HeatCoolHQ heatcoolhq.com (888) 217-3739

Lexington, TX

Furnace Replacement and Installation in Lexington, TX

Furnace replacement in Lexington, TX turns on three things: when the furnace went in, what failed, and how much heat the house actually needs. Lexington has, on average, 27 days a year with a low of 32°F or colder and about one at 20°F or colder (NOAA 1991–2020 normals, station in or next to town). Half the homes in Lexington were built before 1978 (Census ACS 2019–2023). A new non-weatherized gas furnace has to reach an AFUE of at least 80, the federal minimum; DOE has set 95 for furnaces made after December 18, 2028, a rule still being fought in court.

(888) 217-3739

Texas contractors. No obligation for the call.

The year in Lexington—cooling runs nearly all year
The year in Lexington. cooling runs nearly all year. There is no month when both systems are idle. JFMAMJJASOND
heatingcooling27 days below freezing · July dew point 71°F
Two technicians easing a furnace cabinet down a basement stairway
A replacement cabinet coming off the dolly. How the unit gets in is part of the job: a turn in the stairs or a narrow doorway can decide which model fits.

A furnace with one failed part and a furnace on its second service call of the season are asking different questions. Say when it went in, roughly, and what it is doing now, and a heating contractor can come out to Lexington and answer that before anything is ordered.

What low hours change is the way a furnace ends, not whether it ends. A furnace here stands still more than it runs: a flue that never gets hot enough to dry itself out, condensate sitting in a trap through a warm winter, corrosion working on the burners from the outside in. Corrosion reaches the heat exchanger before cycling would have, and the ending is the same one.

From one house to the next here, the indoor cabinet is not the same thing: a small gas furnace in a closet or out in the garage in one, an air handler with electric resistance strips behind a heat pump in the next. The model number on the data plate settles which, and it settles what the visit is — a furnace changeout and an air handler changeout are not the same piece of work.

A new furnace brings a new blower with it, and that blower runs in July as well as in January, which makes a changeout here a cooling decision as much as a heating one. In July most of the work is water rather than temperature: a system that cools fast, shuts off and leaves the rooms cold and clammy did not run long enough to dehumidify. Ask what the new blower does at part load, because one that holds a lower airflow for a longer cycle takes more water out of the same house.

Lexington, TX in numbers

Days a year with a low of 32°F or colder27NOAA 1991–2020 normals, station in or next to town
Days a year with a low of 20°F or colder1NOAA 1991–2020 normals
Average July dew point71°FPRISM 1991–2020 normals
Median year homes were built1978Census ACS 2019–2023
Households702Census ACS 2019–2023
CountyLee CountyCensus Bureau
Federal minimum for a new split central AC14.3 SEER2 under 45,000 Btu/h (Southeast)DOE, 2023 standard

Furnaces do not fix themselves

A crack in a heat exchanger does not stay the size it was found at. Every heating cycle opens it further, because heat moves the steel and the crack is where that movement collects.

A technician at an indoor air handler

Signs it is time to call

  • The gas utility has tagged the furnace and shut the supply off.
  • Flame rolls out of the burner opening, or there is soot around the furnace door.
  • The part it needs is on back order and the furnace was installed before 2010.
The license
Held by the contractor, not by this site, and issued where the work happens — Texas licenses at state level, at city level or not at all depending on the trade and the town. Ask for the number and the name it is held under: a trading name and the licensed entity are often not the same.
The figure
Set by the contractor and said before the work starts. This site never quotes and has no part in it. If a technician cannot say what the visit covers before beginning, that is the moment to stop.
The call
Describing what the system is doing commits you to nothing. Nothing is booked until you say so.

What happens on the visit

  1. 01

    The diagnosis

    At the thermostat first, then at the furnace or the condenser, in the order the equipment runs. What the system is doing is established before any part is named.

  2. 02

    The finding, out loud

    What failed, whether it is the fault or a symptom of another one, and whether the repair suits the age of the system. A diagnostic visit is usually charged separately from the repair — ask whether it is credited if the work goes ahead, because that differs from one contractor to the next.

  3. 03

    The repair

    Agreed with the contractor before it starts. Where a part has to be ordered, a technician says so rather than leaving the system apart.

Before you call: what to have ready

  1. 01When the furnace went in, roughly, and its model number — the data plate inside the door carries both.
  2. 02What the furnace is doing now — no heat at all, short cycling, a noise that started recently, or burners that light and drop out.
  3. 03Where the appliance stands and what it vents into — a metal flue into a chimney, or a white plastic pipe through the wall — and whether a water heater shares that chimney, because one left alone on a flue sized for two appliances becomes its own piece of work. The address and ZIP code go with that.

Have the data plate from inside the furnace door in front of you, because it answers half the call — the year it went in and the model number. And if the gas utility left a tag on the appliance, leave the tag where it is: it names what has to be put right before the gas comes back.

Furnace Replacement in Lexington: questions

How many freezing days does Lexington have?

Lexington averages 27 days a year with a low of 32°F or colder and 1 at 20°F or colder, by the 1991–2020 climate normals for the NOAA station in or next to town. Heating is rarely asked for here, so a fault in it can sit unnoticed until the one cold week of the year.

How old are the homes in Lexington?

Half the homes in Lexington were built before 1978, by the Census Bureau's 2019–2023 American Community Survey. Detached houses make up about half of the housing. Equipment in houses of that age is often on its second set, and the install date on the label decides whether parts are still made. Manufactured homes are common enough here that a packaged unit outside, feeding a duct under the floor, is worth mentioning on the call.

How efficient must a new gas furnace be?

The federal minimum for a new non-weatherized gas furnace is an AFUE of 80. DOE has set 95 for furnaces made after December 18, 2028, and that rule is still being fought in court, so a furnace installed now can still be an 80 or a condensing 90-plus.

Map loads when you reach it

Other services in Lexington

Furnace Replacement nearby

Call (888) 217-3739