HeatCoolHQ heatcoolhq.com (888) 217-3739

Moore, TX

Heat Pump Repair and Replacement in Moore, TX

Heat pump repair in Moore, TX starts by telling a normal defrost cycle or auxiliary-heat run from one that is a fault. Moore has, on average, 17 days a year with a low of 32°F or colder and about one at 20°F or colder (NOAA 1991–2020 normals, station 16 miles away). Half the homes in Moore were built in 2007 or later (Census ACS 2019–2023), so many houses here still run the equipment they were built with. Every split heat pump made since January 1, 2023 has to rate at least 14.3 SEER2 for cooling and 7.5 HSPF2 for heating, the same federal minimum in every state.

(888) 217-3739

Texas contractors. No obligation for the call.

The year in Moore—cooling runs nearly all year
The year in Moore. cooling runs nearly all year. There is no month when both systems are idle. JFMAMJJASOND
heatingcooling17 days below freezing · July dew point 69°F
A technician checking the coil of an outdoor heat pump in winter
The top grille off, frost across the coil. A heat pump melts that off on a schedule of its own, which looks like a fault and is not.

Air that feels cool at the vents in winter is usually the heat pump working as designed, and a heat pump that sits on auxiliary heat for hours in mild weather usually is not. Say what the thermostat is showing and a heating and cooling contractor can come out to Moore and tell the two apart.

In Moore the cooling season is the year and the heating season is a handful of mornings. What a no-heat call means here depends on what else is in the house: where there is a furnace, the heat pump has something to hand the load to, and where there is none — and in this climate plenty of houses have none — the only thing behind it is a bank of electric resistance strips. That is the first thing a technician asks about, because there is no second appliance to switch to.

Sizing here runs the opposite way from a cold climate: the cooling load sets the size, exactly as it would for an air conditioner, because it is the load that exists for most of the year — which is correct, and it also means that on the handful of genuinely cold mornings the machine runs without stopping and the strips carry what it cannot. A machine running continuously on a cold morning is doing its job, not failing at it.

The frost on an outdoor coil comes out of the air, not off the ground, which is why the heaviest of it here arrives in weather nobody would call severe. A coil below freezing collects moisture from damp air faster than from cold dry air, so a drizzly morning near 35°F puts more ice on it than a clear night at 15°F does — and a defrost cycle on a mild wet morning is the machine keeping up rather than falling behind. Ice still sitting there at the end of the day is the fault version, and it does not clear itself.

Moore, TX in numbers

Days a year with a low of 32°F or colder17NOAA 1991–2020 normals, station 16 miles away
Days a year with a low of 20°F or colder1NOAA 1991–2020 normals
Average July dew point69°FPRISM 1991–2020 normals
Median year homes were built2007Census ACS 2019–2023
Households19Census ACS 2019–2023
CountyFrio CountyCensus Bureau
Federal minimum for a new split central AC14.3 SEER2 under 45,000 Btu/h (Southeast)DOE, 2023 standard

Heat pumps do not fix themselves

The parts that cycle fail first, and they rarely fail alone. A run capacitor that has lost capacitance does not stop the compressor — it raises the current the compressor draws every minute it runs, and the heat that comes with it. A heat pump asks for that on the heating side as well as the cooling one, where an AC only ever runs to cool, so the part that fails at the end of it is not the capacitor. A capacitor is a part; a compressor is a large fraction of the machine, and on a system installed before 2010 that is where the conversation turns to replacement.

A technician at an indoor air handler

When to stop and call in Moore

  • Ice covers the outdoor coil and the defrost cycles are not clearing it.
  • The breaker feeding the outdoor unit or the air handler will not stay in.
  • Refrigerant was added in an earlier season and the system is behaving the same way again.
The license
Held by the contractor, not by this site, and issued where the work happens — Texas licenses at state level, at city level or not at all depending on the trade and the town. Ask for the number and the name it is held under: a trading name and the licensed entity are often not the same.
The call
Describing what the system is doing commits you to nothing. Nothing is booked until you say so.
Coverage
By town, not by region. Moore and the towns around it, and it shifts with who is taking calls at the hour you ring.

What the visit involves

  1. 01

    The diagnosis

    At the thermostat first, then at the furnace or the condenser, in the order the equipment runs. What the system is doing is established before any part is named.

  2. 02

    The finding, out loud

    What failed, whether it is the fault or a symptom of another one, and whether the repair suits the age of the system. A diagnostic visit is usually charged separately from the repair — ask whether it is credited if the work goes ahead, because that differs from one contractor to the next.

  3. 03

    The repair

    Agreed with the contractor before it starts. Where a part has to be ordered, a technician says so rather than leaving the system apart.

Before you call: what to have ready

  1. 01That it is a heat pump, and what the backup is — electric, or a gas furnace on the same ducts, and not knowing is a fair answer.
  2. 02Roughly what year it went in, and the refrigerant from the outdoor data plate — R-410A on most systems in service, R-454B on recent ones.
  3. 03What the unit outside is doing: iced over, silent, running without stopping, or reversing every few minutes.

If the house has gone cold, emergency heat is what that setting is for — say on the phone that you switched to it, because it locks out the compressor, and the fault a technician needs to watch stops happening while it is on.

Heat Pumps in Moore: questions

How many freezing days does Moore have?

Moore averages 17 days a year with a low of 32°F or colder and 1 at 20°F or colder, by the 1991–2020 climate normals for a NOAA station 16 miles away. Heating is a handful of mornings here, so a heat pump spends nearly the whole year cooling.

How humid are summers in Moore?

The July dew point in Moore averages 69°F, by the PRISM 1991–2020 climate normals. In air that wet an oversized air conditioner cools the house fast, shuts off before it has dried the air, and leaves rooms cool and clammy, which is why sizing starts with a load calculation for the house.

Does the federal tax credit still cover a new heat pump in Moore?

No: under the tax law signed on July 4, 2025, the 25C credit does not apply to equipment installed after December 31, 2025. A quote that still counts it is out of date; a utility or state rebate is a separate program, and the contractor or the utility can say whether one applies.

Map loads when you reach it

Other services in Moore

Heat Pumps nearby

Call (888) 217-3739