HeatCoolHQ heatcoolhq.com (888) 217-3739

Thompson Falls, MT

Ductwork and Airflow in Thompson Falls, MT

Ductwork and airflow problems in Thompson Falls, MT show up as one room too hot or too cold while the thermostat says the house is fine. Half the homes in Thompson Falls were built before 1974 (Census ACS 2019–2023). The July dew point in Thompson Falls averages 47°F (PRISM 1991–2020 normals), dry enough that nearly all of the cooling load is heat rather than moisture. The 2021 International Energy Conservation Code caps leakage from a new duct system at 4 cubic feet a minute per 100 square feet of floor area, tested after construction, wherever that edition is in force.

(888) 217-3739

Montana contractors. No obligation for the call.

The year in Thompson Falls—heating runs most of the year
The year in Thompson Falls. heating runs most of the year. Between the two seasons there are weeks when neither system runs, which is when a fault goes unnoticed. BELOW FREEZINGBELOW FREEZINGnothing runsJFMAMJJASOND
heatingcoolingbelow freezing148 days below freezing · July dew point 47°F
A technician joining flexible duct to a metal trunk line in a crawl space
Flexible duct being strapped to the trunk line under the floor. What leaves the equipment and what arrives at the register are two different numbers.

A room that never gets comfortable while the rest of the house is fine is usually a duct problem rather than an equipment problem. Say which room and in which season, and an independent contractor can come out to Thompson Falls and measure the airflow instead of guessing at it.

Duct laid through an unheated attic or a vented crawl space carries the warmest air in the house through the coldest air on the property, and the gap is at its widest on the coldest night of the year — the night the far bedroom gets judged. Where the heat comes off a furnace, the supply air is around 120°F to 140°F and the space the run crosses is below freezing. A joint leaks the same amount in October as it does in January; what changes is how much heat leaves with it.

A run inside a heated basement leaks into the house rather than out of it, and most of that heat is recovered. The same joint in an unheated attic or a vented crawl space sends it outdoors instead, and it does that every hour of a season this long. Which of the two the house has decides whether a duct leak is a comfort complaint or a heating bill, and where the runs go is worth saying on the phone.

On a heat pump, a duct problem reaches the electric bill before it reaches anyone's comfort: a run that cannot move enough air leaves the house behind the thermostat setting, and the thermostat answers by calling in the resistance strips. The strips warm the house and hide the duct problem in the same motion, which is why nothing looks broken.

Thompson Falls, MT in numbers

Days a year with a low of 32°F or colder148NOAA 1991–2020 normals, station in or next to town
Days a year with a low of 20°F or colder29NOAA 1991–2020 normals
Average July dew point47°FPRISM 1991–2020 normals
Median year homes were built1974Census ACS 2019–2023
Households628Census ACS 2019–2023
CountySanders CountyCensus Bureau
Federal minimum for a new split central AC13.4 SEER2 (North region)DOE, 2023 standard

Why duct problems do not fix themselves

The cold room is the symptom people call about, and it is the smaller half of the problem. A return that is too small, or a run that has collapsed, raises the pressure the blower works against, and the blower works against it every hour the system runs — in the rooms that are fine as much as in the room that is not.

A technician at an indoor air handler

When to stop and call in Thompson Falls

  • A room has never been comfortable since the system was replaced.
  • A return grille whistles or roars, or the filter bows inward when the blower starts.
  • Ice on the line at the air handler, or the system shutting itself off and starting again within the hour.
The license
Held by the contractor, not by this site, and issued where the work happens — Montana licenses at state level, at city level or not at all depending on the trade and the town. Ask for the number and the name it is held under: a trading name and the licensed entity are often not the same.
The figure
Set by the contractor and said before the work starts. This site never quotes and has no part in it. If a technician cannot say what the visit covers before beginning, that is the moment to stop.
The call
Describing what the system is doing commits you to nothing. Nothing is booked until you say so.

What the visit involves

  1. 01

    The finding, out loud

    What failed, whether it is the fault or a symptom of another one, and whether the repair suits the age of the system. A diagnostic visit is usually charged separately from the repair — ask whether it is credited if the work goes ahead, because that differs from one contractor to the next.

  2. 02

    The repair

    Agreed with the contractor before it starts. Where a part has to be ordered, a technician says so rather than leaving the system apart.

  3. 03

    What happens after

    A system that failed once in a season often fails again in it. Whether that is the same fault or a second one is worth asking while the technician is still there.

What to have ready when you call from Thompson Falls

  1. 01Which rooms are weak, and whether it happens in heating, in cooling, or in both — that one answer narrows it before anybody arrives.
  2. 02The filter size, and how long the one in the slot has been there, and whether any register or damper has been closed.
  3. 03The address and ZIP code, and what way there is in to the duct — an attic hatch, a crawl space door, or a basement with the runs in the open.

Leave the registers and dampers where they are before the visit — a technician measures the system as it actually runs, and one damper moved this morning shifts every reading this afternoon.

Ductwork in Thompson Falls: questions

When were most houses in Thompson Falls built?

Half the homes in Thompson Falls were built before 1974, by the Census Bureau's 2019–2023 American Community Survey. Detached houses make up most of the housing. Equipment in houses of that age is often on its second set, and the install date on the label decides whether parts are still made. Manufactured homes are common enough here that a packaged unit outside, feeding a duct under the floor, is worth mentioning on the call.

What is the July dew point in Thompson Falls?

The July dew point in Thompson Falls averages 47°F, by the PRISM 1991–2020 climate normals. In air that dry most of the cooling load is heat, and an air conditioner removes little water, so sizing turns on the house and its sun more than on humidity.

How much may a new duct system leak in Thompson Falls?

The 2021 International Energy Conservation Code allows a new duct system to leak no more than 4 cubic feet of air a minute per 100 square feet of floor area at the post-construction test. Whether that applies depends on the code edition Montana or the town has adopted, and the building department can say which one.

Map loads when you reach it

Other services in Thompson Falls

Ductwork nearby

Call (888) 217-3739