HeatCoolHQ heatcoolhq.com (888) 217-3739

Kimberly, ID

AC Replacement and Installation in Kimberly, ID

AC replacement in Kimberly, ID is sized from the house and its climate, not from the tonnage stamped on the old condenser. Kimberly has an average July dew point of 43°F (PRISM 1991–2020 normals), dry enough that nearly all of the cooling load is heat rather than moisture. Half the homes in Kimberly were built before 1987 (Census ACS 2019–2023). In Idaho, a split central air conditioner made since January 1, 2023 has to rate at least 13.4 SEER2, the federal minimum for the North region.

(888) 217-3739

Idaho contractors. No obligation for the call.

The year in Kimberly—heating runs most of the year
The year in Kimberly. heating runs most of the year. Between the two seasons there are weeks when neither system runs, which is when a fault goes unnoticed. BELOW FREEZINGBELOW FREEZINGnothing runsJFMAMJJASOND
heatingcoolingbelow freezing156 days below freezing · July dew point 43°F
Two technicians lowering a new condenser onto a concrete pad
A new outdoor unit going down on its pad. Where it stands decides how it is serviced for the next fifteen years, and that is settled once.

An air conditioner that no longer holds the house on a hot afternoon is not automatically finished, and what settles it is age, what failed, and what the system is charged with. Say what year the system went in and what it has started doing, and an independent contractor can come out to Kimberly and size the replacement from the house rather than from the box being carried out.

A short cooling season is what makes the age of an air conditioner misleading in Kimberly. A system that cools for ten or twelve weeks a year puts on a fraction of the running hours the same model accumulates in the south, so it can still be cooling years after the date on the equipment suggested it would stop.

The second machine is usually standing in the same cabinet as the first. Where a furnace and the indoor coil share one, they almost always went in on the same day, and a changeout that replaces one and leaves the other means a contractor opens that cabinet twice. A changeout usually takes about one day, and a heating climate leaves eight months in which that day is not an emergency.

The summer air in Kimberly holds so little water that dropping the temperature is nearly the whole job, and the same oversizing error has the opposite consequence. Nothing goes clammy, because there was little moisture to remove; what happens instead is short cycling — the AC reaches the setting almost as soon as it starts, stops, the temperature climbs back, and it starts again. Starting is the hard part of a compressor's day, so a system that starts several times an hour wears the contactor and the compressor rather than the season. A technician sizing a replacement here also expects a wider temperature split across the coil, because nearly all of the capacity goes into temperature and almost none of it into water.

Kimberly, ID in numbers

Days a year with a low of 32°F or colder156NOAA 1991–2020 normals, station in or next to town
Days a year with a low of 20°F or colder47NOAA 1991–2020 normals
Average July dew point43°FPRISM 1991–2020 normals
Median year homes were built1987Census ACS 2019–2023
Households1,505Census ACS 2019–2023
CountyTwin Falls CountyCensus Bureau
Federal minimum for a new split central AC13.4 SEER2 (North region)DOE, 2023 standard

What the hardware-store fix does and does not do

The sealed can with a gauge on the top is the usual first move, and it deserves an honest answer. A system low on refrigerant does cool badly, and putting refrigerant into it does make it cool better for a while — that part is real. What the can cannot do is find the hole: refrigerant is not used up, so a system that is low is leaking, and the gap between cans gets shorter every time. The cans on the shelf beside the motor oil are charged for car systems, which use a different refrigerant from a home air conditioner, and the ones with a sealant in them add a second problem to the first — sealant can set in the metering device, and it fouls the recovery machine a technician has to connect.

A technician at an indoor air handler

When to stop and call in Kimberly

  • You have read R-22 on the outdoor data plate, and the system is no longer holding the house.
  • The compressor hums and then trips the breaker, and resetting it is the one thing you can do that makes it worse.
  • Ice comes back on the line or the coil after you have put a clean filter in.
The figure
Set by the contractor and said before the work starts. This site never quotes and has no part in it. If a technician cannot say what the visit covers before beginning, that is the moment to stop.
The call
Describing what the system is doing commits you to nothing. Nothing is booked until you say so.
Coverage
By town, not by region. Kimberly and the towns around it, and it shifts with who is taking calls at the hour you ring.

What the visit involves

  1. 01

    The diagnosis

    At the thermostat first, then at the furnace or the condenser, in the order the equipment runs. What the system is doing is established before any part is named.

  2. 02

    The finding, out loud

    What failed, whether it is the fault or a symptom of another one, and whether the repair suits the age of the system. A diagnostic visit is usually charged separately from the repair — ask whether it is credited if the work goes ahead, because that differs from one contractor to the next.

  3. 03

    What happens after

    A system that failed once in a season often fails again in it. Whether that is the same fault or a second one is worth asking while the technician is still there.

Before you call: what to have ready

  1. 01Roughly what year it was installed, and which refrigerant it runs on — the model number is worth having in front of you too.
  2. 02Whether anyone has looked at the system this season, and what they said was wrong.
  3. 03What the system is doing now — not cooling at all, cooling weakly, running without ever stopping, tripping the breaker, or icing over.

Read the outdoor data plate before you call — the model number and the refrigerant are printed on it, and those two lines decide most of what follows.

AC Replacement in Kimberly: questions

What is the July dew point in Kimberly?

The July dew point in Kimberly averages 43°F, by the PRISM 1991–2020 climate normals. In air that dry most of the cooling load is heat, and an air conditioner removes little water, so sizing turns on the house and its sun more than on humidity.

How old are the homes in Kimberly?

Half the homes in Kimberly were built before 1987, by the Census Bureau's 2019–2023 American Community Survey. Detached houses make up most of the housing. Equipment in houses of that age is often on its second set, and the install date on the label decides whether parts are still made. Manufactured homes are common enough here that a packaged unit outside, feeding a duct under the floor, is worth mentioning on the call.

What efficiency does a new air conditioner need in Kimberly?

A new split central air conditioner in Kimberly falls under DOE's 2023 standard for the North: at least 13.4 SEER2. In the North the rule follows the date of manufacture, so a unit made earlier to the old standard can still be installed.

Map loads when you reach it

Other services in Kimberly

AC Replacement nearby

Call (888) 217-3739