HeatCoolHQ heatcoolhq.com (888) 217-3739

Yorktown, TX

Heat Pump Repair and Replacement in Yorktown, TX

A heat pump in Yorktown, TX works in both seasons, so its repair or replacement starts with how it behaves in each. Yorktown averages 21 days a year with a low of 32°F or colder and about one at 20°F or colder (NOAA 1991–2020 normals, station 12 miles away). Half the homes in Yorktown were built before 1959 (Census ACS 2019–2023), so in many of them the heating and cooling equipment has been replaced at least once while the ducts and the flue have not. The federal minimum for a split heat pump made since January 1, 2023 is 14.3 SEER2 in cooling and 7.5 HSPF2 in heating, nationwide.

(888) 217-3739

Texas contractors. No obligation for the call.

The year in Yorktown—cooling runs nearly all year
The year in Yorktown. cooling runs nearly all year. There is no month when both systems are idle. JFMAMJJASOND
heatingcooling21 days below freezing · July dew point 71°F
A technician checking the coil of an outdoor heat pump in winter
The top grille off, frost across the coil. A heat pump melts that off on a schedule of its own, which looks like a fault and is not.

Air that feels cool at the vents in winter is usually the heat pump working as designed, and a heat pump that sits on auxiliary heat for hours in mild weather usually is not. Say what the thermostat is showing and a heating and cooling contractor can come out to Yorktown and tell the two apart.

In Yorktown the cooling season is the year and the heating season is a handful of mornings. What a no-heat call means here depends on what else the house has: where there is a furnace, the heat pump has something to hand the load to, and where there is none — and in this climate plenty of houses have none — the only thing behind it is a bank of electric resistance strips. That is the first thing a technician establishes, because there is no second appliance to switch to.

That makes the sizing question run the opposite way from a cold climate: the cooling load sets the size, exactly as it would for an air conditioner, because it is the load that exists for most of the year — which is correct, and it also means that on the handful of genuinely cold mornings the machine runs without stopping and the strips carry what it cannot. Continuous running on a cold morning is the machine doing its job, not failing at it.

A heat pump has to be sized for two different jobs, and in a July this wet the two pull in opposite directions. Sized for the coldest night, it is oversized for the cooling season: it drops the temperature, shuts off, and never runs long enough to pull water out of the air, so the thermostat reads 74°F and the house still feels damp. That is where a single-stage machine runs out of options, and it is the argument for a compressor that modulates rather than one that is simply larger — long, slow run cycles are what dehumidify. Ask what the sizing was based on: a measurement of the house, with the heating load and the cooling load worked out separately.

Yorktown, TX in numbers

Days a year with a low of 32°F or colder21NOAA 1991–2020 normals, station 12 miles away
Days a year with a low of 20°F or colder1NOAA 1991–2020 normals
Average July dew point71°FPRISM 1991–2020 normals
Median year homes were built1959Census ACS 2019–2023
Households743Census ACS 2019–2023
CountyDeWitt CountyCensus Bureau
Federal minimum for a new split central AC14.3 SEER2 under 45,000 Btu/h (Southeast)DOE, 2023 standard

Why heat pumps in Yorktown do not fix themselves

A heat pump is unusual in that it can fail without going quiet. A machine low on refrigerant, or one whose defrost control has stopped working, does not stop making heat — it falls behind, and the backup heat fills the gap without being asked. The thermostat still reads what it is set to, so the fault turns up on the electric bill rather than in the house. The same shortfall in cooling is easier to spot, because nothing covers for it — which is why a heat pump often gets diagnosed in summer for something it had been doing all through the heating season.

A technician at an indoor air handler

Signs it is time to call

  • Ice covers the outdoor coil and the defrost cycles are not clearing it.
  • The thermostat sits on auxiliary or emergency heat for hours while it is mild outside.
  • The breaker feeding the outdoor unit or the air handler will not stay in.
The license
Held by the contractor, not by this site, and issued where the work happens — Texas licenses at state level, at city level or not at all depending on the trade and the town. Ask for the number and the name it is held under: a trading name and the licensed entity are often not the same.
The figure
Set by the contractor and said before the work starts. This site never quotes and has no part in it. If a technician cannot say what the visit covers before beginning, that is the moment to stop.
The call
Describing what the system is doing commits you to nothing. Nothing is booked until you say so.

What the visit involves

  1. 01

    The diagnosis

    At the thermostat first, then at the furnace or the condenser, in the order the equipment runs. What the system is doing is established before any part is named.

  2. 02

    The finding, out loud

    What failed, whether it is the fault or a symptom of another one, and whether the repair suits the age of the system. A diagnostic visit is usually charged separately from the repair — ask whether it is credited if the work goes ahead, because that differs from one contractor to the next.

  3. 03

    What happens after

    A system that failed once in a season often fails again in it. Whether that is the same fault or a second one is worth asking while the technician is still there.

What to have ready when you call from Yorktown

  1. 01That it is a heat pump, and what the backup is — electric, or a gas furnace on the same ducts, and not knowing is a fair answer.
  2. 02What the unit outside is doing: iced over, silent, running without stopping, or reversing every few minutes.
  3. 03The address and ZIP code, and how the outdoor unit is reached — a locked gate, a dog or deep snow changes the appointment.

If the house has gone cold, emergency heat is what that setting is for — say on the phone that you switched to it, because it locks out the compressor, and the fault a technician needs to watch stops happening while it is on.

Heat Pumps in Yorktown: questions

How many freezing days does Yorktown have?

Yorktown averages 21 days a year with a low of 32°F or colder and 1 at 20°F or colder, by the 1991–2020 climate normals for a NOAA station 12 miles away. Heating is a handful of mornings here, so a heat pump spends nearly the whole year cooling.

How humid are summers in Yorktown?

The July dew point in Yorktown averages 71°F, by the PRISM 1991–2020 climate normals. In air that wet an oversized air conditioner cools the house fast, shuts off before it has dried the air, and leaves rooms cool and clammy, which is why sizing starts with a load calculation for the house.

Can a contractor in Yorktown still install an R-410A system?

Under federal rules, yes, if the equipment was made or imported before January 1, 2025: an EPA rule that took effect on July 27, 2026 removed the January 1, 2026 installation deadline for that stock. Equipment made since January 1, 2025 is charged with R-454B or R-32 instead, and an outdoor unit built for those is not a listed match for an indoor coil built for R-410A.

Map loads when you reach it

Other services in Yorktown

Heat Pumps nearby

Call (888) 217-3739