Hempstead, TX
Heat Pump Repair and Replacement in Hempstead, TX
Heat pump repair in Hempstead, TX starts by telling a normal defrost cycle or auxiliary-heat run from one that is a fault. Hempstead averages 14 days a year with a low of 32°F or colder and about one at 20°F or colder (NOAA 1991–2020 normals, station 10 miles away). Half the homes in Hempstead were built before 1988 (Census ACS 2019–2023). A split heat pump made since January 1, 2023 must rate at least 14.3 SEER2 and 7.5 HSPF2, a federal floor that does not change from state to state.
(888) 217-3739Texas contractors. No obligation for the call.
A heat pump blowing air that feels cool in winter is usually working as designed, and a heat pump that sits on auxiliary heat for hours in mild weather usually is not. Say what the thermostat is showing and a heating and cooling contractor can come out to Hempstead and tell the two apart.
In Hempstead the cooling season is the year and the heating season is a handful of mornings. What a no-heat call means here depends on what else is in the house: where there is a furnace, the heat pump has something to hand the load to, and where there is none — and in this climate plenty of houses have none — the only thing behind it is a bank of electric resistance strips. That is the first thing a technician asks about, because there is no second appliance to switch to.
That makes the sizing question run the opposite way from a cold climate: the cooling load sets the size, exactly as it would for an air conditioner, because it is the load that exists for most of the year — which is correct, and it also means that on the handful of genuinely cold mornings the machine runs without stopping and the strips carry what it cannot. A machine running continuously on a cold morning is doing its job, not failing at it.
Sizing a heat pump means sizing for two jobs at once, and in a July this wet they pull against each other. Sized for the coldest night, it is oversized for the cooling season: it drops the temperature, shuts off, and never runs long enough to pull water out of the air, so the thermostat reads 74°F and the house still feels damp. That is where a single-stage machine runs out of options, and it is the argument for a compressor that modulates rather than one that is simply larger — long, slow run cycles are what dehumidify. Ask what the sizing was based on: a measurement of the house, with the heating load and the cooling load worked out separately.
Hempstead, TX in numbers
| Days a year with a low of 32°F or colder | 14 | NOAA 1991–2020 normals, station 10 miles away |
|---|---|---|
| Days a year with a low of 20°F or colder | 1 | NOAA 1991–2020 normals |
| Average July dew point | 72°F | PRISM 1991–2020 normals |
| Median year homes were built | 1988 | Census ACS 2019–2023 |
| Households | 1,909 | Census ACS 2019–2023 |
| County | Waller County | Census Bureau |
| Federal minimum for a new split central AC | 14.3 SEER2 under 45,000 Btu/h (Southeast) | DOE, 2023 standard |
What the store-bought fix actually does
A hard-start kit does what it says on the box, and that is the problem with it. It adds starting torque, and it will carry a compressor that has started to struggle through another season — it is a real part, fitted deliberately on some systems, and not a gimmick. What it does not do is explain why the compressor needed help: a weak run capacitor, worn windings, or a system running at pressures it should not be. A kit fitted and then forgotten hides that question until the compressor answers it.
Signs it is time to call
- The thermostat sits on auxiliary or emergency heat for hours while it is mild outside.
- It cools in summer but will not heat, or it heats but will not cool.
- The breaker feeding the outdoor unit or the air handler will not stay in.
- The license
- Held by the contractor, not by this site, and issued where the work happens — Texas licenses at state level, at city level or not at all depending on the trade and the town. Ask for the number and the name it is held under: a trading name and the licensed entity are often not the same.
- The call
- Describing what the system is doing commits you to nothing. Nothing is booked until you say so.
- Coverage
- By town, not by region. Hempstead and the towns around it, and it shifts with who is taking calls at the hour you ring.
What happens on the visit
- 01
The diagnosis
At the thermostat first, then at the furnace or the condenser, in the order the equipment runs. What the system is doing is established before any part is named.
- 02
The finding, out loud
What failed, whether it is the fault or a symptom of another one, and whether the repair suits the age of the system. A diagnostic visit is usually charged separately from the repair — ask whether it is credited if the work goes ahead, because that differs from one contractor to the next.
- 03
What happens after
A system that failed once in a season often fails again in it. Whether that is the same fault or a second one is worth asking while the technician is still there.
What to have ready when you call
- 01That the system is a heat pump, and what carries the heat when it cannot — electric, or a gas furnace on the same ducts, and not knowing is a fair answer.
- 02What the outdoor unit is doing: iced over, silent, running without stopping, or reversing every few minutes.
- 03The address and ZIP code, and how the outdoor unit is reached — a locked gate, a dog or deep snow changes the appointment.
Emergency heat is what that setting is for if the house has gone cold, but say on the phone that you switched to it, because it locks out the compressor, and the fault a technician needs to watch stops happening while it is on.
Heat Pumps in Hempstead: questions
How cold does Hempstead get in winter?
Hempstead averages 14 days a year with a low of 32°F or colder and 1 at 20°F or colder, by the 1991–2020 climate normals for a NOAA station 10 miles away. Heating is a handful of mornings here, so a heat pump spends nearly the whole year cooling.
How humid are summers in Hempstead?
The July dew point in Hempstead averages 72°F, by the PRISM 1991–2020 climate normals. In air that wet an oversized air conditioner cools the house fast, shuts off before it has dried the air, and leaves rooms cool and clammy, which is why sizing starts with a load calculation for the house.
Can a contractor in Hempstead still install an R-410A system?
Under federal rules, yes, if the equipment was made or imported before January 1, 2025: an EPA rule that took effect on July 27, 2026 removed the January 1, 2026 installation deadline for that stock. Equipment made since January 1, 2025 is charged with R-454B or R-32 instead, and an outdoor unit built for those is not a listed match for an indoor coil built for R-410A.
Other services in Hempstead
Heat Pumps nearby