HeatCoolHQ heatcoolhq.com (888) 217-3739

Smeltertown, CO

Furnace Replacement and Installation in Smeltertown, CO

Replacing a furnace in Smeltertown, CO starts with sizing the new one to the house rather than copying the label on the old one. Smeltertown averages 201 days a year with a low of 32°F or colder and 104 at 20°F or colder (NOAA 1991–2020 normals, station in or next to town). Half the homes in Smeltertown were built before 1986 (Census ACS 2019–2023). The federal minimum for a new non-weatherized gas furnace is an AFUE of 80, and a 95 standard for furnaces made after December 18, 2028 is still in court.

(888) 217-3739

Colorado contractors. No obligation for the call.

The year in Smeltertown—heating runs most of the year
The year in Smeltertown. heating runs most of the year. Between the two seasons there are weeks when neither system runs, which is when a fault goes unnoticed. BELOW FREEZINGBELOW FREEZINGnothing runsJFMAMJJASOND
heatingcoolingbelow freezing201 days below freezing · July dew point 44°F
Two technicians easing a furnace cabinet down a basement stairway
A replacement cabinet coming off the dolly. How the unit gets in is part of the job: a turn in the stairs or a narrow doorway can decide which model fits.

A furnace with one failed part and a furnace on its second service call of the season are asking different questions. Say roughly when it was installed and what it is doing, and a heating contractor can come out to Smeltertown and answer that before anything is ordered.

The steel expands every time the burners light and contracts every time they stop, and a crack is where that ends. A crack is not a part failure: the heat exchanger is the body of the machine rather than something bolted to it, and getting at one means stripping the furnace back to its cabinet. By then most of the decision has been made for you.

Which is why the month matters more here than almost anywhere. A changeout takes about one day, and for part of that day the house has no heat — an ordinary afternoon in September, a different proposition in January. A furnace that came through last winter on two repairs is worth raising in spring rather than in February.

In this climate a furnace makes a dry house drier, and the older the appliance the more of it there is: a natural-draft furnace burns room air, and the house draws outside air in to replace it, and the outside air here is drier still. A sealed-combustion furnace brings its air in through its own pipe from outdoors and stops using the house as the supply. Dry air feels colder than the thermostat says, and the setting goes up to answer it, which puts hours on a furnace that has them counted already. If a humidifier is wanted, a contractor plumbs it onto the ductwork during the same visit, because the plenum is already open.

Smeltertown, CO in numbers

Days a year with a low of 32°F or colder201NOAA 1991–2020 normals, station in or next to town
Days a year with a low of 20°F or colder104NOAA 1991–2020 normals
Average July dew point44°FPRISM 1991–2020 normals
Median year homes were built1986Census ACS 2019–2023
Households43Census ACS 2019–2023
CountyChaffee CountyCensus Bureau
Federal minimum for a new split central AC13.4 SEER2 (North region)DOE, 2023 standard

What the hardware-store fix does and does not do

A fresh filter is the one thing off the shelf that genuinely does something, and it is worth being exact about what it reaches. A loaded filter chokes the air moving across the heat exchanger until the limit switch opens on temperature, and from the hallway that looks like a furnace that has died. A technician rules that out first as well, along with a flame sensor filmed over enough to make the burners light, drop out a few seconds later, try again, and lock out on the third attempt. A furnace that has had both done and still stops has stopped being a parts question.

A technician at an indoor air handler

Signs it is time to call

  • The gas utility has tagged the furnace and shut the supply off.
  • This is the second service call on the same furnace in one heating season.
  • The part it needs is on back order and the furnace was installed before 2010.
The license
Held by the contractor, not by this site, and issued where the work happens — Colorado licenses at state level, at city level or not at all depending on the trade and the town. Ask for the number and the name it is held under: a trading name and the licensed entity are often not the same.
The figure
Set by the contractor and said before the work starts. This site never quotes and has no part in it. If a technician cannot say what the visit covers before beginning, that is the moment to stop.
The call
Describing what the system is doing commits you to nothing. Nothing is booked until you say so.

What a visit in Smeltertown involves

  1. 01

    The diagnosis

    At the thermostat first, then at the furnace or the condenser, in the order the equipment runs. What the system is doing is established before any part is named.

  2. 02

    The finding, out loud

    What failed, whether it is the fault or a symptom of another one, and whether the repair suits the age of the system. A diagnostic visit is usually charged separately from the repair — ask whether it is credited if the work goes ahead, because that differs from one contractor to the next.

  3. 03

    The repair

    Agreed with the contractor before it starts. Where a part has to be ordered, a technician says so rather than leaving the system apart.

Before you call: what to have ready

  1. 01When the furnace went in, roughly, and its model number — the data plate inside the door carries both.
  2. 02Whether cooling runs through the same ductwork, and what the outdoor data plate gives as the refrigerant — R-410A, R-454B or R-22 — and the model number on that unit, which tells a contractor whether it only cools or heats as well.
  3. 03Where the furnace sits and what it vents into — a metal flue into a chimney, or a white plastic pipe through the wall — and whether a water heater shares that chimney, because one left alone on a flue sized for two appliances becomes its own piece of work. The address and ZIP code go with that.

The data plate inside the furnace door answers half the call, so have it in front of you — the year it went in and the model number. And if the gas utility left a tag on the appliance, leave the tag where it is: it names what has to be put right before the gas comes back.

Furnace Replacement in Smeltertown: questions

How many freezing days does Smeltertown have?

Smeltertown averages 201 days a year with a low of 32°F or colder and 104 at 20°F or colder, by the 1991–2020 climate normals for the NOAA station in or next to town. Heating is the main system here, and a furnace that quits in January is an emergency rather than an inconvenience.

When were most houses in Smeltertown built?

Half the homes in Smeltertown were built before 1986, by the Census Bureau's 2019–2023 American Community Survey. Detached houses make up some of the housing. Equipment in houses of that age is often on its second set, and the install date on the label decides whether parts are still made. Manufactured homes are common enough here that a packaged unit outside, feeding a duct under the floor, is worth mentioning on the call.

What happens if the gas company red-tags a furnace in Smeltertown?

The gas utility red-tags a furnace when it finds a leak or an unsafe appliance, and it shuts the gas off to it. The gas stays off until a contractor repairs the fault, and a cracked heat exchanger is often where a red tag turns a repair into a replacement.

Map loads when you reach it

Other services in Smeltertown

Furnace Replacement nearby

Call (888) 217-3739