Alice, TX
Furnace and Heating Repair in Alice, TX
Heating repair in Alice, TX comes down to finding the step where the furnace or heat pump stops in its start-up sequence. Alice averages 4 days a year with a low of 32°F or colder and almost none at 20°F or colder (NOAA 1991–2020 normals, station in or next to town). Half the homes in Alice were built before 1976 (Census ACS 2019–2023). When the gas utility finds a leak or an unsafe furnace it shuts the gas off and tags the appliance, and only a repair brings the gas back.
(888) 217-3739Texas contractors. No obligation for the call.
No heat on a cold night comes down to a short list of faults, and the step where the sequence stops names the part. Say what heats the house, both thermostat numbers — the setting and the reading — and what the equipment is doing, and a heating contractor who covers Alice takes it from there.
In Alice the heating half of the system is the part nobody thinks about, and in a climate like this it is as often as not the same outdoor unit that cools in July, running the other way. People live with a heat pump for years without knowing the machine does both jobs, which is why the first thing worth saying on the phone is which of the two heats the house.
Cool-feeling air at the vents in winter is not a fault on its own — a heat pump works on a smaller difference between the room and the air it supplies, and it runs longer cycles to make that up. What matters is whether the room gets to the number on the thermostat, and whether the electric strips are doing work the heat pump should be doing: a thermostat set or wired wrong brings them on when the weather never asked for them.
Where July dew points sit at 70°F and above, the indoor coil runs wet all summer, and everything it pulls out of the air leaves by one drain line. A summer of that grows a film inside the trap and the line, and nobody thinks about a drain on the first cold night: a condensing furnace makes water of its own, in most installations it goes down that same line, and a line that will not take it backs the water up until the pressure switch refuses to close. In a climate like this a no-heat call can end at the drain and never reach the burner.
Alice, TX in numbers
| Days a year with a low of 32°F or colder | 4 | NOAA 1991–2020 normals, station in or next to town |
|---|---|---|
| Days a year with a low of 20°F or colder | fewer than one | NOAA 1991–2020 normals |
| Average July dew point | 72°F | PRISM 1991–2020 normals |
| Median year homes were built | 1976 | Census ACS 2019–2023 |
| Households | 6,062 | Census ACS 2019–2023 |
| County | Jim Wells County | Census Bureau |
| Federal minimum for a new split central AC | 14.3 SEER2 under 45,000 Btu/h (Southeast) | DOE, 2023 standard |
Before you try the store-bought fix
A new filter is the one item from a hardware store that ends a no-heat call outright, and it is fair to say so: a filter loaded solid chokes the return, the heat exchanger cannot put its heat into air that is barely moving, the limit switch opens, and the furnace shuts itself down and short cycles. What a new filter cannot do is prove it was the fault. Where the furnace locks out again within a day of a new one going in, the restriction is somewhere past the filter, and a technician measures the temperature rise across the furnace to find where.
A heating tune-up before the season
A tune-up does not promise a winter without a call, and a visit that finds nothing wrong has still told you the age and condition of the parts that fail first. It is a one-time visit. A service agreement is a separate decision, and booking the first does not require the second.
When to stop and call
- The furnace locks out again within an hour of being reset.
- There is a smell of gas, or a carbon monoxide alarm has gone off — outside first, then the gas utility, then the repair call.
- There is a tag on the furnace and the gas supply has been shut off.
- The figure
- Set by the contractor and said before the work starts. This site never quotes and has no part in it. If a technician cannot say what the visit covers before beginning, that is the moment to stop.
- The call
- Describing what the system is doing commits you to nothing. Nothing is booked until you say so.
- Coverage
- By town, not by region. Alice and the towns around it, and it shifts with who is taking calls at the hour you ring.
What happens on the visit
- 01
The diagnosis
At the thermostat first, then at the furnace or the condenser, in the order the equipment runs. What the system is doing is established before any part is named.
- 02
The finding, out loud
What failed, whether it is the fault or a symptom of another one, and whether the repair suits the age of the system. A diagnostic visit is usually charged separately from the repair — ask whether it is credited if the work goes ahead, because that differs from one contractor to the next.
- 03
The repair
Agreed with the contractor before it starts. Where a part has to be ordered, a technician says so rather than leaving the system apart.
Before you call: what to have ready
- 01What the system is — a furnace, a boiler on radiators or baseboard, or a heat pump with electric backup.
- 02When the system went in, as near as anyone knows, and the model and serial number off the data plate inside the cabinet door — the year is usually in the serial rather than printed as a date.
- 03What it is doing: silent, clicking and stopping, lighting and dropping out, or running with cold air at the vents.
Do not keep pressing the reset while you wait — each press relights a furnace that shut itself down for a reason, and the lockout it is holding is the first thing a technician reads.
Heating Repair in Alice: questions
How many freezing days does Alice have?
Alice averages 4 days a year with a low of 32°F or colder and almost none at 20°F or colder, by the 1991–2020 climate normals for the NOAA station in or next to town. Heating is rarely asked for here, so a fault in it can sit unnoticed until the one cold week of the year.
How old are the homes in Alice?
Half the homes in Alice were built before 1976, by the Census Bureau's 2019–2023 American Community Survey. Detached houses make up most of the housing. Equipment in houses of that age is often on its second set, and the install date on the label decides whether parts are still made.
What efficiency does a new gas furnace in Alice need?
A new non-weatherized gas furnace has to reach an AFUE of at least 80 under the federal minimum. A 95 standard is set for furnaces made after December 18, 2028 and is still in court, so a furnace going in now can be an 80 or a condensing model in the 90s.
Other services in Alice
Heating Repair nearby