HeatCoolHQ heatcoolhq.com (888) 217-3739

Poteet, TX

Furnace and Heating Repair in Poteet, TX

Furnace repair in Poteet, TX begins with what the system does when the thermostat calls for heat, and where in that sequence it quits. Poteet averages 20 days a year with a low of 32°F or colder and about one at 20°F or colder (NOAA 1991–2020 normals, station in or next to town). Half the homes in Poteet were built before 1974 (Census ACS 2019–2023). A gas utility that finds a leak or an unsafe furnace shuts off the gas and tags the appliance, and the gas stays off until a contractor repairs the fault.

(888) 217-3739

Texas contractors. No obligation for the call.

The year in Poteet—cooling runs nearly all year
The year in Poteet. cooling runs nearly all year. There is no month when both systems are idle. JFMAMJJASOND
heatingcooling20 days below freezing · July dew point 70°F
A technician with a meter at the open panel of a gas furnace
A meter at the burner assembly with the panel off. The ignition sequence runs in a fixed order, and the step where it stops is what names the part.

A system that has stopped making heat on a cold night has one of a short list of faults behind it, and the step where the sequence stops names the part. Say what heats the house, what the thermostat is asking for against what it says the room is, and what the equipment is actually doing, and a heating contractor who covers Poteet takes it from there.

The heating half of the system is the part nobody in Poteet thinks about, and in a climate like this it is as often as not the same outdoor unit that cools in July, running the other way. A household can live with a heat pump for years without knowing the machine does both jobs, which is why the first thing worth saying on the phone is which of the two heats the house.

Where a heat pump does the heating, no heat usually means it stopped heating rather than stopped running. The reversing valve is what decides which job the machine is doing, and one that sticks leaves an outdoor unit sounding normal and air at the registers that never warms. Where the heating comes from a small gas furnace instead, the list is the familiar one: flame sensor, ignitor, pressure switch, limit switch.

Where July dew points sit at 70°F and above, the indoor coil runs wet for the whole season, and everything it takes out of the air leaves through one drain line. A summer of that grows a film inside the trap and the line, and nobody thinks about a drain on the first cold night: a condensing furnace makes water of its own, in most installations it goes down that same line, and a line that will not take it backs the water up until the pressure switch refuses to close. So a no-heat call in a climate like this can end at the drain rather than at the burner.

Poteet, TX in numbers

Days a year with a low of 32°F or colder20NOAA 1991–2020 normals, station in or next to town
Days a year with a low of 20°F or colder1NOAA 1991–2020 normals
Average July dew point70°FPRISM 1991–2020 normals
Median year homes were built1974Census ACS 2019–2023
Households901Census ACS 2019–2023
CountyAtascosa CountyCensus Bureau
Federal minimum for a new split central AC14.3 SEER2 under 45,000 Btu/h (Southeast)DOE, 2023 standard

Why heating faults in Poteet do not fix themselves

A furnace that has to be reset to keep running is not a furnace that is working. Each lockout is a control board refusing to try again after a safety did not prove — the flame, the pressure switch or the limit — and a reset settles none of it. What a reset does change is the wear: a furnace short cycling through a cold week runs its ignition sequence dozens of times a day, and the ignitor and the inducer motor are the parts paying for it.

A heating tune-up before the season

A heating tune-up is the one visit that happens on your schedule rather than the furnace's. In Poteet it belongs before the first cold night, because the faults that end a winter evening are mostly parts that were already wearing in October: an ignitor near the end of its starts, a flame sensor carrying last season's coating, a filter loaded through the cooling months, a condensate drain that has grown a film.

A technician at an indoor air handler

When to stop and call

  • There is a smell of gas, or a carbon monoxide alarm has gone off — outside first, then the gas utility, then the repair call.
  • There is a tag on the furnace and the gas supply has been shut off.
  • Water is standing at the base of the furnace, or the flue outside has iced over.
The license
Held by the contractor, not by this site, and issued where the work happens — Texas licenses at state level, at city level or not at all depending on the trade and the town. Ask for the number and the name it is held under: a trading name and the licensed entity are often not the same.
The figure
Set by the contractor and said before the work starts. This site never quotes and has no part in it. If a technician cannot say what the visit covers before beginning, that is the moment to stop.
Coverage
By town, not by region. Poteet and the towns around it, and it shifts with who is taking calls at the hour you ring.

What the visit involves

  1. 01

    The diagnosis

    At the thermostat first, then at the furnace or the condenser, in the order the equipment runs. What the system is doing is established before any part is named.

  2. 02

    The repair

    Agreed with the contractor before it starts. Where a part has to be ordered, a technician says so rather than leaving the system apart.

  3. 03

    What happens after

    A system that failed once in a season often fails again in it. Whether that is the same fault or a second one is worth asking while the technician is still there.

What to have ready when you call from Poteet

  1. 01Which system it is: a furnace, a boiler with radiators or baseboard, or a heat pump with electric backup.
  2. 02Roughly when it went in, plus the model and serial number from the data plate inside the cabinet door — the year is usually in the serial rather than printed as a date.
  3. 03What it is doing: silent, clicking and stopping, lighting and dropping out, or running with cold air at the vents.

Do not keep pressing the reset while you wait — each press relights a furnace that shut itself down for a reason, and the lockout it is holding is the first thing a technician reads.

Heating Repair in Poteet: questions

How many freezing days does Poteet have?

Poteet averages 20 days a year with a low of 32°F or colder and 1 at 20°F or colder, by the 1991–2020 climate normals for the NOAA station in or next to town. Heating is rarely asked for here, so a fault in it can sit unnoticed until the one cold week of the year.

How old are the homes in Poteet?

Half the homes in Poteet were built before 1974, by the Census Bureau's 2019–2023 American Community Survey. Detached houses make up about half of the housing. Equipment in houses of that age is often on its second set, and the install date on the label decides whether parts are still made. Manufactured homes are common enough here that a packaged unit outside, feeding a duct under the floor, is worth mentioning on the call.

What efficiency does a new gas furnace in Poteet need?

The federal minimum for a new non-weatherized gas furnace is an AFUE of 80. DOE has set 95 for furnaces made after December 18, 2028, and that rule is still being fought in court, so a furnace installed now can still be an 80 or a condensing 90-plus.

Map loads when you reach it

Other services in Poteet

Heating Repair nearby

Call (888) 217-3739