HeatCoolHQ heatcoolhq.com (888) 217-3739

Valley Head, AL

Heat Pump Repair and Replacement in Valley Head, AL

A heat pump in Valley Head, AL works in both seasons, so its repair or replacement starts with how it behaves in each. Valley Head averages 78 days a year with a low of 32°F or colder and 15 at 20°F or colder (NOAA 1991–2020 normals, station in or next to town). Half the homes in Valley Head were built before 1988 (Census ACS 2019–2023). Every split heat pump made since January 1, 2023 has to rate at least 14.3 SEER2 for cooling and 7.5 HSPF2 for heating, the same federal minimum in every state.

(888) 217-3739

Alabama contractors. No obligation for the call.

The year in Valley Head—cooling leads, heating gets weeks
The year in Valley Head. cooling leads, heating gets weeks. Between the two seasons there are weeks when neither system runs, which is when a fault goes unnoticed. nothing runsJFMAMJJASOND
heatingcooling78 days below freezing · July dew point 70°F
A technician checking the coil of an outdoor heat pump in winter
The top grille off, frost across the coil. A heat pump melts that off on a schedule of its own, which looks like a fault and is not.

A heat pump blowing air that feels cool in winter is usually working as designed, and a heat pump that sits on auxiliary heat for hours in mild weather usually is not. Say what the thermostat is showing and a heating and cooling contractor can come out to Valley Head and tell the two apart.

In Valley Head a heat pump spends most of its life as an air conditioner, and the heating side runs for a few weeks rather than a season. That decides which faults get noticed and when: anything wrong with cooling shows up in July with the whole house paying attention, while anything wrong with heating waits for the first cold week of the year to announce itself.

A gas furnace and a heat pump deliver heat at different temperatures, and the gap is wide. A heat pump supplies air nearer 95°F where a gas furnace supplies it nearer 130°F, and air that arrives near skin temperature, moving, reads as cool — which is why the complaint arrives every year from houses with nothing wrong. What matters is whether the house reaches the setting, and how long it sits short of it: air that feels cool with the house holding at the setting is the machine working, and air that feels cool with the house still short of it at bedtime is not.

A heat pump has to be sized for two different jobs, and in a July this wet the two pull in opposite directions. Size it for the coldest night and it is too large for the cooling season: it drops the temperature, shuts off, and never runs long enough to pull water out of the air, so the thermostat reads 74°F and the house still feels damp. This is the point where a single-stage machine runs out of options, and it is the argument for a compressor that modulates rather than one that is simply larger — long, slow run cycles are what dehumidify. Ask what the size was based on: a measurement of the house, with the heating load and the cooling load worked out separately.

Valley Head, AL in numbers

Days a year with a low of 32°F or colder78NOAA 1991–2020 normals, station in or next to town
Days a year with a low of 20°F or colder15NOAA 1991–2020 normals
Average July dew point70°FPRISM 1991–2020 normals
Median year homes were built1988Census ACS 2019–2023
Households271Census ACS 2019–2023
CountyDeKalb CountyCensus Bureau
Federal minimum for a new split central AC14.3 SEER2 under 45,000 Btu/h (Southeast)DOE, 2023 standard

Why heat pumps in Valley Head do not fix themselves

A heat pump is unusual in that it can fail without going quiet. A system low on charge, or one with a defrost control that has quit, does not stop making heat — it falls behind, and the backup heat fills the gap without being asked. The house stays at the setting, so the fault reports itself on the electric bill instead of at the thermostat. The same shortfall in cooling is easier to spot, because nothing covers for it — which is why a heat pump often gets diagnosed in summer for something it had been doing all through the heating season.

A technician at an indoor air handler

When to stop and call in Valley Head

  • The thermostat sits on auxiliary or emergency heat for hours while it is mild outside.
  • It cools in summer but will not heat, or it heats but will not cool.
  • The breaker feeding the outdoor unit or the air handler will not stay in.
The figure
Set by the contractor and said before the work starts. This site never quotes and has no part in it. If a technician cannot say what the visit covers before beginning, that is the moment to stop.
The call
Describing what the system is doing commits you to nothing. Nothing is booked until you say so.
Coverage
By town, not by region. Valley Head and the towns around it, and it shifts with who is taking calls at the hour you ring.

What the visit involves

  1. 01

    The diagnosis

    At the thermostat first, then at the furnace or the condenser, in the order the equipment runs. What the system is doing is established before any part is named.

  2. 02

    The finding, out loud

    What failed, whether it is the fault or a symptom of another one, and whether the repair suits the age of the system. A diagnostic visit is usually charged separately from the repair — ask whether it is credited if the work goes ahead, because that differs from one contractor to the next.

  3. 03

    What happens after

    A system that failed once in a season often fails again in it. Whether that is the same fault or a second one is worth asking while the technician is still there.

Before you call: what to have ready

  1. 01That the system is a heat pump, and what carries the heat when it cannot — electric, or a gas furnace on the same ducts, and not knowing is a fair answer.
  2. 02What the thermostat is set to, what it is reading, and whether it shows auxiliary or emergency heat.
  3. 03The address and ZIP code, and whether the outdoor unit can be reached — a locked gate, a dog or deep snow changes the appointment.

If the house has gone cold, emergency heat is what that setting is for — say on the phone that you switched to it, because it locks out the compressor, and the fault a technician needs to watch stops happening while it is on.

Heat Pumps in Valley Head: questions

How many freezing days does Valley Head have?

Valley Head averages 78 days a year with a low of 32°F or colder and 15 at 20°F or colder, by the 1991–2020 climate normals for the NOAA station in or next to town. Cooling sizes the equipment here, and the few cold mornings are when the backup heat comes on.

How humid are summers in Valley Head?

The July dew point in Valley Head averages 70°F, by the PRISM 1991–2020 climate normals. In air that wet an oversized air conditioner cools the house fast, shuts off before it has dried the air, and leaves rooms cool and clammy, which is why sizing starts with a load calculation for the house.

How efficient must a new heat pump in Valley Head be?

A split heat pump made since January 1, 2023 has to rate at least 14.3 SEER2 for cooling and 7.5 HSPF2 for heating under the federal standard, and the minimum is the same in every state, Alabama included. A contractor can quote above the minimum; the rating is on the unit's label and on the AHRI certificate for the matched pair.

Map loads when you reach it

Other services in Valley Head

Heat Pumps nearby

Call (888) 217-3739