HeatCoolHQ heatcoolhq.com (888) 217-3739

Seattle, WA

Ductwork and Airflow in Seattle, WA

Ductwork in Seattle, WA decides whether a furnace or air conditioner delivers what it is rated for, room by room. Half the homes in Seattle were built before 1974 (Census ACS 2019–2023). The July dew point in Seattle averages 54°F (PRISM 1991–2020 normals), so moisture is a smaller part of the cooling load here than heat. Where the 2021 International Energy Conservation Code is adopted, a new duct system may leak at most 4 cubic feet of air a minute per 100 square feet of floor area in the test after construction.

(888) 217-3739

Washington contractors. No obligation for the call.

The year in Seattle—cooling runs nearly all year
The year in Seattle. cooling runs nearly all year. There is no month when both systems are idle. JFMAMJJASOND
heatingcooling25 days below freezing · July dew point 54°F
A technician joining flexible duct to a metal trunk line in a crawl space
Flexible duct being strapped to the trunk line under the floor. What leaves the equipment and what arrives at the register are two different numbers.

A room that never gets comfortable while the rest of the house is fine is usually a duct problem rather than an equipment problem. Name the room, and whether it happens in heating or in cooling, and an independent contractor can come out to Seattle and measure the airflow instead of guessing at it.

The system in Seattle runs nearly all year, so duct leakage here is a standing loss rather than a seasonal one. There is also no quiet month in which the system can sit idle while somebody opens the duct up, which is why a contractor books this work around the weather rather than after it.

Where a run crosses a vented attic, the attic is the hostile part: it sits far above the outdoor temperature through the middle of the day, and a supply run crossing it arrives at the register warmer than it left the coil. That is not a leak and nothing is broken — it is the tail of the run undoing part of the cooling, which is why the far room is the one that never quite gets there.

Salt air this close to the ocean works on everything outside, and on the duct side it matters where a return opens into a vented crawl space or a garage — the damp, salty air it draws in reaches the coil and the drain pan before it reaches any room.

Seattle, WA in numbers

Days a year with a low of 32°F or colder25NOAA 1991–2020 normals, station 6 miles away
Days a year with a low of 20°F or colder1NOAA 1991–2020 normals
Average July dew point54°FPRISM 1991–2020 normals
Median year homes were built1974Census ACS 2019–2023
Households353,019Census ACS 2019–2023
CountyKing CountyCensus Bureau
Federal minimum for a new split central AC13.4 SEER2 (North region)DOE, 2023 standard

What the store-bought fix actually does

Shutting the registers in unused rooms feels like it should send the air somewhere useful. The air does not move to the weak room, it raises the pressure in the duct, and higher pressure pushes more of it out through every leak the system already has. Easing one register in a room that overshoots is a different thing, and that is what a damper does — the difference is one adjustment against half the house closed off. A booster fan at a register moves air only where the run behind it is sound, and on a run that is leaking or pulled off its collar it changes nothing.

A technician at an indoor air handler

When to stop and call in Seattle

  • A room has never been comfortable since the system was replaced.
  • There is a stain on a ceiling under a duct run, or duct insulation that is wet to the touch.
  • Ice on the line at the air handler, or the system shutting itself off and starting again within the hour.
The license
Held by the contractor, not by this site, and issued where the work happens — Washington licenses at state level, at city level or not at all depending on the trade and the town. Ask for the number and the name it is held under: a trading name and the licensed entity are often not the same.
The figure
Set by the contractor and said before the work starts. This site never quotes and has no part in it. If a technician cannot say what the visit covers before beginning, that is the moment to stop.
Coverage
By town, not by region. Seattle and the towns around it, and it shifts with who is taking calls at the hour you ring.

What the visit involves

  1. 01

    The finding, out loud

    What failed, whether it is the fault or a symptom of another one, and whether the repair suits the age of the system. A diagnostic visit is usually charged separately from the repair — ask whether it is credited if the work goes ahead, because that differs from one contractor to the next.

  2. 02

    The repair

    Agreed with the contractor before it starts. Where a part has to be ordered, a technician says so rather than leaving the system apart.

  3. 03

    What happens after

    A system that failed once in a season often fails again in it. Whether that is the same fault or a second one is worth asking while the technician is still there.

What to have ready when you call

  1. 01Which rooms are wrong, and whether it is in heating, in cooling, or both — that one answer narrows it before anybody arrives.
  2. 02What the system is — furnace, heat pump, or a furnace with cooling added — and roughly when it was installed, and whether the installer replaced the duct with it or left it in place.
  3. 03The address and ZIP code, and how a technician reaches the duct — an attic hatch, a crawl space door, or a basement with the runs in the open.

Leave the registers and dampers where they are before the visit — a technician measures the system as it actually runs, and one damper moved this morning shifts every reading this afternoon.

Ductwork in Seattle: questions

How old are the homes in Seattle?

Half the homes in Seattle were built before 1974, by the Census Bureau's 2019–2023 American Community Survey. Detached houses make up a good share of the housing. Equipment in houses of that age is often on its second set, and the install date on the label decides whether parts are still made.

What is the July dew point in Seattle?

The July dew point in Seattle averages 54°F, by the PRISM 1991–2020 climate normals. In air that dry most of the cooling load is heat, and an air conditioner removes little water, so sizing turns on the house and its sun more than on humidity.

Is there a leakage limit for new ducts in Seattle?

The 2021 International Energy Conservation Code allows a new duct system to leak no more than 4 cubic feet of air a minute per 100 square feet of floor area at the post-construction test. Whether that applies depends on the code edition Washington or the town has adopted, and the building department can say which one.

Map loads when you reach it

Other services in Seattle

Ductwork nearby

Call (888) 217-3739