when you reach it

Other services in Andrews

Heat Pumps nearby

Call (888) 217-3739