Kemah, TX
Furnace Replacement and Installation in Kemah, TX
A new furnace in Kemah, TX is sized from the house, its ducts and its winters, not from the rating plate of the one coming out. Kemah averages 9 days a year with a low of 32°F or colder and almost none at 20°F or colder (NOAA 1991–2020 normals, station 5 miles away). Half the homes in Kemah were built in 1995 or later (Census ACS 2019–2023). The federal minimum for a new non-weatherized gas furnace is an AFUE of 80, and a 95 standard for furnaces made after December 18, 2028 is still in court.
(888) 217-3739Texas contractors. No obligation for the call.
A furnace that has failed once and a furnace on its second service call this season are two different questions. Say roughly when it was installed and what it is doing, and a heating contractor can come out to Kemah and answer that before anything is ordered.
A furnace in Kemah works a few weeks of the year, and some years barely that. The calendar comes out of the decision first: a changeout takes about one day, and a day without heat here is an inconvenience rather than a risk. Here the appliance sets the timing, rather than the timing setting the appliance.
Low hours change the way a furnace ends rather than whether it ends. A furnace here stands still more than it runs: a flue that never gets hot enough to dry itself out, condensate sitting in a trap through a warm winter, corrosion working on the burners from the outside in. Corrosion reaches the heat exchanger before cycling would have, and the ending is the same one.
Salt air works on the outdoor unit and does not reach the equipment indoors, which is why near the water the two halves stop reaching the end of their lives together — the coil and the cabinet outside corrode years ahead of anything inside the house.
Kemah, TX in numbers
| Days a year with a low of 32°F or colder | 9 | NOAA 1991–2020 normals, station 5 miles away |
|---|---|---|
| Days a year with a low of 20°F or colder | fewer than one | NOAA 1991–2020 normals |
| Average July dew point | 75°F | PRISM 1991–2020 normals |
| Median year homes were built | 1995 | Census ACS 2019–2023 |
| Households | 772 | Census ACS 2019–2023 |
| County | Galveston County | Census Bureau |
| Federal minimum for a new split central AC | 14.3 SEER2 under 45,000 Btu/h (Southeast) | DOE, 2023 standard |
Before you try the store-bought fix
A fresh filter is the one store-bought thing that genuinely does something, and it is worth being exact about what it reaches. A loaded filter chokes the air moving across the heat exchanger until the limit switch opens on temperature, and from the hallway that looks like a furnace that has died. A technician rules that out first as well, along with a flame sensor filmed over enough to make the burners light, drop out a few seconds later, try again, and lock out on the third attempt. A furnace that has been through both and still stops is not a parts question any more.
When to stop and call in Kemah
- A technician has said the words heat exchanger, or a carbon monoxide alarm has gone off.
- Flame rolls out of the burner opening, or there is soot around the furnace door.
- The part it needs is on back order and the furnace was installed before 2010.
- The license
- Held by the contractor, not by this site, and issued where the work happens — Texas licenses at state level, at city level or not at all depending on the trade and the town. Ask for the number and the name it is held under: a trading name and the licensed entity are often not the same.
- The call
- Describing what the system is doing commits you to nothing. Nothing is booked until you say so.
- Coverage
- By town, not by region. Kemah and the towns around it, and it shifts with who is taking calls at the hour you ring.
What a visit in Kemah involves
- 01
The diagnosis
At the thermostat first, then at the furnace or the condenser, in the order the equipment runs. What the system is doing is established before any part is named.
- 02
The repair
Agreed with the contractor before it starts. Where a part has to be ordered, a technician says so rather than leaving the system apart.
- 03
What happens after
A system that failed once in a season often fails again in it. Whether that is the same fault or a second one is worth asking while the technician is still there.
What to have ready when you call from Kemah
- 01When the furnace went in, roughly, and its model number — the data plate inside the door carries both.
- 02Whether the gas utility has been out, and what the tag says word for word — the tag usually names the component.
- 03Whether the same ductwork also cools the house, and what the outdoor data plate lists as the refrigerant — R-410A, R-454B or R-22 — and the model number on that unit, which tells a contractor whether it only cools or heats as well.
The data plate inside the furnace door answers half the call, so have it in front of you — the year it went in and the model number. And if the gas utility left a tag on the appliance, leave the tag where it is: it names what has to be put right before the gas comes back.
Furnace Replacement in Kemah: questions
How cold does Kemah get in winter?
Kemah averages 9 days a year with a low of 32°F or colder and almost none at 20°F or colder, by the 1991–2020 climate normals for a NOAA station 5 miles away. Heating is rarely asked for here, so a fault in it can sit unnoticed until the one cold week of the year.
How old are the homes in Kemah?
Half the homes in Kemah were built in 1995 or later, by the Census Bureau's 2019–2023 American Community Survey. Detached houses make up most of the housing. Equipment in houses of that age is often on its second set, and the install date on the label decides whether parts are still made.
Is there still a federal tax credit for a new furnace?
No: under the tax law signed on July 4, 2025, the 25C credit does not apply to equipment installed after December 31, 2025. A quote that subtracts it is out of date, and any utility or state rebate is a separate program to ask the utility about.
Other services in Kemah
Furnace Replacement nearby