HeatCoolHQ heatcoolhq.com (888) 217-3739

Palisade, CO

Heat Pump Repair and Replacement in Palisade, CO

Heat pump repair in Palisade, CO starts by telling a normal defrost cycle or auxiliary-heat run from one that is a fault. Palisade has, on average, 119 days a year with a low of 32°F or colder and 34 at 20°F or colder (NOAA 1991–2020 normals, station in or next to town), and those colder days are when a heat pump leans on its backup heat. Half the homes in Palisade were built before 1981 (Census ACS 2019–2023). The federal minimum for a split heat pump made since January 1, 2023 is 14.3 SEER2 in cooling and 7.5 HSPF2 in heating, nationwide.

(888) 217-3739

Colorado contractors. No obligation for the call.

The year in Palisade—both systems work a real season
The year in Palisade. both systems work a real season. There is no month when both systems are idle. BELOW FREEZINGJFMAMJJASOND
heatingcoolingbelow freezing119 days below freezing · July dew point 42°F
A technician checking the coil of an outdoor heat pump in winter
The top grille off, frost across the coil. A heat pump melts that off on a schedule of its own, which looks like a fault and is not.

A heat pump blowing air that feels cool in winter is usually working as designed, and a heat pump that sits on auxiliary heat for hours in mild weather usually is not. Say what the thermostat is showing and a heating and cooling contractor can come out to Palisade and tell the two apart.

A heat pump in Palisade carries most of the year on its own, cooling through the summer and heating through everything except the coldest weeks. That is the argument for one, and it is also what ages it: the compressor, the contactor and the capacitor take run hours an air conditioner in the same house would never see, which is why age on a heat pump is better counted in seasons worked than in years on the data plate — a system installed in 2012 that has worked both halves of every year since is further along than the date suggests.

The reversing valve gets tested twice a year, when the machine changes direction — once in autumn and once in spring. A machine that heated all winter and then refuses to cool when the first warm week of May arrives is usually pointing at that valve, or at the control that tells it to move, rather than at the compressor. Putting a spring failure off is easy, and that is the trap: the valve that would not move in May is the valve that has to move again in October, and a summer of leaving it alone does not fix it.

Nights below 20°F come often enough here that the auxiliary strips do real work, so a January bill above October's is the equipment behaving as designed rather than a fault. A failed element inside that bank is the version worth knowing about — several elements share one breaker, so the rest carry on, the house falls behind only on the coldest nights, and the heat pump itself tests fine.

Palisade, CO in numbers

Days a year with a low of 32°F or colder119NOAA 1991–2020 normals, station in or next to town
Days a year with a low of 20°F or colder34NOAA 1991–2020 normals
Average July dew point42°FPRISM 1991–2020 normals
Median year homes were built1981Census ACS 2019–2023
Households1,179Census ACS 2019–2023
CountyMesa CountyCensus Bureau
Federal minimum for a new split central AC13.4 SEER2 (North region)DOE, 2023 standard

Why heat pumps do not fix themselves

What makes a heat pump different is that it can fail without ever going quiet. A machine low on refrigerant, or one whose defrost control has stopped working, does not stop making heat — it falls behind, and the backup heat fills the gap without being asked. The thermostat still reads what it is set to, so the fault turns up on the electric bill rather than in the house. The same shortfall in cooling is easier to spot, because nothing covers for it — which is why a heat pump often gets diagnosed in summer for something it had been doing all through the heating season.

A technician at an indoor air handler

When to stop and call

  • The thermostat sits on auxiliary or emergency heat for hours while it is mild outside.
  • It cools in summer but will not heat, or it heats but will not cool.
  • Refrigerant was added in an earlier season and the system is behaving the same way again.
The license
Held by the contractor, not by this site, and issued where the work happens — Colorado licenses at state level, at city level or not at all depending on the trade and the town. Ask for the number and the name it is held under: a trading name and the licensed entity are often not the same.
The call
Describing what the system is doing commits you to nothing. Nothing is booked until you say so.
Coverage
By town, not by region. Palisade and the towns around it, and it shifts with who is taking calls at the hour you ring.

What happens on the visit

  1. 01

    The diagnosis

    At the thermostat first, then at the furnace or the condenser, in the order the equipment runs. What the system is doing is established before any part is named.

  2. 02

    The finding, out loud

    What failed, whether it is the fault or a symptom of another one, and whether the repair suits the age of the system. A diagnostic visit is usually charged separately from the repair — ask whether it is credited if the work goes ahead, because that differs from one contractor to the next.

  3. 03

    What happens after

    A system that failed once in a season often fails again in it. Whether that is the same fault or a second one is worth asking while the technician is still there.

What to have ready when you call

  1. 01That the system is a heat pump, and what carries the heat when it cannot — electric, or a gas furnace on the same ducts, and not knowing is a fair answer.
  2. 02What the thermostat is set to, what it is reading, and whether it shows auxiliary or emergency heat.
  3. 03The address and ZIP code, and whether the outdoor unit can be reached — a locked gate, a dog or deep snow changes the appointment.

Emergency heat is what that setting is for if the house has gone cold, but say on the phone that you switched to it, because it locks out the compressor, and the fault a technician needs to watch stops happening while it is on.

Heat Pumps in Palisade: questions

How cold does Palisade get in winter?

Palisade averages 119 days a year with a low of 32°F or colder and 34 at 20°F or colder, by the 1991–2020 climate normals for the NOAA station in or next to town. Both seasons are real here, and the coldest weeks are when the backup strips or a furnace carry part of the load.

How humid are summers in Palisade?

The July dew point in Palisade averages 42°F, by the PRISM 1991–2020 climate normals. In air that dry most of the cooling load is heat, and an air conditioner removes little water, so sizing turns on the house and its sun more than on humidity.

Can a contractor in Palisade still install an R-410A system?

Federally, yes, for equipment made or imported before January 1, 2025: the EPA dropped the January 1, 2026 installation deadline for that stock in a rule effective July 27, 2026. Equipment made since January 1, 2025 is charged with R-454B or R-32 instead, and an outdoor unit built for those is not a listed match for an indoor coil built for R-410A.

Map loads when you reach it

Other services in Palisade

Heat Pumps nearby

Call (888) 217-3739