HeatCoolHQ heatcoolhq.com (888) 217-3739

Wimberley, TX

Furnace Replacement and Installation in Wimberley, TX

Replacing a furnace in Wimberley, TX starts with sizing the new one to the house rather than copying the label on the old one. Wimberley has, on average, 18 days a year with a low of 32°F or colder and about one at 20°F or colder (NOAA 1991–2020 normals, station 11 miles away). Half the homes in Wimberley were built in 1994 or later (Census ACS 2019–2023). The federal minimum for a new non-weatherized gas furnace is an AFUE of 80, and a 95 standard for furnaces made after December 18, 2028 is still in court.

(888) 217-3739

Texas contractors. No obligation for the call.

The year in Wimberley—cooling runs nearly all year
The year in Wimberley. cooling runs nearly all year. There is no month when both systems are idle. JFMAMJJASOND
heatingcooling18 days below freezing · July dew point 69°F
Two technicians easing a furnace cabinet down a basement stairway
A replacement cabinet coming off the dolly. How the unit gets in is part of the job: a turn in the stairs or a narrow doorway can decide which model fits.

A furnace that has failed once and a furnace on its second service call this season are two different questions. Say when it went in, roughly, and what it is doing now, and a heating contractor can come out to Wimberley and answer that before anything is ordered.

In Wimberley a furnace works a few weeks of the year, and some years barely that. The calendar comes out of the decision first: a changeout takes about one day, and a day without heat here is an inconvenience rather than a risk. So the timing follows the appliance instead of the other way around.

From one house to the next here, the indoor cabinet is not the same thing: a small gas furnace in a closet or out in the garage in one, an air handler with electric resistance strips behind a heat pump in the next. The model number on the data plate settles which, and it settles what the visit is — a furnace changeout and an air handler changeout are not the same piece of work.

In an upflow cabinet the cooling coil sits directly on top of the furnace, and in a summer like this it runs wet for months at a time. Everything it takes out of the air leaves through one drain line, and a blocked line leaves the water one place to go: rust across the top of a heat exchanger is often a story about the cooling season rather than the heating one. It is worth saying on the call, because it changes what a contractor expects to find when the cabinet comes open.

Wimberley, TX in numbers

Days a year with a low of 32°F or colder18NOAA 1991–2020 normals, station 11 miles away
Days a year with a low of 20°F or colder1NOAA 1991–2020 normals
Average July dew point69°FPRISM 1991–2020 normals
Median year homes were built1994Census ACS 2019–2023
Households1,290Census ACS 2019–2023
CountyHays CountyCensus Bureau
Federal minimum for a new split central AC14.3 SEER2 under 45,000 Btu/h (Southeast)DOE, 2023 standard

Why furnaces do not fix themselves

A crack in a heat exchanger does not stay the size it was found at. It opens further on every heating cycle, because heat moves the steel and the crack is where that movement collects.

A technician at an indoor air handler

When to stop and call in Wimberley

  • This is the second service call on the same furnace in one heating season.
  • Flame rolls out of the burner opening, or there is soot around the furnace door.
  • The part it needs is on back order and the furnace was installed before 2010.
The license
Held by the contractor, not by this site, and issued where the work happens — Texas licenses at state level, at city level or not at all depending on the trade and the town. Ask for the number and the name it is held under: a trading name and the licensed entity are often not the same.
The call
Describing what the system is doing commits you to nothing. Nothing is booked until you say so.
Coverage
By town, not by region. Wimberley and the towns around it, and it shifts with who is taking calls at the hour you ring.

What happens on the visit

  1. 01

    The diagnosis

    At the thermostat first, then at the furnace or the condenser, in the order the equipment runs. What the system is doing is established before any part is named.

  2. 02

    The repair

    Agreed with the contractor before it starts. Where a part has to be ordered, a technician says so rather than leaving the system apart.

  3. 03

    What happens after

    A system that failed once in a season often fails again in it. Whether that is the same fault or a second one is worth asking while the technician is still there.

What to have ready when you call from Wimberley

  1. 01When the furnace went in, roughly, and its model number — the data plate inside the door carries both.
  2. 02Whether the gas utility has already been there, and the wording on the tag — the tag usually names the component.
  3. 03Whether the same ductwork also cools the house, and what the outdoor data plate lists as the refrigerant — R-410A, R-454B or R-22 — and the model number on that unit, which tells a contractor whether it only cools or heats as well.

Have the data plate from inside the furnace door in front of you, because it answers half the call — the year it went in and the model number. And if the gas utility left a tag on the appliance, leave the tag where it is: it names what has to be put right before the gas comes back.

Furnace Replacement in Wimberley: questions

How many freezing days does Wimberley have?

Wimberley averages 18 days a year with a low of 32°F or colder and 1 at 20°F or colder, by the 1991–2020 climate normals for a NOAA station 11 miles away. Heating is rarely asked for here, so a fault in it can sit unnoticed until the one cold week of the year.

When were most houses in Wimberley built?

Half the homes in Wimberley were built in 1994 or later, by the Census Bureau's 2019–2023 American Community Survey. Detached houses make up most of the housing. Equipment in houses of that age is often on its second set, and the install date on the label decides whether parts are still made.

What happens if the gas company red-tags a furnace in Wimberley?

The gas utility red-tags a furnace when it finds a leak or an unsafe appliance, and it shuts the gas off to it. The gas stays off until a contractor repairs the fault, and a cracked heat exchanger is often where a red tag turns a repair into a replacement.

Map loads when you reach it

Other services in Wimberley

Furnace Replacement nearby

Call (888) 217-3739