HeatCoolHQ heatcoolhq.com (888) 217-3739

Graham, TX

Heat Pump Repair and Replacement in Graham, TX

Heat pump repair in Graham, TX starts by telling a normal defrost cycle or auxiliary-heat run from one that is a fault. Graham averages 74 days a year with a low of 32°F or colder and 13 at 20°F or colder (NOAA 1991–2020 normals, station in or next to town). Half the homes in Graham were built before 1970 (Census ACS 2019–2023). Every split heat pump made since January 1, 2023 has to rate at least 14.3 SEER2 for cooling and 7.5 HSPF2 for heating, the same federal minimum in every state.

(888) 217-3739

Texas contractors. No obligation for the call.

The year in Graham—cooling leads, heating gets weeks
The year in Graham. cooling leads, heating gets weeks. Between the two seasons there are weeks when neither system runs, which is when a fault goes unnoticed. nothing runsJFMAMJJASOND
heatingcooling74 days below freezing · July dew point 65°F
A technician checking the coil of an outdoor heat pump in winter
The top grille off, frost across the coil. A heat pump melts that off on a schedule of its own, which looks like a fault and is not.

Air that feels cool at the vents in winter is usually the heat pump working as designed, and a heat pump that sits on auxiliary heat for hours in mild weather usually is not. Say what the thermostat is showing and a heating and cooling contractor can come out to Graham and tell the two apart.

In Graham a heat pump spends most of its life as an air conditioner, and the heating side runs for a few weeks rather than a season. That shapes which faults get noticed, and when: anything wrong with cooling shows up in July with the whole house paying attention, while anything wrong with heating waits for the first cold week of the year to announce itself.

The part that pattern is hardest on is the reversing valve. It holds one position for most of the year and is then asked to move, and a valve that has sat that long sometimes does not move at all, or stops halfway. A machine that cooled all summer and then blows room-temperature air in the first cold week of December is describing that valve, or the solenoid on it, far more often than a dead compressor.

The frost on an outdoor coil comes out of the air, not off the ground, which is why the heaviest of it here arrives in weather nobody would call severe. A coil running below freezing takes moisture out of damp air faster than out of cold dry air, so a drizzly morning near 35°F puts more ice on it than a clear night at 15°F does — and a defrost cycle on a mild wet morning is the machine keeping up rather than falling behind. Ice that is still sitting there at the end of the day is the fault version, and it does not clear itself.

Graham, TX in numbers

Days a year with a low of 32°F or colder74NOAA 1991–2020 normals, station in or next to town
Days a year with a low of 20°F or colder13NOAA 1991–2020 normals
Average July dew point65°FPRISM 1991–2020 normals
Median year homes were built1970Census ACS 2019–2023
Households3,625Census ACS 2019–2023
CountyYoung CountyCensus Bureau
Federal minimum for a new split central AC14.3 SEER2 under 45,000 Btu/h (Southeast)DOE, 2023 standard

Why heat pumps in Graham do not fix themselves

What makes a heat pump different is that it can fail without ever going quiet. A system low on charge, or one with a defrost control that has quit, does not stop making heat — it falls behind, and the backup heat fills the gap without being asked. The thermostat still reads what it is set to, so the fault turns up on the electric bill rather than in the house. In cooling the same shortfall is easier to spot, because nothing covers for it — which is why a heat pump often gets diagnosed in summer for something it had been doing all through the heating season.

A technician at an indoor air handler

When to stop and call

  • Ice covers the outdoor coil and the defrost cycles are not clearing it.
  • It cools in summer but will not heat, or it heats but will not cool.
  • The breaker feeding the outdoor unit or the air handler will not stay in.
The license
Held by the contractor, not by this site, and issued where the work happens — Texas licenses at state level, at city level or not at all depending on the trade and the town. Ask for the number and the name it is held under: a trading name and the licensed entity are often not the same.
The figure
Set by the contractor and said before the work starts. This site never quotes and has no part in it. If a technician cannot say what the visit covers before beginning, that is the moment to stop.
Coverage
By town, not by region. Graham and the towns around it, and it shifts with who is taking calls at the hour you ring.

What happens on the visit

  1. 01

    The finding, out loud

    What failed, whether it is the fault or a symptom of another one, and whether the repair suits the age of the system. A diagnostic visit is usually charged separately from the repair — ask whether it is credited if the work goes ahead, because that differs from one contractor to the next.

  2. 02

    The repair

    Agreed with the contractor before it starts. Where a part has to be ordered, a technician says so rather than leaving the system apart.

  3. 03

    What happens after

    A system that failed once in a season often fails again in it. Whether that is the same fault or a second one is worth asking while the technician is still there.

What to have ready when you call

  1. 01That it is a heat pump, and what the backup is — electric, or a gas furnace on the same ducts, and not knowing is a fair answer.
  2. 02What the outdoor unit is doing: iced over, silent, running without stopping, or reversing every few minutes.
  3. 03The address and ZIP code, and whether the outdoor unit can be reached — a locked gate, a dog or deep snow changes the appointment.

Emergency heat is what that setting is for if the house has gone cold, but say on the phone that you switched to it, because it locks out the compressor, and the fault a technician needs to watch stops happening while it is on.

Heat Pumps in Graham: questions

How cold does Graham get in winter?

Graham averages 74 days a year with a low of 32°F or colder and 13 at 20°F or colder, by the 1991–2020 climate normals for the NOAA station in or next to town. Cooling sizes the equipment here, and the few cold mornings are when the backup heat comes on.

What is the July dew point in Graham?

The July dew point in Graham averages 65°F, by the PRISM 1991–2020 climate normals. In air that wet an oversized air conditioner cools the house fast, shuts off before it has dried the air, and leaves rooms cool and clammy, which is why sizing starts with a load calculation for the house.

Is a new R-410A system still allowed in Graham?

Under federal rules, yes, if the equipment was made or imported before January 1, 2025: an EPA rule that took effect on July 27, 2026 removed the January 1, 2026 installation deadline for that stock. Equipment made since January 1, 2025 is charged with R-454B or R-32 instead, and an outdoor unit built for those is not a listed match for an indoor coil built for R-410A.

Map loads when you reach it

Other services in Graham

Heat Pumps nearby

Call (888) 217-3739