Kennard, TX
Furnace Replacement and Installation in Kennard, TX
Replacing a furnace in Kennard, TX starts with sizing the new one to the house rather than copying the label on the old one. Kennard averages 26 days a year with a low of 32°F or colder and about one at 20°F or colder (NOAA 1991–2020 normals, station 11 miles away). Half the homes in Kennard were built before 1978 (Census ACS 2019–2023). A new non-weatherized gas furnace has to reach an AFUE of at least 80, the federal minimum; DOE has set 95 for furnaces made after December 18, 2028, a rule still being fought in court.
(888) 217-3739Texas contractors. No obligation for the call.
A furnace that has failed once and a furnace on its second service call this season are two different questions. Say when it went in, roughly, and what it is doing now, and a heating contractor can come out to Kennard and answer that before anything is ordered.
What low hours change is the way a furnace ends, not whether it ends. A furnace here stands still more than it runs: a flue that never gets hot enough to dry itself out, condensate sitting in a trap through a warm winter, corrosion working on the burners from the outside in. Corrosion reaches the heat exchanger before cycling would have, and the ending is the same one.
From one house to the next here, the indoor cabinet is not the same thing: a small gas furnace in a closet or out in the garage in one, an air handler with electric resistance strips behind a heat pump in the next. The model number on the data plate settles which, and it settles what the visit is — a furnace changeout and an air handler changeout are not the same piece of work.
A new furnace brings a new blower with it, and that blower runs in July as well as in January, which makes a changeout here a cooling decision as much as a heating one. In July most of the work is water rather than temperature: a system that cools the air fast, shuts down and leaves the house cold and sticky never ran long enough to dehumidify. Ask what the new blower does at part load, because one that holds a lower airflow for a longer cycle takes more water out of the same house.
Kennard, TX in numbers
| Days a year with a low of 32°F or colder | 26 | NOAA 1991–2020 normals, station 11 miles away |
|---|---|---|
| Days a year with a low of 20°F or colder | 1 | NOAA 1991–2020 normals |
| Average July dew point | 72°F | PRISM 1991–2020 normals |
| Median year homes were built | 1978 | Census ACS 2019–2023 |
| Households | 106 | Census ACS 2019–2023 |
| County | Houston County | Census Bureau |
| Federal minimum for a new split central AC | 14.3 SEER2 under 45,000 Btu/h (Southeast) | DOE, 2023 standard |
Why furnaces in Kennard do not fix themselves
A crack in a heat exchanger does not stay the size it was found at. It opens further on every heating cycle, because heat moves the steel and the crack is where that movement collects.
When to stop and call in Kennard
- The gas utility has tagged the furnace and shut the supply off.
- Flame rolls out of the burner opening, or there is soot around the furnace door.
- The part it needs is on back order and the furnace was installed before 2010.
- The license
- Held by the contractor, not by this site, and issued where the work happens — Texas licenses at state level, at city level or not at all depending on the trade and the town. Ask for the number and the name it is held under: a trading name and the licensed entity are often not the same.
- The call
- Describing what the system is doing commits you to nothing. Nothing is booked until you say so.
- Coverage
- By town, not by region. Kennard and the towns around it, and it shifts with who is taking calls at the hour you ring.
What the visit involves
- 01
The diagnosis
At the thermostat first, then at the furnace or the condenser, in the order the equipment runs. What the system is doing is established before any part is named.
- 02
The finding, out loud
What failed, whether it is the fault or a symptom of another one, and whether the repair suits the age of the system. A diagnostic visit is usually charged separately from the repair — ask whether it is credited if the work goes ahead, because that differs from one contractor to the next.
- 03
The repair
Agreed with the contractor before it starts. Where a part has to be ordered, a technician says so rather than leaving the system apart.
What to have ready when you call
- 01Roughly when the furnace was installed, and the model number — the data plate inside the door carries both.
- 02Whether cooling runs through the same ductwork, and what the outdoor data plate gives as the refrigerant — R-410A, R-454B or R-22 — and the model number on that unit, which tells a contractor whether it only cools or heats as well.
- 03Where the furnace sits and what it vents into — a metal flue into a chimney, or a white plastic pipe through the wall — and whether a water heater shares that chimney, because one left alone on a flue sized for two appliances becomes its own piece of work. Give the address and ZIP code as well.
The data plate inside the furnace door answers half the call, so have it in front of you — the year it went in and the model number. And if the gas utility left a tag on the appliance, leave the tag where it is: it names what has to be put right before the gas comes back.
Furnace Replacement in Kennard: questions
How many freezing days does Kennard have?
Kennard averages 26 days a year with a low of 32°F or colder and 1 at 20°F or colder, by the 1991–2020 climate normals for a NOAA station 11 miles away. Heating is rarely asked for here, so a fault in it can sit unnoticed until the one cold week of the year.
When were most houses in Kennard built?
Half the homes in Kennard were built before 1978, by the Census Bureau's 2019–2023 American Community Survey. Detached houses make up about half of the housing. Equipment in houses of that age is often on its second set, and the install date on the label decides whether parts are still made. Manufactured homes are common enough here that a packaged unit outside, feeding a duct under the floor, is worth mentioning on the call.
What efficiency does a new gas furnace in Kennard need?
A new non-weatherized gas furnace has to reach an AFUE of at least 80 under the federal minimum. A 95 standard is set for furnaces made after December 18, 2028 and is still in court, so a furnace going in now can be an 80 or a condensing model in the 90s.
Other services in Kennard
Furnace Replacement nearby