HeatCoolHQ heatcoolhq.com (888) 217-3739

Smelterville, ID

Ductwork and Airflow in Smelterville, ID

Ductwork in Smelterville, ID decides whether a furnace or air conditioner delivers what it is rated for, room by room. Half the homes in Smelterville were built before 1947 (Census ACS 2019–2023), and ducts in houses that age were often added or extended long after they were built. Smelterville has an average July dew point of 47°F (PRISM 1991–2020 normals), dry enough that nearly all of the cooling load is heat rather than moisture. Where the 2021 International Energy Conservation Code is adopted, a new duct system may leak at most 4 cubic feet of air a minute per 100 square feet of floor area in the test after construction.

(888) 217-3739

Idaho contractors. No obligation for the call.

The year in Smelterville—heating runs most of the year
The year in Smelterville. heating runs most of the year. Between the two seasons there are weeks when neither system runs, which is when a fault goes unnoticed. BELOW FREEZINGBELOW FREEZINGnothing runsJFMAMJJASOND
heatingcoolingbelow freezing147 days below freezing · July dew point 47°F
A technician joining flexible duct to a metal trunk line in a crawl space
Flexible duct being strapped to the trunk line under the floor. What leaves the equipment and what arrives at the register are two different numbers.

One room that is always wrong while the thermostat says the house is fine usually points at the duct rather than at the equipment. Say which room and in which season, and an independent contractor can come out to Smelterville and measure the airflow instead of guessing at it.

Duct laid through an unheated attic or a vented crawl space carries the warmest air in the house through the coldest air on the property, and the gap is at its widest on the coldest night of the year — the night the far bedroom gets judged. Where the heat comes off a furnace, the supply air is around 120°F to 140°F and the space the run crosses is below freezing. The same joint leaks the same amount in October and in January; what changes is how much heat leaves with it.

A run inside a heated basement leaks into the house rather than out of it, and most of that heat is recovered. Put the same joint in an unheated attic or a vented crawl space and it goes outdoors instead, and it does that every hour of a season this long. Which of the two the house has decides whether a duct leak is a comfort complaint or a heating bill, and where the runs go is worth saying on the phone.

Where a heat pump carries the winter, a duct problem shows up on the electric bill before it shows up as a cold room: a run that cannot move enough air leaves the house behind the thermostat setting, and the thermostat answers by calling in the resistance strips. The strips make the house warm and make the duct problem invisible at the same time, which is why nothing looks broken.

Smelterville, ID in numbers

Days a year with a low of 32°F or colder147NOAA 1991–2020 normals, station 3 miles away
Days a year with a low of 20°F or colder33NOAA 1991–2020 normals
Average July dew point47°FPRISM 1991–2020 normals
Median year homes were built1947Census ACS 2019–2023
Households313Census ACS 2019–2023
CountyShoshone CountyCensus Bureau
Federal minimum for a new split central AC13.4 SEER2 (North region)DOE, 2023 standard

What the hardware-store fix does and does not do

Duct tape is named for the one job it does not hold. On a warm duct the cloth-backed roll dries out and lets go, usually inside a couple of years, and the joint is open again with nothing to show for the afternoon. What holds is mastic brushed on, or foil tape carrying a UL 181 marking on the roll — and both want the joint clean and dry, which is the hard part in a crawl space.

A technician at an indoor air handler

When to stop and call

  • A return grille whistles or roars, or the filter bows inward when the blower starts.
  • There is a stain on a ceiling under a duct run, or duct insulation that is wet to the touch.
  • Ice on the line at the air handler, or the system shutting itself off and starting again within the hour.
The license
Held by the contractor, not by this site, and issued where the work happens — Idaho licenses at state level, at city level or not at all depending on the trade and the town. Ask for the number and the name it is held under: a trading name and the licensed entity are often not the same.
The figure
Set by the contractor and said before the work starts. This site never quotes and has no part in it. If a technician cannot say what the visit covers before beginning, that is the moment to stop.
Coverage
By town, not by region. Smelterville and the towns around it, and it shifts with who is taking calls at the hour you ring.

What the visit involves

  1. 01

    The finding, out loud

    What failed, whether it is the fault or a symptom of another one, and whether the repair suits the age of the system. A diagnostic visit is usually charged separately from the repair — ask whether it is credited if the work goes ahead, because that differs from one contractor to the next.

  2. 02

    The repair

    Agreed with the contractor before it starts. Where a part has to be ordered, a technician says so rather than leaving the system apart.

  3. 03

    What happens after

    A system that failed once in a season often fails again in it. Whether that is the same fault or a second one is worth asking while the technician is still there.

What to have ready when you call

  1. 01Which rooms are weak, and whether it happens in heating, in cooling, or in both — that one answer narrows it before anybody arrives.
  2. 02The filter size, and how long the one in the slot has been there, and whether any register or damper has been closed.
  3. 03The address and ZIP code, and what way there is in to the duct — an attic hatch, a crawl space door, or a basement with the runs in the open.

Do not go around opening and closing registers before the visit — a technician measures the system as it actually runs, and one damper moved this morning shifts every reading this afternoon.

Ductwork in Smelterville: questions

When were most houses in Smelterville built?

Half the homes in Smelterville were built before 1947, by the Census Bureau's 2019–2023 American Community Survey. Detached houses make up most of the housing. Ducts in houses that age were often added after the house was built, sized for heat rather than for cooling. Manufactured homes are common enough here that a packaged unit outside, feeding a duct under the floor, is worth mentioning on the call.

What is the July dew point in Smelterville?

The July dew point in Smelterville averages 47°F, by the PRISM 1991–2020 climate normals. In air that dry most of the cooling load is heat, and an air conditioner removes little water, so sizing turns on the house and its sun more than on humidity.

How efficient must a new air conditioner in Smelterville be?

A new split central air conditioner in Smelterville falls under DOE's 2023 standard for the North: at least 13.4 SEER2. In the North the rule follows the date of manufacture, so a unit made earlier to the old standard can still be installed.

Map loads when you reach it

Other services in Smelterville

Ductwork nearby

Call (888) 217-3739