Mentone, TX
Furnace Replacement and Installation in Mentone, TX
Furnace replacement in Mentone, TX turns on three things: when the furnace went in, what failed, and how much heat the house actually needs. Mentone averages 69 days a year with a low of 32°F or colder and 7 at 20°F or colder (NOAA 1991–2020 normals, station 23 miles away). Half the homes in Mentone were built before 1960 (Census ACS 2019–2023), so in many of them the heating and cooling equipment has been replaced at least once while the ducts and the flue have not. The federal minimum for a new non-weatherized gas furnace is an AFUE of 80, and a 95 standard for furnaces made after December 18, 2028 is still in court.
(888) 217-3739Texas contractors. No obligation for the call.
A furnace that has failed once and a furnace on its second service call this season are two different questions. Say when it went in, roughly, and what it is doing now, and a heating contractor can come out to Mentone and answer that before anything is ordered.
The furnace in Mentone runs a fraction of the hours the same appliance would further north, and that shows in how it fails. It rarely wears out — it sits idle for most of the year, and the first cold evening asks it to start.
So the replacement question usually arrives from the cooling side. A compressor fails in August, or the indoor coil leaks, and the cabinet comes apart for reasons that have nothing to do with heat — and the furnace stands there in the open, data plate showing, while the AC work goes on around it. The furnace is not the reason for the call, and it is still part of what gets decided that day.
Mentone, TX in numbers
| Days a year with a low of 32°F or colder | 69 | NOAA 1991–2020 normals, station 23 miles away |
|---|---|---|
| Days a year with a low of 20°F or colder | 7 | NOAA 1991–2020 normals |
| Average July dew point | 59°F | PRISM 1991–2020 normals |
| Median year homes were built | 1960 | Census ACS 2019–2023 |
| Households | 5 | Census ACS 2019–2023 |
| County | Loving County | Census Bureau |
| Federal minimum for a new split central AC | 14.3 SEER2 under 45,000 Btu/h (Southeast) | DOE, 2023 standard |
Furnaces do not fix themselves
A crack in a heat exchanger does not stay the size it was found at. Every heating cycle opens it further, because heat moves the steel and the crack is where that movement collects.
When to stop and call in Mentone
- A technician has said the words heat exchanger, or a carbon monoxide alarm has gone off.
- Flame rolls out of the burner opening, or there is soot around the furnace door.
- The part it needs is on back order and the furnace was installed before 2010.
- The license
- Held by the contractor, not by this site, and issued where the work happens — Texas licenses at state level, at city level or not at all depending on the trade and the town. Ask for the number and the name it is held under: a trading name and the licensed entity are often not the same.
- The figure
- Set by the contractor and said before the work starts. This site never quotes and has no part in it. If a technician cannot say what the visit covers before beginning, that is the moment to stop.
- The call
- Describing what the system is doing commits you to nothing. Nothing is booked until you say so.
What the visit involves
- 01
The finding, out loud
What failed, whether it is the fault or a symptom of another one, and whether the repair suits the age of the system. A diagnostic visit is usually charged separately from the repair — ask whether it is credited if the work goes ahead, because that differs from one contractor to the next.
- 02
The repair
Agreed with the contractor before it starts. Where a part has to be ordered, a technician says so rather than leaving the system apart.
- 03
What happens after
A system that failed once in a season often fails again in it. Whether that is the same fault or a second one is worth asking while the technician is still there.
What to have ready when you call
- 01When the furnace went in, roughly, and its model number — the data plate inside the door carries both.
- 02Whether the gas utility has already been there, and the wording on the tag — the tag usually names the component.
- 03Whether the same ductwork also cools the house, and what the outdoor data plate lists as the refrigerant — R-410A, R-454B or R-22 — and the model number on that unit, which tells a contractor whether it only cools or heats as well.
Have the data plate from inside the furnace door in front of you, because it answers half the call — the year it went in and the model number. And if the gas utility left a tag on the appliance, leave the tag where it is: it names what has to be put right before the gas comes back.
Furnace Replacement in Mentone: questions
How many freezing days does Mentone have?
Mentone averages 69 days a year with a low of 32°F or colder and 7 at 20°F or colder, by the 1991–2020 climate normals for a NOAA station 23 miles away. Cooling leads here, and the heating runs for a few weeks of the year, so a fault often shows up on the first cold morning.
How old are the homes in Mentone?
Half the homes in Mentone were built before 1960, by the Census Bureau's 2019–2023 American Community Survey. Detached houses make up most of the housing. In houses that age the furnace or air conditioner has usually been replaced at least once, and the ducts and the flue are often older than the equipment. Manufactured homes are common enough here that a packaged unit outside, feeding a duct under the floor, is worth mentioning on the call.
Is there still a federal tax credit for a new furnace?
No. The 25C energy efficient home improvement credit ended for equipment installed after December 31, 2025, under the tax law signed on July 4, 2025. A quote that subtracts it is out of date, and any utility or state rebate is a separate program to ask the utility about.