HeatCoolHQ heatcoolhq.com (888) 217-3739

Thompson Springs, UT

Heat Pump Repair and Replacement in Thompson Springs, UT

A heat pump in Thompson Springs, UT works in both seasons, so its repair or replacement starts with how it behaves in each. Thompson Springs averages 138 days a year with a low of 32°F or colder and 59 at 20°F or colder (NOAA 1991–2020 normals, station 15 miles away), and those colder days are when a heat pump leans on its backup heat. A split heat pump made since January 1, 2023 must rate at least 14.3 SEER2 and 7.5 HSPF2, a federal floor that does not change from state to state.

(888) 217-3739

Utah contractors. No obligation for the call.

The year in Thompson Springs—both systems work a real season
The year in Thompson Springs. both systems work a real season. There is no month when both systems are idle. BELOW FREEZINGJFMAMJJASOND
heatingcoolingbelow freezing138 days below freezing · July dew point 41°F
A technician checking the coil of an outdoor heat pump in winter
The top grille off, frost across the coil. A heat pump melts that off on a schedule of its own, which looks like a fault and is not.

A heat pump blowing air that feels cool in winter is usually working as designed, and a heat pump that sits on auxiliary heat for hours in mild weather usually is not. Say what the thermostat reads and a heating and cooling contractor can come out to Thompson Springs and tell the two apart.

Where a furnace and a separate AC are two machines, one can fail and the other carries on: the furnace goes and the cooling still works all summer. A heat pump is both of those machines in one cabinet, so when the compressor goes, heating and cooling go together, and the decision that arrives is not about half a system. In a climate with two real seasons there is also no long off season to put it into — the machine is wanted again within weeks, whichever way the weather is going.

The reversing valve gets tested twice a year, when the machine changes direction — once in autumn and once in spring. A machine that heated all winter and then refuses to cool when the first warm week of May arrives is usually pointing at that valve, or at the control that tells it to move, rather than at the compressor. A spring failure is easy to put off, and that is the trap: the valve that would not move in May is the valve that has to move again in October, and a summer of leaving it alone does not fix it.

Nights below 20°F come often enough here that the auxiliary strips run real hours, so a January bill above October's is the equipment behaving as designed rather than a fault. The version worth knowing about is a failed element inside that bank — several elements share one breaker, so the rest carry on, the house falls behind only on the coldest nights, and the heat pump itself tests fine.

Thompson Springs, UT in numbers

Days a year with a low of 32°F or colder138NOAA 1991–2020 normals, station 15 miles away
Days a year with a low of 20°F or colder59NOAA 1991–2020 normals
Average July dew point41°FPRISM 1991–2020 normals
CountyGrand CountyCensus Bureau
Federal minimum for a new split central AC13.4 SEER2 (North region)DOE, 2023 standard

Before you try the store-bought fix

The small can with a gauge on the top is a car product, and that is not an accident: a homeowner cannot buy R-410A or R-454B over the counter. The EPA restricts sales of those refrigerants to certified technicians, and the exception that keeps the can on the shelf is refrigerant for a car air conditioner. Even where a fitting could be made to work, a technician sets the charge by measurement rather than by a gauge reading — superheat and subcooling, read at the machine, and read differently in heating mode than in cooling. And a working system does not consume refrigerant: a heat pump that needs more of it has a leak, so the work is finding the leak rather than replacing what escaped.

A technician at an indoor air handler

Signs it is time to call

  • Ice covers the outdoor coil and the defrost cycles are not clearing it.
  • The thermostat sits on auxiliary or emergency heat for hours while it is mild outside.
  • It cools in summer but will not heat, or it heats but will not cool.
The license
Held by the contractor, not by this site, and issued where the work happens — Utah licenses at state level, at city level or not at all depending on the trade and the town. Ask for the number and the name it is held under: a trading name and the licensed entity are often not the same.
The figure
Set by the contractor and said before the work starts. This site never quotes and has no part in it. If a technician cannot say what the visit covers before beginning, that is the moment to stop.
The call
Describing what the system is doing commits you to nothing. Nothing is booked until you say so.

What a visit in Thompson Springs involves

  1. 01

    The finding, out loud

    What failed, whether it is the fault or a symptom of another one, and whether the repair suits the age of the system. A diagnostic visit is usually charged separately from the repair — ask whether it is credited if the work goes ahead, because that differs from one contractor to the next.

  2. 02

    The repair

    Agreed with the contractor before it starts. Where a part has to be ordered, a technician says so rather than leaving the system apart.

  3. 03

    What happens after

    A system that failed once in a season often fails again in it. Whether that is the same fault or a second one is worth asking while the technician is still there.

What to have ready when you call from Thompson Springs

  1. 01That it is a heat pump, and what the backup is — electric, or a gas furnace on the same ducts, and not knowing is a fair answer.
  2. 02Both thermostat numbers, and whether the display is showing auxiliary or emergency heat.
  3. 03Roughly what year it went in, and the refrigerant from the outdoor data plate — R-410A on most systems in service, R-454B on recent ones.

Emergency heat is what that setting is for if the house has gone cold, but say on the phone that you switched to it, because it locks out the compressor, and the fault a technician needs to watch stops happening while it is on.

Heat Pumps in Thompson Springs: questions

How many freezing days does Thompson Springs have?

Thompson Springs averages 138 days a year with a low of 32°F or colder and 59 at 20°F or colder, by the 1991–2020 climate normals for a NOAA station 15 miles away. Both seasons are real here, and the coldest weeks are when the backup strips or a furnace carry part of the load.

How humid are summers in Thompson Springs?

The July dew point in Thompson Springs averages 41°F, by the PRISM 1991–2020 climate normals. In air that dry most of the cooling load is heat, and an air conditioner removes little water, so sizing turns on the house and its sun more than on humidity.

Is a new R-410A system still allowed in Thompson Springs?

Under federal rules, yes, if the equipment was made or imported before January 1, 2025: an EPA rule that took effect on July 27, 2026 removed the January 1, 2026 installation deadline for that stock. What has been made since January 1, 2025 runs on R-454B or R-32, and those outdoor units are not a listed match for a coil built for R-410A.

Map loads when you reach it

Other services in Thompson Springs

Heat Pumps nearby

Call (888) 217-3739