HeatCoolHQ heatcoolhq.com (888) 217-3739

Irving, TX

Furnace Replacement and Installation in Irving, TX

Replacing a furnace in Irving, TX starts with sizing the new one to the house rather than copying the label on the old one. Irving averages 29 days a year with a low of 32°F or colder and 3 at 20°F or colder (NOAA 1991–2020 normals, station 4 miles away). Half the homes in Irving were built before 1986 (Census ACS 2019–2023). A new non-weatherized gas furnace has to reach an AFUE of at least 80, the federal minimum; DOE has set 95 for furnaces made after December 18, 2028, a rule still being fought in court.

(888) 217-3739

Texas contractors. No obligation for the call.

The year in Irving—cooling runs nearly all year
The year in Irving. cooling runs nearly all year. There is no month when both systems are idle. JFMAMJJASOND
heatingcooling29 days below freezing · July dew point 68°F
Two technicians easing a furnace cabinet down a basement stairway
A replacement cabinet coming off the dolly. How the unit gets in is part of the job: a turn in the stairs or a narrow doorway can decide which model fits.

A furnace that has failed once and a furnace on its second service call this season are two different questions. Say roughly when it was installed and what it is doing, and a heating contractor can come out to Irving and answer that before anything is ordered.

A furnace in Irving works a few weeks of the year, and some years barely that. That takes the calendar out of the decision: a changeout takes about one day, and a day without heat here is an inconvenience rather than a risk. Here the appliance sets the timing, rather than the timing setting the appliance.

The indoor cabinet is not the same thing from one house to the next here: a small gas furnace in a closet or out in the garage in one, an air handler with electric resistance strips behind a heat pump in the next. The model number on the data plate settles which, and it settles what the visit is — a furnace changeout and an air handler changeout are not the same piece of work.

The cooling coil sits directly on top of the furnace in an upflow cabinet, and in a summer like this it runs wet for months at a time. Everything it takes out of the air leaves through one drain line, and when that line blocks the water has one place to go: rust across the top of a heat exchanger is often a story about the cooling season rather than the heating one. It is worth saying on the call, because it changes what a contractor expects to find when the cabinet comes open.

Irving, TX in numbers

Days a year with a low of 32°F or colder29NOAA 1991–2020 normals, station 4 miles away
Days a year with a low of 20°F or colder3NOAA 1991–2020 normals
Average July dew point68°FPRISM 1991–2020 normals
Median year homes were built1986Census ACS 2019–2023
Households94,252Census ACS 2019–2023
CountyDallas CountyCensus Bureau
Federal minimum for a new split central AC14.3 SEER2 under 45,000 Btu/h (Southeast)DOE, 2023 standard

What the store-bought fix actually does

A fresh filter is the one store-bought thing that genuinely does something, and it is worth being exact about what it reaches. A loaded filter chokes the air moving across the heat exchanger until the limit switch opens on temperature, and from the hallway that looks like a furnace that has died. Changing it is also the first thing a technician rules out, along with a flame sensor filmed over enough to make the burners light, drop out a few seconds later, try again, and lock out on the third attempt. A furnace that has had both done and still stops has stopped being a parts question.

A technician at an indoor air handler

When to stop and call in Irving

  • A technician has said the words heat exchanger, or a carbon monoxide alarm has gone off.
  • This is the second service call on the same furnace in one heating season.
  • The part it needs is on back order and the furnace was installed before 2010.
The license
Held by the contractor, not by this site, and issued where the work happens — Texas licenses at state level, at city level or not at all depending on the trade and the town. Ask for the number and the name it is held under: a trading name and the licensed entity are often not the same.
The figure
Set by the contractor and said before the work starts. This site never quotes and has no part in it. If a technician cannot say what the visit covers before beginning, that is the moment to stop.
Coverage
By town, not by region. Irving and the towns around it, and it shifts with who is taking calls at the hour you ring.

What happens on the visit

  1. 01

    The diagnosis

    At the thermostat first, then at the furnace or the condenser, in the order the equipment runs. What the system is doing is established before any part is named.

  2. 02

    The repair

    Agreed with the contractor before it starts. Where a part has to be ordered, a technician says so rather than leaving the system apart.

  3. 03

    What happens after

    A system that failed once in a season often fails again in it. Whether that is the same fault or a second one is worth asking while the technician is still there.

What to have ready when you call

  1. 01Roughly when the furnace was installed, and the model number — the data plate inside the door carries both.
  2. 02Whether the gas utility has already been there, and the wording on the tag — the tag usually names the component.
  3. 03Where the appliance stands and what it vents into — a metal flue into a chimney, or a white plastic pipe through the wall — and whether a water heater shares that chimney, because one left alone on a flue sized for two appliances becomes its own piece of work. Give the address and ZIP code as well.

The data plate inside the furnace door answers half the call, so have it in front of you — the year it went in and the model number. And if the gas utility left a tag on the appliance, leave the tag where it is: it names what has to be put right before the gas comes back.

Furnace Replacement in Irving: questions

How many freezing days does Irving have?

Irving averages 29 days a year with a low of 32°F or colder and 3 at 20°F or colder, by the 1991–2020 climate normals for a NOAA station 4 miles away. Heating is rarely asked for here, so a fault in it can sit unnoticed until the one cold week of the year.

How old are the homes in Irving?

Half the homes in Irving were built before 1986, by the Census Bureau's 2019–2023 American Community Survey. Detached houses make up a good share of the housing. Equipment in houses of that age is often on its second set, and the install date on the label decides whether parts are still made.

What efficiency does a new gas furnace in Irving need?

A new non-weatherized gas furnace has to reach an AFUE of at least 80 under the federal minimum. A 95 standard is set for furnaces made after December 18, 2028 and is still in court, so a furnace going in now can be an 80 or a condensing model in the 90s.

Map loads when you reach it

Other services in Irving

Furnace Replacement nearby

Call (888) 217-3739