Kim, CO
Furnace Replacement and Installation in Kim, CO
A new furnace in Kim, CO is sized from the house, its ducts and its winters, not from the rating plate of the one coming out. Kim averages 151 days a year with a low of 32°F or colder and 55 at 20°F or colder (NOAA 1991–2020 normals, station 10 miles away). Half the homes in Kim were built before 1970 (Census ACS 2019–2023). A new non-weatherized gas furnace has to reach an AFUE of at least 80, the federal minimum; DOE has set 95 for furnaces made after December 18, 2028, a rule still being fought in court.
(888) 217-3739Colorado contractors. No obligation for the call.
A furnace with one failed part and a furnace on its second service call of the season are asking different questions. Say roughly when it was installed and what it is doing, and a heating contractor can come out to Kim and answer that before anything is ordered.
Every time the burners light the steel expands, and every time they stop it contracts, and a crack is where that ends. That is not a failed part: the heat exchanger is the body of the machine rather than something bolted to it, and getting at one means stripping the furnace back to its cabinet. By then most of the decision has been made for you.
That is why the month matters more here than in most places. A changeout takes about one day, and for part of that day the house has no heat — an ordinary afternoon in September, a different proposition in January. A furnace that came through last winter on two repairs is worth raising in spring rather than in February.
A changeout is the one visit where a second question is genuinely open, and nights below 20°F come often enough here to put it there: another gas furnace, or a heat pump with the furnace kept behind it. A heat pump working alone hands the shortfall to electric resistance strips on those nights, and the electric bill follows. What a contractor means by dual fuel is keeping the furnace as the backup instead of strips, and the thermostat, the wiring and the gas connection are all apart on changeout day anyway.
Kim, CO in numbers
| Days a year with a low of 32°F or colder | 151 | NOAA 1991–2020 normals, station 10 miles away |
|---|---|---|
| Days a year with a low of 20°F or colder | 55 | NOAA 1991–2020 normals |
| Average July dew point | 51°F | PRISM 1991–2020 normals |
| Median year homes were built | 1970 | Census ACS 2019–2023 |
| Households | 43 | Census ACS 2019–2023 |
| County | Las Animas County | Census Bureau |
| Federal minimum for a new split central AC | 13.4 SEER2 (North region) | DOE, 2023 standard |
What the hardware-store fix does and does not do
A fresh filter is the one thing off the shelf that genuinely does something, and it is worth being exact about what it reaches. A loaded filter chokes the air moving across the heat exchanger until the limit switch opens on temperature, and from the hallway that looks like a furnace that has died. A technician rules that out first as well, along with a flame sensor filmed over enough to make the burners light, drop out a few seconds later, try again, and lock out on the third attempt. A furnace that has been through both and still stops is not a parts question any more.
Signs it is time to call
- The gas utility has tagged the furnace and shut the supply off.
- A technician has said the words heat exchanger, or a carbon monoxide alarm has gone off.
- This is the second service call on the same furnace in one heating season.
- The figure
- Set by the contractor and said before the work starts. This site never quotes and has no part in it. If a technician cannot say what the visit covers before beginning, that is the moment to stop.
- The call
- Describing what the system is doing commits you to nothing. Nothing is booked until you say so.
- Coverage
- By town, not by region. Kim and the towns around it, and it shifts with who is taking calls at the hour you ring.
What a visit in Kim involves
- 01
The diagnosis
At the thermostat first, then at the furnace or the condenser, in the order the equipment runs. What the system is doing is established before any part is named.
- 02
The repair
Agreed with the contractor before it starts. Where a part has to be ordered, a technician says so rather than leaving the system apart.
- 03
What happens after
A system that failed once in a season often fails again in it. Whether that is the same fault or a second one is worth asking while the technician is still there.
What to have ready when you call
- 01Roughly when the furnace was installed, and the model number — the data plate inside the door carries both.
- 02Whether cooling runs through the same ductwork, and what the outdoor data plate gives as the refrigerant — R-410A, R-454B or R-22 — and the model number on that unit, which tells a contractor whether it only cools or heats as well.
- 03Where the furnace sits and what it vents into — a metal flue into a chimney, or a white plastic pipe through the wall — and whether a water heater shares that chimney, because one left alone on a flue sized for two appliances becomes its own piece of work. The address and ZIP code go with that.
Have the data plate from inside the furnace door in front of you, because it answers half the call — the year it went in and the model number. And if the gas utility left a tag on the appliance, leave the tag where it is: it names what has to be put right before the gas comes back.
Furnace Replacement in Kim: questions
How many freezing days does Kim have?
Kim averages 151 days a year with a low of 32°F or colder and 55 at 20°F or colder, by the 1991–2020 climate normals for a NOAA station 10 miles away. Heating is the main system here, and a furnace that quits in January is an emergency rather than an inconvenience.
When were most houses in Kim built?
Half the homes in Kim were built before 1970, by the Census Bureau's 2019–2023 American Community Survey. Detached houses make up most of the housing. Equipment in houses of that age is often on its second set, and the install date on the label decides whether parts are still made. Manufactured homes are common enough here that a packaged unit outside, feeding a duct under the floor, is worth mentioning on the call.
What happens if the gas company red-tags a furnace in Kim?
A red tag means the gas utility found a leak or an unsafe appliance and shut the gas off to it. Gas comes back only after a contractor repairs the fault; a cracked heat exchanger is the finding that most often turns the repair into a replacement.
Other services in Kim
Furnace Replacement nearby