HeatCoolHQ heatcoolhq.com (888) 217-3739

Alice, TX

AC Repair in Alice, TX

AC repair in Alice, TX starts at the outdoor unit: whether it runs, and whether the air at the vents is colder than the air going back in. The July dew point in Alice averages 72°F (PRISM 1991–2020 normals), air wet enough that an air conditioner spends much of each cycle pulling water out of it. Half the homes in Alice were built before 1976 (Census ACS 2019–2023). A system made before 2010 may run on R-22, which has not been produced or imported since January 1, 2020; one made from 2010 through 2024 most likely runs on R-410A, which new equipment stopped using on January 1, 2025.

(888) 217-3739

Texas contractors. No obligation for the call.

The year in Alice—cooling runs nearly all year
The year in Alice. cooling runs nearly all year. There is no month when both systems are idle. JFMAMJJASOND
heatingcooling4 days below freezing · July dew point 72°F
A technician with a gauge manifold connected to an outdoor condenser
A gauge manifold on the service ports. Pressure says whether the charge is low, but not where it went, and a recharge without that answer comes back.

An air conditioner that runs without cooling and one that will not start at all are two different faults, and from the thermostat they look the same. Say which of the two is happening and an independent contractor can come out to Alice and settle it at the unit rather than at the thermostat.

Where the machine cooling a house in Alice is a heat pump, it cools exactly the way an AC does — same compressor, same coil, same faults — with one part a cooling-only system does not have.

Nothing in the year here puts the cooling side away for a season, so nothing on the calendar forces a look at it. Further north a furnace gets switched on every October, and that first start is an annual test whether anyone means it as one; a system that is never put away is never tested either. A unit that has stopped cycling off on afternoons it used to handle has lost capacity, and that is the point at which the repair is still a small one.

In July the air here holds enough water that the AC spends much of its run time wringing it out rather than lowering the temperature, and that changes what a fault sounds like. A house that reaches the set temperature and still feels clammy is reporting something real: the system is falling short on the water half of the job, whether from a low charge, too much air moving across the coil, or a unit that satisfies the thermostat before it has taken any water out and shuts off. It changes one of the readings as well. The temperature split across the coil reads lower in a damp house than in a dry one on the same healthy system, because part of the capacity is going into water instead of into the thermometer — so a split that looks weak in Alice is not automatically a weak system, and a technician takes that reading together with what the house feels like rather than instead of it.

Alice, TX in numbers

Days a year with a low of 32°F or colder4NOAA 1991–2020 normals, station in or next to town
Days a year with a low of 20°F or colderfewer than oneNOAA 1991–2020 normals
Average July dew point72°FPRISM 1991–2020 normals
Median year homes were built1976Census ACS 2019–2023
Households6,062Census ACS 2019–2023
CountyJim Wells CountyCensus Bureau
Federal minimum for a new split central AC14.3 SEER2 under 45,000 Btu/h (Southeast)DOE, 2023 standard

Before you try the store-bought fix

The can of refrigerant with sealant in it is the one to leave on the shelf. The sealant is made to harden where it meets air, and inside a system it hardens in the metering device, the filter drier and the recovery equipment — and it does not come back out of a recovery machine, which is why a system that has had it is a harder system to get worked on. Nothing on a can's gauge separates a low charge from a dirty coil, a blocked filter or a restricted metering device, and all four read low on the same needle. A technician weighs the charge in against a measurement instead of adding it until the air feels colder. Refrigerant for a home system is not a retail purchase either: EPA rules restrict the sale of it to certified technicians, and what has turned up on the shelf as a drop-in for R-22 has at times been a flammable hydrocarbon blend.

An AC tune-up before the summer

An AC tune-up in Alice belongs before the first hot week rather than in the middle of it, for the plain reason that every air conditioner in town gets its first hard test on the same afternoon. The parts that give out first — the run capacitor, the contactor, the condenser fan motor — wear through the months they spend idle as much as through the months they spend working.

A technician at an indoor air handler

When to stop and call

  • The breaker has tripped more than once. Resetting it again is the response that makes it worse.
  • There is ice on the copper line or on the indoor coil in hot weather.
  • Water is standing under the indoor unit, or there is a burning smell from either half.
The license
Held by the contractor, not by this site, and issued where the work happens — Texas licenses at state level, at city level or not at all depending on the trade and the town. Ask for the number and the name it is held under: a trading name and the licensed entity are often not the same.
The call
Describing what the system is doing commits you to nothing. Nothing is booked until you say so.
Coverage
By town, not by region. Alice and the towns around it, and it shifts with who is taking calls at the hour you ring.

What the visit involves

  1. 01

    The diagnosis

    At the thermostat first, then at the furnace or the condenser, in the order the equipment runs. What the system is doing is established before any part is named.

  2. 02

    The finding, out loud

    What failed, whether it is the fault or a symptom of another one, and whether the repair suits the age of the system. A diagnostic visit is usually charged separately from the repair — ask whether it is credited if the work goes ahead, because that differs from one contractor to the next.

  3. 03

    The repair

    Agreed with the contractor before it starts. Where a part has to be ordered, a technician says so rather than leaving the system apart.

What to have ready when you call from Alice

  1. 01Which system it is: central air with a furnace, a heat pump, or a ductless mini-split.
  2. 02Both thermostat numbers — what it is set to and what it is reading.
  3. 03What the outdoor unit is doing: silent, humming, fan spinning, or tripping the breaker.

Switch the cooling off at the thermostat and leave the fan running if there is ice anywhere on the system: a technician cannot measure anything through a block of ice. A coil that has iced over takes a few hours to clear with the fan running, and about one day with the system off altogether — which is why the fan stays on.

AC Repair in Alice: questions

How humid are summers in Alice?

The July dew point in Alice averages 72°F, by the PRISM 1991–2020 climate normals. In air that wet an oversized air conditioner cools the house fast, shuts off before it has dried the air, and leaves rooms cool and clammy, which is why sizing starts with a load calculation for the house.

When were most houses in Alice built?

Half the homes in Alice were built before 1976, by the Census Bureau's 2019–2023 American Community Survey. Detached houses make up most of the housing. Equipment in houses of that age is often on its second set, and the install date on the label decides whether parts are still made.

Can a contractor in Alice still install an R-410A system?

Federally, yes, for equipment made or imported before January 1, 2025: the EPA dropped the January 1, 2026 installation deadline for that stock in a rule effective July 27, 2026. Equipment made since January 1, 2025 is charged with R-454B or R-32 instead, and an outdoor unit built for those is not a listed match for an indoor coil built for R-410A.

Map loads when you reach it

Other services in Alice

AC Repair nearby

Call (888) 217-3739