Andrews, TX
Ductwork and Airflow in Andrews, TX
Ductwork in Andrews, TX decides whether a furnace or air conditioner delivers what it is rated for, room by room. Half the homes in Andrews were built before 1975 (Census ACS 2019–2023). The July dew point in Andrews averages 59°F (PRISM 1991–2020 normals), so moisture is a smaller part of the cooling load here than heat. Under the 2021 International Energy Conservation Code, a new duct system may leak no more than 4 cubic feet of air a minute per 100 square feet of floor area at the post-construction test, where the state or town has adopted that edition.
(888) 217-3739Texas contractors. No obligation for the call.
A room that never gets comfortable while the rest of the house is fine is usually a duct problem rather than an equipment problem. Name the room, and whether it happens in heating or in cooling, and an independent contractor can come out to Andrews and measure the airflow instead of guessing at it.
Cooling leads the year in Andrews, and the installer sizes the duct around the cooling load — when it was sized at all. More often than not that works in your favor: a system with a furnace moves less air in heating than it moves in cooling, and a heat pump moves the same air in both, so a run sized to carry the house through August usually carries it through the few cold weeks either way.
The heating season here is short enough that a weak room gets tolerated — a few weeks of a back bedroom nobody sits in, and then it is spring. That same run is the one that will not cool in July, and by then it has been wrong for a year. Usually it is the room at the end of the longest run, which is the one the air reaches last in either season.
A leaking return in an attic or a crawl space pulls outdoor air into the system at the dew point outdoors, and the coil deals with that air before it deals with any room. The heating side pays for the same leak in winter, and no room feels wrong in either season while it happens. Most of what the coil does in this climate is still temperature rather than moisture, so the temperature split measured across it reads mostly as airflow — one reading at the air handler is worth more than an afternoon of opening and closing registers.
Andrews, TX in numbers
| Days a year with a low of 32°F or colder | 59 | NOAA 1991–2020 normals, station in or next to town |
|---|---|---|
| Days a year with a low of 20°F or colder | 7 | NOAA 1991–2020 normals |
| Average July dew point | 59°F | PRISM 1991–2020 normals |
| Median year homes were built | 1975 | Census ACS 2019–2023 |
| Households | 5,102 | Census ACS 2019–2023 |
| County | Andrews County | Census Bureau |
| Federal minimum for a new split central AC | 14.3 SEER2 under 45,000 Btu/h (Southeast) | DOE, 2023 standard |
What the hardware-store fix does and does not do
Duct tape is named after the job it fails at. The cloth-backed roll dries out on a warm duct and releases, usually within a couple of years, and the joint is open again with nothing to show for the afternoon. What holds is mastic brushed on, or foil tape carrying a UL 181 marking on the roll — and both want the joint clean and dry, which is the hard part in a crawl space.
When to stop and call
- The filter is clean, every register is open, and one room is still wrong.
- A return grille whistles or roars, or the filter bows inward when the blower starts.
- Ice on the line at the air handler, or the system shutting itself off and starting again within the hour.
- The license
- Held by the contractor, not by this site, and issued where the work happens — Texas licenses at state level, at city level or not at all depending on the trade and the town. Ask for the number and the name it is held under: a trading name and the licensed entity are often not the same.
- The call
- Describing what the system is doing commits you to nothing. Nothing is booked until you say so.
- Coverage
- By town, not by region. Andrews and the towns around it, and it shifts with who is taking calls at the hour you ring.
What happens on the visit
- 01
The diagnosis
At the thermostat first, then at the furnace or the condenser, in the order the equipment runs. What the system is doing is established before any part is named.
- 02
The repair
Agreed with the contractor before it starts. Where a part has to be ordered, a technician says so rather than leaving the system apart.
- 03
What happens after
A system that failed once in a season often fails again in it. Whether that is the same fault or a second one is worth asking while the technician is still there.
Before you call: what to have ready
- 01Which rooms are weak, and whether it happens in heating, in cooling, or in both — that one answer narrows it before anybody arrives.
- 02The filter size, and how long the one in the slot has been there, and whether any register or damper has been closed.
- 03The address and ZIP code, and what way there is in to the duct — an attic hatch, a crawl space door, or a basement with the runs in the open.
Do not go around opening and closing registers before the visit — a technician measures the system as it actually runs, and one damper moved this morning shifts every reading this afternoon.
Ductwork in Andrews: questions
How old are the homes in Andrews?
Half the homes in Andrews were built before 1975, by the Census Bureau's 2019–2023 American Community Survey. Detached houses make up most of the housing. Equipment in houses of that age is often on its second set, and the install date on the label decides whether parts are still made. Manufactured homes are common enough here that a packaged unit outside, feeding a duct under the floor, is worth mentioning on the call.
What is the July dew point in Andrews?
The July dew point in Andrews averages 59°F, by the PRISM 1991–2020 climate normals. In air that dry most of the cooling load is heat, and an air conditioner removes little water, so sizing turns on the house and its sun more than on humidity.
What efficiency does a new air conditioner need in Andrews?
A new split central air conditioner in Andrews falls under DOE's 2023 standard for the Southeast: at least 14.3 SEER2 below 45,000 Btu/h. The Southeast rule goes by installation, so a unit below the standard may not be connected after January 1, 2023, whenever it was built.