HeatCoolHQ heatcoolhq.com (888) 217-3739

Memphis, TX

Heat Pump Repair and Replacement in Memphis, TX

Heat pump repair in Memphis, TX starts by telling a normal defrost cycle or auxiliary-heat run from one that is a fault. Memphis has, on average, 89 days a year with a low of 32°F or colder and 18 at 20°F or colder (NOAA 1991–2020 normals, station in or next to town). Half the homes in Memphis were built before 1955 (Census ACS 2019–2023), so in many of them the heating and cooling equipment has been replaced at least once while the ducts and the flue have not. Every split heat pump made since January 1, 2023 has to rate at least 14.3 SEER2 for cooling and 7.5 HSPF2 for heating, the same federal minimum in every state.

(888) 217-3739

Texas contractors. No obligation for the call.

The year in Memphis—cooling leads, heating gets weeks
The year in Memphis. cooling leads, heating gets weeks. Between the two seasons there are weeks when neither system runs, which is when a fault goes unnoticed. nothing runsJFMAMJJASOND
heatingcooling89 days below freezing · July dew point 62°F
A technician checking the coil of an outdoor heat pump in winter
The top grille off, frost across the coil. A heat pump melts that off on a schedule of its own, which looks like a fault and is not.

A heat pump blowing air that feels cool in winter is usually working as designed, and a heat pump that sits on auxiliary heat for hours in mild weather usually is not. Say what the thermostat reads and a heating and cooling contractor can come out to Memphis and tell the two apart.

In Memphis a heat pump spends most of its life as an air conditioner, and the heating side runs for a few weeks rather than a season. That decides which faults get noticed and when: anything wrong with cooling shows up in July with the whole house paying attention, while anything wrong with heating waits for the first cold week of the year to announce itself.

A gas furnace and a heat pump do not deliver heat at the same temperature, and the difference is large. A heat pump supplies air nearer 95°F where a gas furnace supplies it nearer 130°F, and air that arrives near skin temperature, moving, reads as cool — which is why the complaint arrives every year from houses with nothing wrong. What matters is whether the house reaches the setting, and how long it sits short of it: air that feels cool with the house holding at the setting is the machine working, and air that feels cool with the house still short of it at bedtime is not.

The frost on an outdoor coil comes out of the air, not off the ground, which is why the heaviest of it here arrives in weather nobody would call severe. A coil below freezing collects moisture from damp air faster than from cold dry air, so a drizzly morning near 35°F puts more ice on it than a clear night at 15°F does — and a defrost cycle on a mild wet morning is the machine keeping up rather than falling behind. Ice still sitting there at the end of the day is the fault version, and it does not clear itself.

Memphis, TX in numbers

Days a year with a low of 32°F or colder89NOAA 1991–2020 normals, station in or next to town
Days a year with a low of 20°F or colder18NOAA 1991–2020 normals
Average July dew point62°FPRISM 1991–2020 normals
Median year homes were built1955Census ACS 2019–2023
Households917Census ACS 2019–2023
CountyHall CountyCensus Bureau
Federal minimum for a new split central AC14.3 SEER2 under 45,000 Btu/h (Southeast)DOE, 2023 standard

Why heat pumps do not fix themselves

A heat pump is unusual in that it can fail without going quiet. A machine low on refrigerant, or one whose defrost control has stopped working, does not stop making heat — it falls behind, and the backup heat fills the gap without being asked. The house stays at the setting, so the fault reports itself on the electric bill instead of at the thermostat. The same shortfall in cooling is easier to spot, because nothing covers for it — which is why a heat pump often gets diagnosed in summer for something it had been doing all through the heating season.

A technician at an indoor air handler

When to stop and call in Memphis

  • It cools in summer but will not heat, or it heats but will not cool.
  • The breaker feeding the outdoor unit or the air handler will not stay in.
  • Refrigerant was added in an earlier season and the system is behaving the same way again.
The license
Held by the contractor, not by this site, and issued where the work happens — Texas licenses at state level, at city level or not at all depending on the trade and the town. Ask for the number and the name it is held under: a trading name and the licensed entity are often not the same.
The figure
Set by the contractor and said before the work starts. This site never quotes and has no part in it. If a technician cannot say what the visit covers before beginning, that is the moment to stop.
The call
Describing what the system is doing commits you to nothing. Nothing is booked until you say so.

What happens on the visit

  1. 01

    The diagnosis

    At the thermostat first, then at the furnace or the condenser, in the order the equipment runs. What the system is doing is established before any part is named.

  2. 02

    The finding, out loud

    What failed, whether it is the fault or a symptom of another one, and whether the repair suits the age of the system. A diagnostic visit is usually charged separately from the repair — ask whether it is credited if the work goes ahead, because that differs from one contractor to the next.

  3. 03

    What happens after

    A system that failed once in a season often fails again in it. Whether that is the same fault or a second one is worth asking while the technician is still there.

What to have ready when you call

  1. 01That the system is a heat pump, and what carries the heat when it cannot — electric, or a gas furnace on the same ducts, and not knowing is a fair answer.
  2. 02Roughly what year it went in, and the refrigerant from the outdoor data plate — R-410A on most systems in service, R-454B on recent ones.
  3. 03The address and ZIP code, and whether the outdoor unit can be reached — a locked gate, a dog or deep snow changes the appointment.

Emergency heat is what that setting is for if the house has gone cold, but say on the phone that you switched to it, because it locks out the compressor, and the fault a technician needs to watch stops happening while it is on.

Heat Pumps in Memphis: questions

How many freezing days does Memphis have?

Memphis averages 89 days a year with a low of 32°F or colder and 18 at 20°F or colder, by the 1991–2020 climate normals for the NOAA station in or next to town. Cooling sizes the equipment here, and the few cold mornings are when the backup heat comes on.

How humid are summers in Memphis?

The July dew point in Memphis averages 62°F, by the PRISM 1991–2020 climate normals. In air that wet an oversized air conditioner cools the house fast, shuts off before it has dried the air, and leaves rooms cool and clammy, which is why sizing starts with a load calculation for the house.

Can a contractor in Memphis still install an R-410A system?

Federally, yes, for equipment made or imported before January 1, 2025: the EPA dropped the January 1, 2026 installation deadline for that stock in a rule effective July 27, 2026. Equipment made since January 1, 2025 is charged with R-454B or R-32 instead, and an outdoor unit built for those is not a listed match for an indoor coil built for R-410A.

Map loads when you reach it

Other services in Memphis

Heat Pumps nearby

Call (888) 217-3739