HeatCoolHQ heatcoolhq.com (888) 217-3739

Howard, CO

Furnace Replacement and Installation in Howard, CO

A new furnace in Howard, CO is sized from the house, its ducts and its winters, not from the rating plate of the one coming out. Howard has, on average, 201 days a year with a low of 32°F or colder and 104 at 20°F or colder (NOAA 1991–2020 normals, station 13 miles away). Half the homes in Howard were built before 1977 (Census ACS 2019–2023). A gas furnace installed now must reach an AFUE of 80 or more under the federal minimum, while DOE's 95 rule for furnaces made after December 18, 2028 is still being litigated.

(888) 217-3739

Colorado contractors. No obligation for the call.

The year in Howard—heating runs most of the year
The year in Howard. heating runs most of the year. Between the two seasons there are weeks when neither system runs, which is when a fault goes unnoticed. BELOW FREEZINGBELOW FREEZINGnothing runsJFMAMJJASOND
heatingcoolingbelow freezing201 days below freezing · July dew point 44°F
Two technicians easing a furnace cabinet down a basement stairway
A replacement cabinet coming off the dolly. How the unit gets in is part of the job: a turn in the stairs or a narrow doorway can decide which model fits.

A furnace that has failed once and a furnace on its second service call this season are two different questions. Say when it went in, roughly, and what it is doing now, and a heating contractor can come out to Howard and answer that before anything is ordered.

The steel expands every time the burners light and contracts every time they stop, and a crack is where that ends. That is not a failed part: the heat exchanger is the body of the machine rather than something bolted to it, and getting at one means stripping the furnace back to its cabinet. At that point the decision has largely been made for you.

That is why the month matters more here than in most places. A changeout takes about one day, and for part of that day the house has no heat — an ordinary afternoon in September, a different proposition in January. A furnace that came through last winter on two repairs is a spring conversation, not a February one.

In this climate a furnace makes a dry house drier, and the older the appliance the more of it there is: a natural-draft furnace burns room air, and the house draws outside air in to replace it, and the outside air here is drier still. A sealed-combustion furnace brings its air in through its own pipe from outdoors and stops using the house as the supply. Dry air feels colder than the thermostat says, and the setting goes up to answer it, which puts hours on a furnace that has them counted already. A contractor plumbs a humidifier onto the ductwork at the same visit, if one is wanted, because the plenum is already open.

Howard, CO in numbers

Days a year with a low of 32°F or colder201NOAA 1991–2020 normals, station 13 miles away
Days a year with a low of 20°F or colder104NOAA 1991–2020 normals
Average July dew point44°FPRISM 1991–2020 normals
Median year homes were built1977Census ACS 2019–2023
Households542Census ACS 2019–2023
CountyFremont CountyCensus Bureau
Federal minimum for a new split central AC13.4 SEER2 (North region)DOE, 2023 standard

Before you try the store-bought fix

A fresh filter is the one store-bought thing that genuinely does something, and it is worth being exact about what it reaches. A loaded filter chokes the air moving across the heat exchanger until the limit switch opens on temperature, and from the hallway that looks like a furnace that has died. Changing it is also the first thing a technician rules out, along with a flame sensor filmed over enough to make the burners light, drop out a few seconds later, try again, and lock out on the third attempt. A furnace that has had both done and still stops has stopped being a parts question.

A technician at an indoor air handler

When to stop and call

  • A technician has said the words heat exchanger, or a carbon monoxide alarm has gone off.
  • Flame rolls out of the burner opening, or there is soot around the furnace door.
  • The part it needs is on back order and the furnace was installed before 2010.
The figure
Set by the contractor and said before the work starts. This site never quotes and has no part in it. If a technician cannot say what the visit covers before beginning, that is the moment to stop.
The call
Describing what the system is doing commits you to nothing. Nothing is booked until you say so.
Coverage
By town, not by region. Howard and the towns around it, and it shifts with who is taking calls at the hour you ring.

What happens on the visit

  1. 01

    The finding, out loud

    What failed, whether it is the fault or a symptom of another one, and whether the repair suits the age of the system. A diagnostic visit is usually charged separately from the repair — ask whether it is credited if the work goes ahead, because that differs from one contractor to the next.

  2. 02

    The repair

    Agreed with the contractor before it starts. Where a part has to be ordered, a technician says so rather than leaving the system apart.

  3. 03

    What happens after

    A system that failed once in a season often fails again in it. Whether that is the same fault or a second one is worth asking while the technician is still there.

What to have ready when you call from Howard

  1. 01When the furnace went in, roughly, and its model number — the data plate inside the door carries both.
  2. 02What the furnace is doing now — no heat at all, short cycling, a noise that started recently, or burners that light and drop out.
  3. 03Whether cooling runs through the same ductwork, and what the outdoor data plate gives as the refrigerant — R-410A, R-454B or R-22 — and the model number on that unit, which tells a contractor whether it only cools or heats as well.

Have the data plate from inside the furnace door in front of you, because it answers half the call — the year it went in and the model number. And if the gas utility left a tag on the appliance, leave the tag where it is: it names what has to be put right before the gas comes back.

Furnace Replacement in Howard: questions

How cold does Howard get in winter?

Howard averages 201 days a year with a low of 32°F or colder and 104 at 20°F or colder, by the 1991–2020 climate normals for a NOAA station 13 miles away. Heating is the main system here, and a furnace that quits in January is an emergency rather than an inconvenience.

How old are the homes in Howard?

Half the homes in Howard were built before 1977, by the Census Bureau's 2019–2023 American Community Survey. Detached houses make up almost all of the housing. Equipment in houses of that age is often on its second set, and the install date on the label decides whether parts are still made. Manufactured homes are common enough here that a packaged unit outside, feeding a duct under the floor, is worth mentioning on the call.

Is there still a federal tax credit for a new furnace?

No. The 25C energy efficient home improvement credit ended for equipment installed after December 31, 2025, under the tax law signed on July 4, 2025. A quote that subtracts it is out of date, and any utility or state rebate is a separate program to ask the utility about.

Map loads when you reach it

Other services in Howard

Furnace Replacement nearby

Call (888) 217-3739