HeatCoolHQ heatcoolhq.com (888) 217-3739

Union, NH

Furnace Replacement and Installation in Union, NH

Replacing a furnace in Union, NH starts with sizing the new one to the house rather than copying the label on the old one. Union has, on average, 156 days a year with a low of 32°F or colder and 70 at 20°F or colder (NOAA 1991–2020 normals, station 12 miles away). Half the homes in Union were built in 2003 or later (Census ACS 2019–2023). The federal minimum for a new non-weatherized gas furnace is an AFUE of 80, and a 95 standard for furnaces made after December 18, 2028 is still in court.

(888) 217-3739

New Hampshire contractors. No obligation for the call.

The year in Union—heating runs most of the year
The year in Union. heating runs most of the year. Between the two seasons there are weeks when neither system runs, which is when a fault goes unnoticed. BELOW FREEZINGBELOW FREEZINGnothing runsJFMAMJJASOND
heatingcoolingbelow freezing156 days below freezing · July dew point 60°F
Two technicians easing a furnace cabinet down a basement stairway
A replacement cabinet coming off the dolly. How the unit gets in is part of the job: a turn in the stairs or a narrow doorway can decide which model fits.

A furnace with one failed part and a furnace on its second service call of the season are asking different questions. Say roughly when it was installed and what it is doing, and a heating contractor can come out to Union and answer that before anything is ordered.

In Union the furnace is the main system, and it works a full season rather than a handful of cold snaps. That is what puts this question on a clock: a furnace here runs up heating cycles faster than the same appliance in a milder place, and the heat exchanger is the part that keeps the count.

Every time the burners light the steel expands, and every time they stop it contracts, and a crack is where that ends. That is not a failed part: the heat exchanger is the body of the machine rather than something bolted to it, and getting at one means stripping the furnace back to its cabinet. By then most of the decision has been made for you.

A changeout is the one visit where a second question is genuinely open, and nights below 20°F come often enough here to put it there: another gas furnace, or a heat pump with the furnace kept behind it. On those nights a heat pump working alone hands the shortfall to electric resistance strips, and the electric bill follows. What a contractor means by dual fuel is keeping the furnace as the backup instead of strips, and the thermostat, the wiring and the gas connection are all apart on changeout day anyway.

Union, NH in numbers

Days a year with a low of 32°F or colder156NOAA 1991–2020 normals, station 12 miles away
Days a year with a low of 20°F or colder70NOAA 1991–2020 normals
Average July dew point60°FPRISM 1991–2020 normals
Median year homes were built2003Census ACS 2019–2023
Households101Census ACS 2019–2023
CountyCarroll CountyCensus Bureau
Federal minimum for a new split central AC13.4 SEER2 (North region)DOE, 2023 standard

Why furnaces do not fix themselves

A cracked heat exchanger does not stay the size it was when somebody found it. Every heating cycle opens it further, because heat moves the steel and the crack is where that movement collects.

A technician at an indoor air handler

Signs it is time to call

  • This is the second service call on the same furnace in one heating season.
  • Flame rolls out of the burner opening, or there is soot around the furnace door.
  • The part it needs is on back order and the furnace was installed before 2010.
The license
Held by the contractor, not by this site, and issued where the work happens — New Hampshire licenses at state level, at city level or not at all depending on the trade and the town. Ask for the number and the name it is held under: a trading name and the licensed entity are often not the same.
The figure
Set by the contractor and said before the work starts. This site never quotes and has no part in it. If a technician cannot say what the visit covers before beginning, that is the moment to stop.
The call
Describing what the system is doing commits you to nothing. Nothing is booked until you say so.

What a visit in Union involves

  1. 01

    The diagnosis

    At the thermostat first, then at the furnace or the condenser, in the order the equipment runs. What the system is doing is established before any part is named.

  2. 02

    The repair

    Agreed with the contractor before it starts. Where a part has to be ordered, a technician says so rather than leaving the system apart.

  3. 03

    What happens after

    A system that failed once in a season often fails again in it. Whether that is the same fault or a second one is worth asking while the technician is still there.

What to have ready when you call from Union

  1. 01Roughly when the furnace was installed, and the model number — the data plate inside the door carries both.
  2. 02Whether the gas utility has been out, and what the tag says word for word — the tag usually names the component.
  3. 03Where the furnace sits and what it vents into — a metal flue into a chimney, or a white plastic pipe through the wall — and whether a water heater shares that chimney, because one left alone on a flue sized for two appliances becomes its own piece of work. The address and ZIP code go with that.

Have the data plate from inside the furnace door in front of you, because it answers half the call — the year it went in and the model number. And if the gas utility left a tag on the appliance, leave the tag where it is: it names what has to be put right before the gas comes back.

Furnace Replacement in Union: questions

How cold does Union get in winter?

Union averages 156 days a year with a low of 32°F or colder and 70 at 20°F or colder, by the 1991–2020 climate normals for a NOAA station 12 miles away. Heating is the main system here, and a furnace that quits in January is an emergency rather than an inconvenience.

How old are the homes in Union?

Half the homes in Union were built in 2003 or later, by the Census Bureau's 2019–2023 American Community Survey. Detached houses make up almost all of the housing. Equipment in houses of that age is often on its second set, and the install date on the label decides whether parts are still made.

Is there still a federal tax credit for a new furnace?

No. The 25C energy efficient home improvement credit ended for equipment installed after December 31, 2025, under the tax law signed on July 4, 2025. A quote that still counts it is out of date; a utility or state rebate is a separate program, and the contractor or the utility can say whether one applies.

Map loads when you reach it

Other services in Union

Furnace Replacement nearby

Call (888) 217-3739